ページ1に含まれる内容の要旨
GY-HD250/GY-HD251 HD CAMERA RECORDER
e_hd250_cover_7.fm Page 1 Tuesday, October 24, 2006 3:13 PM
E
INTRODUCTION
CONTROLS,
INDICATORS AND
CONNECTORS
PREPARATIONS
PREPARATIONS
FOR OPERATION
SETTING AND
ADJUSTMENTS
BEFORE SHOOTING
SHOOTING
OPERATION
HD CAMERA RECORDER
PLAYBACK MODE
USING EXTERNAL
INSTRUCTIONS
COMPONENTS
GY-HD250
MENU SCREENS
GY-HD251
FEATURES OF THE
CAMERA SECTION
OTHERS
* The illustration shows the GY-HD250/GY-
HD251 HD CAMERA RECORDER with the
Thank you for purchasing thi
ページ2に含まれる内容の要旨
e_hd250.book Page I Tuesday, October 24, 2006 3:11 PM Important Safeguards 1. Read all of these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accor- dance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radia- tors, heat resisters, stoves, or other apparatus (including amplifiers) that pr
ページ3に含まれる内容の要旨
e_hd250.book Page II Tuesday, October 24, 2006 3:11 PM INFORMATION (FOR CANADA) Safety Precautions RENSEIGNEMENT (POUR CANADA) This Class B digital apparatus complies with Canadian ICES- 003. Cet appareil numérique de la Classe B est conforme à la norme NMB-003 du Canada. FOR USA AND CANADA CAUTION WARNING: RISK OF ELECTRIC SHOCK TO REDUCE THE RISK OF FIRE OR ELEC- DO NOT OPEN TRIC SHOCK, DO NOT EXPOSE THIS CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, APPLIANCE TO RAIN OR MOISTURE. DO NOT R
ページ4に含まれる内容の要旨
e_hd250.book Page III Tuesday, October 24, 2006 3:11 PM WARNING: Safety Precautions (Cont’d) TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. This unit should be used with 12V DC only. CAUTION: FOR EUROPE To prevent electric shocks and fire hazards, do NOT use any other power source. This equipment is in conformity with the provisions and protection requirements of the corresponding European Directives. NOTE: This equipment is designed for profes
ページ5に含まれる内容の要旨
e_hd250.book Page IV Tuesday, October 24, 2006 3:11 PM Information for Users on Disposal of Old Equipment Attention: This symbol is only valid in the European Union. [European Union] This symbol indicates that the electrical and electronic equip- ment should not be disposed as general household waste at its end-of-life. Instead, the product should be handed over to the applicable collection point for the recycling of electrical and electronic equipment for proper treatment, recovery and re
ページ6に含まれる内容の要旨
e_hd250.book Page 2 Tuesday, October 24, 2006 3:11 PM Thank you for purchasing the JVC GY-HD250U/CHU and GY-HD251E/CHE HD CAMERA RECORDER. ACCESSORIES These instructions are for the GY-HD250U/CHU and GY- HD251E/CHE. • A lens is included with the GY-HD250U and GY-HD251E. • A lens is not included with the GY-HD250CHU and GY- HD251CHE. Information applicable only to the GY-HD250U/CHU is marked by “(U model only)”. Information applicable only to the GY-HD251E/CHE is marked by “(E model only)”. (
ページ7に含まれる内容の要旨
e_hd250.book Page 3 Tuesday, October 24, 2006 3:11 PM • Time code input/output terminal and slave lock function Slave lock to an external time code generator connected MAIN FEATURES to the time code input terminal. The time code output terminal outputs built-in time code generator data. • Built-in large 3.5" color LCD display In addition to displaying the camera image and the play- • GY-HD250/GY-HD251 records in HDV format or DV format. back image, the LCD monitor shows the status screens, DV
ページ8に含まれる内容の要旨
e_hd250.book Page 4 Tuesday, October 24, 2006 3:11 PM Charging the Built-in Battery . . . . . . . . . . . . . . . . . . . . .36 Battery Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .37 CONTENTS Attaching the Battery. . . . . . . . . . . . . . . . . . . . . . . . . . .37 Removing the Battery . . . . . . . . . . . . . . . . . . . . . . . . . .37 Precautions for the Battery Operation. . . . . . . . . . . . . .38 Remaining Battery Power Display . . . . . . . . . . . . .
