ページ1に含まれる内容の要旨
®
Netopia 3346-ENT/3356-ENT ADSL Router
Getting Started Guide
A Al ll l M Mo od de el ls s
A Al ll l M Mo od de el ls s
ページ2に含まれる内容の要旨
Copyright ©2003 Netopia, Inc., v.041905 All rights reserved. Printed in the U.S.A. Copyright 2005, Netopia, Inc. Netopia and the Netopia logo are registered trademarks belonging to Netopia, Inc., registered U.S. Patent and Trademark Office. Broadband Without Boundaries is a trademark belonging to Netopia, Inc. All other trademarks are the property of their respective owners. All rights reserved. Netopia, Inc. 6001 Shellmound Street, 4th Floor Emeryville, CA 94608 U.S.A. Part Number Netop
ページ3に含まれる内容の要旨
C C C Co o o on n n nt t t te e e en n n nt t t ts s s s Contents 3 Chapter 1 — Introduction..........................................................1-5 Overview....................................................................... 1-5 Features and Capabilities............................................... 1-5 How to Use this Guide.................................................... 1-6 Chapter 2 — Making the Physical Connections..........................2-1 Find a Location.
ページ4に含まれる内容の要旨
4 Getting Started Guide 4. Easy Setup Security Configuration ..................... 6-8 Appendix A — Technical Specifications and Safety Information ..A-1 Description.................................................................... A-1 Power requirements ............................................. A-1 Environment ........................................................ A-1 Software and protocols......................................... A-1 Agency approvals.................................
ページ5に含まれる内容の要旨
Introduction 1-5 C C C Ch h h ha a a ap p p pt t t te e e er r r r 1 1 1 1 II I In n n nt t t tr r r ro o o od d d du u u uc c c ct t t t ii iio o o on n n n Overview The Netopia 4-port ADSL Router (3346-ENT/3356-ENT, DE, EU models) is a full-featured, stand-alone DSL router for connecting diverse local area networks (LANs) to the Internet and other remote networks. The Netopia 4-port ADSL Router uses a high performance ADSL line to provide yo
ページ6に含まれる内容の要旨
1-6 Getting Started Guide • NAT/NAPT, Multi-NAT, and DHCP (client, server, and relay) for security and convenience • DNS proxy • IP Multicast Forwarding, IGMP V1, V2 • RIP1 and RIP2, static routes • IP QoS: TOS bit prioritization • VPN Pass-through for PPTP and IPSec • Built-in VPN gateway features offer support for up to 15 PPTP or IPSec VPN tunnels • IPSec implementation supports DES or 3DES encryption, MD5 or SHA1 encapsulation, and manual or IKE
ページ7に含まれる内容の要旨
Making the Physical Connections 2-1 C C C Ch h h ha a a ap p p pt t t te e e er r r r 2 2 2 2 M M M Ma a a ak k k ki ii in n n ng g g g t t t th h h he e e e P P P Ph h h hy y y ys s s s ii iic c c ca a a a ll ll C C C Co o o on n n nn n n ne e e ec c c ct t t ti ii io o o on n n ns s s s This section tells you how to make the physical connections to your Netopia 4-port ADSL Router. This section covers the following topics: • “Find a Loca
ページ8に含まれる内容の要旨
2-2 Getting Started Guide You will need: • A Windows–based PC or a Macintosh computer with Ethernet connectivity for configuring the Netopia 4-port ADSL Router. This may be built-in Ethernet or an add-on card, with TCP/IP installed and configured. See “Sharing the Connection” on page 4-1. • A DSL wall outlet wired for a connection to a telephone carrier who supports Asymmetric Digital Subscriber Line (ADSL) connections. Important Safety Instructions POWER SUPPLY INSTALLATION Connect the
ページ9に含まれる内容の要旨
Making the Physical Connections 2-3 Identify the Connectors and Attach the Cables Identify the connectors and switches on the back panel and attach the necessary Netopia Router cables. Connect your computer, DSL line, and power source as shown. 10/100BT LAN DSL DC Power 4 3 LAN 2 1 Power Off / On Power Switch DSL 2 1 3 1. For a direct computer to router Ethernet connection, use the standard Ethernet cable included with your router. 2. Use the supplied DSL line cable to connect the router
ページ10に含まれる内容の要旨
2-4 Getting Started Guide Netopia 4-port back panel 4 3 LAN 2 1 Power Off / On DSL DSL port Power switch Power port Ethernet ports . Port Description DSL port An RJ-48 jack labeled DSL for your ADSL connection. Ethernet ports Four RJ-45 10/100Base-T Ethernet jacks. You can use one of these to configure the Netopia 4-port. You can either connect your computer directly to an Ethernet port using the supplied Category 5 Ethernet cable, or connect both your computer and the Netopia 4-port to
