ページ1に含まれる内容の要旨
Operator’s Reference
Dictionary of Configuring,
Operating, and
Reporting Features
HP AdvanceStack Routers
ページ2に含まれる内容の要旨
Hewlett-Packard Series 200, 400, and 600 Routers Operator’s Reference
ページ3に含まれる内容の要旨
© Copyright Hewlett- Product Numbers and Warranty Packard Company 1994. Software Version The information contained All rights reserved. This guide provides informa- in this document is subject This document contains pro- tion for Hewlett-Packard to change without notice prietary information, which routers running software is protected by copyright. with the following version HEWLETT-PACKARD No part of this document numbers: COMPANY MAKES NO may be photocopied, repro- A.08 series WARRANTY OF ANY
ページ4に含まれる内容の要旨
Operator’s Reference Preface Preface When To Use This Guide Part I of this guide provides an alphabetical listing of Configuration Editor parameters and their descriptions, grouped according to their corresponding entries in the Configuration Menu of the Configuration Editor. The Configuration Menu of the Configuration Guide Refer to Part I when you need information on a parameter in order to better understand how to use it in your router’s configuration. Part II of this guide provides detailed
ページ5に含まれる内容の要旨
Operator’s Reference Preface Refer to Part II when you need to learn the meanings of features in these areas. (To learn how to use statistics screens, NCL commands, the Event Log, and the MIB variables, refer to the User’s Guide.) Coverage Note This manual addresses the entire range of parameters and other soft- ware features found in Hewlett-Packard routers, including features that are not found on all router models. Thus, for some routers, such as the HP Router PR (J2540), certain features des
ページ6に含まれる内容の要旨
Operator’s Reference Preface Chapter 10, ‘‘Xerox Network System (XNS) Parameters’’ Chapter 11, ‘‘IPX Protocol Parameters’’ Chapter 12, ‘‘AppleTalk Parameters’’ Chapter 13, ‘‘X.25 Service Parameters’’ Chapter 14, ‘‘V.25 bis Network Mapping Parameters’’ Part II: General Operating Reference provides detailed reference information on the router’s statistics output, NCL command usage, event messages, and MIB variables. The individual chapters are: Chapter 15, ‘‘Statistics’’ Chapter 16, ‘‘Network Comm
ページ7に含まれる内容の要旨
Operator’s Reference Preface 6
ページ8に含まれる内容の要旨
Contents Operator’s Reference Preface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 When To Use This Guide . . . . . . . . . . . . . . . . . . . . . . . 3 Audience . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Organization . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Other HP Router Manuals . . . . . . . . . .
ページ9に含まれる内容の要旨
7 Internet Protocol (IP) Parameters Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-2 Parameters and Options . . . . . . . . . . . . . . . . . . . . . . . . . 7-6 8 DECnet Parameters Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-2 Parameters and Options . . . . . . . . . . . . . . . . . . . . . . . . . 8-4 9 SNMP Agent
ページ10に含まれる内容の要旨
Part II General Operating Reference 15 Using the Statistic Screens AppleTalk Router Statistics Screen . . . . . . . . . . . . . . . . . . . 15-4 Bridge Statistics Screen . . . . . . . . . . . . . . . . . . . . . . . . . 15-6 Buffers Usage Statistics Screen . . . . . . . . . . . . . . . . . . . . . 15-8 Circuit Statistics Screen . . . . . . . . . . . . . . . . . . . . . . . . . 15-10 DECnet Router Statistics S
ページ11に含まれる内容の要旨
dev: Device Event Messages . . . . . . . . . . . . . . . . . . . . . . 17-60 dls: Data Link Services Event Messages . . . . . . . . . . . . . . . . 17-69 drs: DECnet Event Messages . . . . . . . . . . . . . . . . . . . . . . 17-74 egp: Exterior Gateway Protocol Event Messages . . . . . . . . . . . 17-79 ip: IP Event Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . 17-86 ipx: IPX Router Eve
ページ12に含まれる内容の要旨
decnet: DECnet Configuration Information Base . . . . . . . . . . . 18-53 dls: Data Link Services Information Base . . . . . . . . . . . . . . . 18-55 drs: DECnet Circuit Group Information Base . . . . . . . . . . . . . 18-58 echo: Echo Service Information Base . . . . . . . . . . . . . . . . . 18-60 egp: EGP Information Base . . . . . . . . . . . . . . . . . . . . . . . 18-61 hw: Hardware Information Base . . . . . .
ページ13に含まれる内容の要旨
A Parameter Finder How To Use the Parameter Finder . . . . . . . . . . . . . . . . . . . A-2 1. System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-4 2. Software & 3. Lines . . . . . . . . . . . . . . . . . . . . . . . . . . A-5 4. Circuits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-6 5. Circuit Groups . . . . . . . . . . . .
ページ14に含まれる内容の要旨
Introduction: How To Use the Dictionary of Configuration Parameters Introduction
ページ15に含まれる内容の要旨
Operator’s Reference Part I is a dictionary reference of the Parameters found in the Configuration Editor, which is accessable from the Main menu (or by using the [/] [M] hot- key combination in Quick Configuration). