ページ1に含まれる内容の要旨
Installation Instructions
Renaissance Wall Oven
Models:
EOR, MOR
Part No. 102579 Rev. G
ページ2に含まれる内容の要旨
® All specifications are subject to change without notice. Dacor assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved.
ページ3に含まれる内容の要旨
Table of Contents Before You Begin... ........................................................... 1 Installation Specifications ................................................ 6 Important Safety Instructions .......................................... 1 Installation Planning ......................................................... 6 Important Information About Safety Instructions .............. 1 Installation Instructions .................................................... 8 Safety Symbols and
ページ4に含まれる内容の要旨
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precau- tions, including the following: WARNING WARNING 1. Read the accompanying use and care manual 15. To prevent injury due to the unit from tipping for- before operating this appliance. ward, secure the oven to the cabinet using the sup- plied mounting screws. 2. Keep packaging materials away from children. Plastic sheet
ページ5に含まれる内容の要旨
Customer Service Information If You Need Help... Model Identification • If you have questions or problems with installation, con- tact your Dacor dealer or the Dacor Customer Service EORS227SCH Team. When you call, have the model and serial num- ber of the appliance ready. The model and serial num- ber are printed on the appliance data plate. A BC D E Dacor Customer Service t eam A MODEL: Phone: (800) 793-0093 E-mail: customerservice@Dacor.com EOR = Epicure Renaissance Web site:
ページ6に含まれる内容の要旨
Product Specifications Power Supply Requirements • It is the owner’s responsibility to ensure that a licensed Model Dedicated Circuit t otal Connected electrician performs the installation of the electrical sup- Number Requirements* Load ply for this appliance. The electrical installation, includ- EORS127 ing minimum supply wire size, must comply with the MORS127 National Electric Code ANSI/NFPA 70 (latest revision) 5.0 kW (21 Amp.) 240 Vac 60 Hz, and local codes and ordinances. EORS130 3
ページ7に含まれる内容の要旨
Design Specifications Product Dimensions All tolerances: +1/16 (1.6 mm). -0, unless otherwise stated. Top of Top of Chassis Chassis L L * * B B J F J F G G H H C D Light Cover C D A Conduit: 60” (152 cm) Long K Control Panel Front Top of E Chassis * Width at light A M Chassis Notch covers on both sides Light Covers Side View Conduit: Single Oven 60” (152 cm) K Long Control Panel Top of Front E Chassis M Chassis Notch 1” 1” Double Oven Side View (2.5 cm) (2.5 cm) 3 3/8” (8.6 cm) Epicure Mi
ページ8に含まれる内容の要旨
Installation Specifications • Dacor recommends installing the electrical junction box Installation Planning in the one of the locations shown. • Install the junction box in a location that allows the oven WARNING to be removed from the the cut out for service without being disconnected. Observe all governing codes and ordinances during plan- ning and installation. Contact your local building depart- • Plan the installation so that all minimum clearances are ment for further information.
ページ9に含まれる内容の要旨
Installation Specifications Cabinet Dimensions N N Recommended Recommended Electrical Electrical Location Location 1” (2.5 cm) min. to bottom of cabinet door 3/4” (1.9 cm) R R Support Platform P P 1” (2.5 cm) min. 1” (2.5 cm) min. to top of 3/4” (1.9 cm) to top of drawer face Support Platform cabinet door Alternate Electrical 31 1/4” (79.4 cm) Location Recommended 9 5/8” (24.4 cm) Recommended 4” Typical Toe Kick 4” Typical Toe Kick Single Wall Oven - Cut Out Dimensions Double Wall Oven - Cut
ページ10に含まれる内容の要旨
Installation Instructions Verify the Package Contents Verify that all the components below have been provided. If any item is missing or damaged, please contact your dealer immediately. Do not install a damaged or incomplete appliance. Make sure that you have everything necessary to ensure proper installation before proceeding. • Use and care manual • Exhaust grill with 2 mounting screws (2, #8 X 3/8”, color should match exhaust grill: Silver Dacor PN 83571, • Mounting screws (Wood, #6 X
ページ11に含まれる内容の要旨
Grab both sides of the door and pull out at a 30° angle to remove. Installation Instructions Removing the Oven Door on Model EORS136: 1. Open the door to its fully opened position. 3. Lift the oven door to about a 15° angle from the vertical position. 2. Rotate the catch over the retaining arm on each hinge. 4. Hold the door with both hands just below the handle and Catch pull it away from the oven while continuing to lift. Gripping point Retaining arm Gripping point Steps 1 and 2 Steps
ページ12に含まれる内容の要旨
Installation Instructions Electrical Connection - (continued) Connecting to a Four Wire Electrical Connecting to a Three Wire Electrical System System - Where Local Codes Permit 1. Separate the wires coming out of the appliance conduit. WARNING 2. Connect the white wire from the appliance conduit to the Do not connect the green appliance conduit wire to the white (neutral) supply wire in the junction box. neutral (white) junction box wire unless local building 3. Connect the black wire from
ページ13に含まれる内容の要旨
Installation Instructions Connecting to a Three Wire Electrical Insulating device 4 AWG wire System with External Ground - Where Local (minimum) Codes Permit WARNING • Do not ground the appliance to a gas supply pipe or hot water pipe. • If connecting the ground wire to a grounded cold water pipe, connect using a separate copper grounding wire (No. 10 minimum) and a clamp with an external Clamps grounding screw. The grounded cold water pipe must have metal continuity to electrical grou
ページ14に含まれる内容の要旨
Installation Instructions 3. Locate the mounting holes in the trim on both sides of Installing the Oven in the Cabinet the oven. There are four (4) holes, two (2) on each side, for single oven models and six (6) holes for dou- ble oven models. WARNING 4. Use a 1/16” drill bit to drill pilot holes in the cabinet • Failure to properly install the mounting screws may through all of the trim mounting holes. result in movement or tipping of the oven during use resulting in personal injury. 5.
ページ15に含まれる内容の要旨
Installation Instructions Installing the Exhaust Grill Reinstalling the Oven Doors With the oven secured to the cabinet, install the exhaust WARNING grill by mounting it to the oven with the two (2) provided screws. Failure to fully rotate the hinge catches will result in a safety hazard and may cause personal injury due to the door falling off its hinges. Also damage to the oven and/or improper door alignment may occur. CAUtION On double ovens, install the top door first to reduce the c
ページ16に含まれる内容の要旨
Installation Instructions Reinstalling the Oven Door (Cont) Verifying Proper Operation t o re-install the oven door on model EORS136: 1. For stainless steel ovens, peel off the protective layer of plastic that covers the stainless steel surfaces. WARNING 2. Remove any packaging from inside the oven(s). t o avoid personal injury or damage to the door from 3. Slide the oven racks onto the supports inside the oven it falling off its hinges: chamber(s) according to the use and care manual. • Ma
ページ17に含まれる内容の要旨
Installation Instructions Installation Checklist WARNING To ensure proper installation, the installer must complete the checklist below to make sure that no part of the in- stallation has been overlooked. □ Is the oven mount on a level platform? □ Is the oven wired and grounded according to these instructions and in accordance with all applicable elec- trical codes? (See Pages 4 and 9-11.) □ Is the oven secured into the cabinet with all the mount- ing screws [four (4) on single oven models,
ページ18に含まれる内容の要旨
Notes 16
ページ19に含まれる内容の要旨
ページ20に含まれる内容の要旨
Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com