ページ9に含まれる内容の要旨
e_hd250.book Page 5 Tuesday, October 24, 2006 3:11 PM Adjusting Audio during Recording . . . . . . . . . . . . . . . .56 OTHERS[1/2] Menu Screen . . . . . . . . . . . . . . . . . . . . . . .96 Monitoring Audio during Recording . . . . . . . . . . . . . . .57 OTHERS[2/2] Menu Screen . . . . . . . . . . . . . . . . . . . . . . .97 GENLOCK Menu Screen . . . . . . . . . . . . . . . . . . . . . . . . . .99 FILE MANAGE Menu Screen . . . . . . . . . . . . . . . . . . . . .100 SHOOTING OPERATION D
ページ10に含まれる内容の要旨
e_hd250.book Page 6 Tuesday, October 24, 2006 3:11 PM INTRODUCTION • Do not insert an object other than a videocassette in the cassette insertion slot. Be sure to close the cassette cover Precautions for Proper when this device is not to be used for a long period. • Do not set the POWER switch to OFF or remove the Use power cable during recording or playback. Otherwise the tape may be damaged. • The sensitivity level of the provided microphone is set • Supply voltage lower than the reference
ページ11に含まれる内容の要旨
e_hd250.book Page 7 Tuesday, October 24, 2006 3:11 PM • The maintenance contents vary depending on the operat- ing environment and method. Therefore, the data in the Routine and Periodical chart should be considered as a reference. Time management Maintenance The accumulated running time of this device can be con- firmed with the hour meter display (which shows the accu- mulated drum and fan motor running time). X See “How to The GY-HD250/GY-HD251 incorporates precision mechani- Display the
ページ12に含まれる内容の要旨
e_hd250.book Page 8 Tuesday, October 24, 2006 3:11 PM INTRODUCTION Battery Pack to be Used For recording and storing videotapes in the best con- dition The GY-HD250/GY-HD251 can use any of the following bat- teries. (Factory setting) U model: Anton Bauer battery Observe the following instructions for the best recording and E model: IDX battery storage of videotapes. • Take care of the conditions of handling videotapes. It is Recommended batteries recommended that you record and store videota
ページ13に含まれる内容の要旨
e_hd250.book Page 9 Tuesday, October 24, 2006 3:11 PM eocassette, place this device in a tightly sealed vinyl bag, and then move it to a new environment. Condensation To ensure no condensation occurs, allow the temperature of this device in the bag to reach that of the new environ- ment before using it. • If this device has been cooled down in a cold place and is then carried to a warm place, the moisture contained in Characteristic CCD Phe- the warm air may adhere to the head drum or tape gu
ページ14に含まれる内容の要旨
e_hd250.book Page 10 Tuesday, October 24, 2006 3:11 PM CONTROLS, INDICATORS AND CONNECTORS 6ZOOM servo control lever To operate the servo zoom feature with this lever, set the ZOOM Lens ZOOM knob b to “S”. • Pressing the “W” section of this lever increases the angle of the lens for a wider shooting angle. • Pressing the “T” section of this lever narrows the lens angle perspective for telephoto shots. The zoom lens is not provided with the GY-HD250CHU or • Pushing harder changes the speed of t
ページ15に含まれる内容の要旨
e_hd250.book Page 11 Tuesday, October 24, 2006 3:11 PM 6[ZEBRA] Zebra switch When this switch is ON, a zebra pattern is imposed on the Front Section viewfinder or LCD areas having luminance levels in accor- dance with the menu settings made for the video signal. This pattern can be used as a reference for manual adjust- ment of the lens iris. Zebra patterns are also displayed during color bar display when this switch is set to ON. • The default value is 70% - 80%. The luminance level 32 1 can
ページ16に含まれる内容の要旨
e_hd250.book Page 12 Tuesday, October 24, 2006 3:11 PM CONTROLS, INDICATORS AND CONNECTORS Connecting the Earphone Cable To reduce the emission of unwanted radio waves, be sure to Rear Section attach the provided clamp filter as shown in the figure below. • Attach the clamp filter as close to this device as possible, as shown in the figure. 1 Earphone cable 2 Clamp filter 3 3Shoulder belt hooks Allows you to attach a separately sold shoulder belt. 4LCD monitor 4 Shows a color camera image
ページ17に含まれる内容の要旨
e_hd250.book Page 13 Tuesday, October 24, 2006 3:11 PM 4[TC GENE.] Time code generator setting switch Switch for setting the time code generator to preset mode LCD Door or regeneration mode. It is also used to select the time code run mode when the preset mode is selected. FREE : The preset mode is selected, and the time code run mode becomes the FREE run mode. Set to this position to record with the time code or user’s bits set anew (preset). In this setting, the time code always operates in
ページ18に含まれる内容の要旨
e_hd250.book Page 14 Tuesday, October 24, 2006 3:11 PM CONTROLS, INDICATORS AND CONNECTORS 7Clamp Attach the cable from the viewfinder here. Right Side Section 8[USER1/2/3] User buttons You can assign camera functions to the USER1 - 3 but- tons. Use them to switch shooting conditions depending upon the subject. 2 1 Set them using the USER1 - 3 items in the SWITCH MODE menu screen. X See page 86. Use this button to preset the time code. X See page 46. 5 4 3 6 7 h i MEMO VF BRIGHT • The USER
ページ19に含まれる内容の要旨
e_hd250.book Page 15 Tuesday, October 24, 2006 3:11 PM a[STATUS] Status/Menu button d[POWER] Power ON/OFF switch • Pressing this button in the normal screen mode (condi- Switch that turns the power ON/OFF. tion in which the menu screen is not shown) displays a When the power is OFF, “POFF” is displayed in the LCD status screen in the viewfinder or on the LCD monitor. monitor or viewfinder. The displayed status screen changes each time the but- * Wait at least 5 seconds if you need to turn th
ページ20に含まれる内容の要旨
e_hd250.book Page 16 Tuesday, October 24, 2006 3:11 PM CONTROLS, INDICATORS AND CONNECTORS 4[INPUT1/INPUT2] INPUT1/INPUT2 audio input connec- tors Left Side Section These are audio input connectors for connecting to an external audio device or microphone. • Set the [AUDIO INPUT] switch 3 according to the device to be connected. • Set the CH-2 audio input connector using the [CH-2 98 7 INPUT] switch 2. The CH-2 audio from the set connector is recorded. 5Shoulder pad slide button 1 Button to
