American Standard CADET 2568の取扱説明書

ページ1に含まれる内容の要旨

INSTALLATION INSTRUCTIONS
®
ANTIQUITY CADET 3 - 1.6 GPF ONE-PIECE TOILET, MODEL 2907
®
COMPACT CADET 3 - 1.6 GPF ONE-PIECE TOILET
®
COMPACT CADET 3 FloWise™ - 1.28 GPF ONE-PIECE TOILET
Model 2568 – Compact Elongated Right Height™ with Seat
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also

ページ2に含まれる内容の要旨

T H I S S I 5 6 INSTALL TOILET POSITION TOILET ON FLANGE a. Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. a. Unplug floor waste opening and install toilet on closet Alternately tighten nuts until toilet is firmly seated on floor. flange so bolts project through mounting holes. ! CAUTION: DO NOT OVERTIGHTEN NUTS b. Loosely install retainer washers and nuts. Side of OR BASE MAY BE DAMAGED! washers marked "T

ページ3に含まれる内容の要旨

9 10 ARM TOP REFILL NIPPLE ADJUSTMENTS TUBE a. Adjust water level. Water level TANK should be adjusted to level indicated LEVER CRITICAL LEVEL on tank by adjusting float cup. Fig. 9A MARK ("C.L.") MUST BE 1" ABOVE "S" OVERFLOW PIPE FLOAT CLIP See Step 10 for water level adjustment CUP method. b. If bowl fails to siphon, an adjustment FILL FLUSH may be required with the lift chain. VALVE VALVE Simply remove the bead chain from VALVE the retainment clip (see Fig. 9A)

ページ4に含まれる内容の要旨

TROUBLESHOOTING 12 IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 12. IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE, it is a signal you are wasting water because: LEVER LE • The end of the refill tube is inserted into overflow pipe, below BRAS EN water level in tank. Attach refill tube to overflow pipe using "S" PREMIER clip provided. • The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a new flapper)