Moen TUB AND SHOWER VALVES 2290の取扱説明書

ページ1に含まれる内容の要旨

MODELS 2290, 2291, 2600, 2700, 5401, 62600, 62700, 72615, 72700
MT620J
and MODEL SERIES T471, T473, T555, T666, T777 & T888

®
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
TUB AND SHOWER VALVES
Available with three or four port castings, with and without stops.
Connections are either 1/2 inch I.P.S. pipe or 1/2 inch copper sweat connections.
If the Moen Slip Fit spout is used, a 1/2 inch copper drop and lookout may be used.
Measurements
These are shown in the drawing

ページ2に含まれる内容の要旨

WITHOUT STOPS WITH STOPS 7" DIA 7" DIA (178mm) (178mm) SHOWER SHOWER SUPPLY SUPPLY SUPPLY SUPPLY RUBBER STOP VALVE (WITH SCREW DRIVER SLOT) TUB TUB 4-1/2" 2-1/8" CC 2" CC (114mm) (54MM) (51mm) PLASTER GROUND 3-3/4" IPS SIZE AND WALL 2-3/16" IPS (95MM) OPENING (56mm) 4-5/8" FOR C.C. (117mm) 6" FOR I.P.S. (152mm) Stop Operation CC - This type is integral with casting, actuated by screwdriver, and require a 90° turn to open or close. When the screwdrive

ページ3に含まれる内容の要旨

Disassembly Turn "OFF" both hot and cold water supplies, then open faucet to relieve pressure. Remove handle cover from handle knob. Take out handle screw and remove handle knob, washer, and stop tube. Lift out retainer clip. Rotate cartridge shell back and forth with Moen cartridge twist wrench, grasp the cartridge stem with pliers, and pull out the cartridge. ALWAYS KEEP POINTER UP NOTCHED FLAT RETAINER ON STEM CLIP WASHER STOP TUBE HANDLE HANDLE HANDLE SCREW COVER KNOB EAR VALVE BODY CART

ページ4に含まれる内容の要旨

(Continued from page 3) SCUTCHEON: Remove screw holding plaster ground in place. Discard plaster ground. Temporarily install handle knob or lever. Turn on water and check E system for leaks. If there are no leaks, turn OFF water and remove handle knob or lever. Install escutcheon plate with two screws provided Mount with the notch UP. Install stop tube. The notched flat on the cartridge stem must point UP when mounting the handle knob or lever. Mount handle knob or lever on the stem an