ページ11に含まれる内容の要旨
Making the Physical Connections 2-5 Netopia 4-port ADSL Router Status Lights The figure below represents the Netopia 4-port ADSL Router status light (LED) panel. Netopia 4-port ADSL Router status indicator lights LAN 1, 2, 3, 4: Power: Solid green when the power is on Solid green when Ethernet link is established Blinks green when traffic is sent or received over the Ethernet DSL Sync: Blinks green with no line attached or training, Solid green when trained with the DSL line LAN 1 LAN 2 LAN 3
ページ12に含まれる内容の要旨
2-6 Getting Started Guide
ページ13に含まれる内容の要旨
Connecting to Your Local Area Network 3-1 C C C Ch h h ha a a ap p p pt t t te e e er r r r 3 3 3 3 C C C Co o o on n n nn n n ne e e ec c c ct t t t ii iin n n ng g g g t t t to o o o Y Y Y Yo o o ou u u ur r r r L L L Lo o o oc c c ca a a a ll ll A A A Ar r r re e e ea a a a N N N Ne e e et t t tw w w wo o o or r r rk k k k This chapter describes how to physically connect the Netopia 4-port ADSL Router to your local area network (LAN). Before you proceed, make sure the Net
ページ14に含まれる内容の要旨
3-2 Getting Started Guide Ethernet: Ethernet hardware and software drivers enable your PC or Macintosh computer to communicate on the LAN. Once the Netopia 4-port ADSL Router is properly configured and connected to your LAN, PC and Macintosh computers that have their required components in place will be able to connect to the Internet or other remote IP networks. Connecting to an Ethernet Network You can connect a standard 10/100Base-T Ethernet network to the Netopia 4-port ADSL Router using
ページ15に含まれる内容の要旨
Sharing the Connection 4-1 C C C Ch h h ha a a ap p p pt t t te e e er r r r 4 4 4 4 S S S Sh h h ha a a ar r r r ii iin n n ng g g g t t t th h h he e e e C C C Co o o on n n nn n n ne e e ec c c ct t t t ii iio o o on n n n Once you have set up your physical local area network, you will need to configure the TCP/IP stack on each client workstation connected to your Netopia 4-port ADSL Router. This chapter describes how to configure TCP/IP for both Windows-based and Macintosh compute
ページ16に含まれる内容の要旨
4-2 Getting Started Guide b. Some Windows Start menu -> Control Panel -> Network versions follow a path and Internet Connections -> Network like this: Connections -> Local Area Connection -> Properties -> Internet Protocol [TCP/IP] -> Properties Then go to Step 2. Step 2. Select Obtain an IP address automatically. Step 3. Select Obtain DNS server address automatically, if available. Step 4. Remove any previously configured Gateways, if available. Step 5. OK the settings. Restart if prompted
ページ17に含まれる内容の要旨
Sharing the Connection 4-3 Macintosh MacOS 8 or higher or Mac OS X Step 1. Access the TCP/IP Control Panel or Network Preference Pane. a. MacOS follows a Apple Menu -> Control Panels -> path like this: TCP/IP Control Panel b. Mac OS X follows a Apple Menu -> System path like this: Preferences -> Network Then go to Step 2. Step 2. Select Built-in Ethernet Step 3. Select Configure Using DHCP Step 4. Close and Save, if prompted. NOTE: You can use these instructions to configure other computers
ページ18に含まれる内容の要旨
4-4 Getting Started Guide
ページ19に含まれる内容の要旨
Telnet-Based Management 5-1 C C C Ch h h ha a a ap p p pt t t te e e er r r r 5 5 5 5 T T T Te e e e ll lln n n ne e e et t t t- - - -B B B Ba a a as s s se e e ed d d d M M M Ma a a an n n na a a ag g g ge e e em m m me e e en n n nt t t t Telnet-based management is a menu-driven interface for the capabilities built into the Netopia 4-port ADSL Router. Telnet-based management provides access to a wide variety of features that the router supports. You can customize these features for y
ページ20に含まれる内容の要旨
5-2 Getting Started Guide • The System Configuration menus display and permit changing: • IP Setup • Filter Sets • IP Address Serving • Network Address Translation (NAT) • Date and Time • SNMP (Simple Network Management Protocol) • Security • Upgrade Feature Set • Change Device to a Bridge • Logging • The Utilities & Diagnostics menus provide a selection of seven tools for monitoring and diagnosing the router's behavior, as well as for updating the firmware and rebooting the system. • The Stati
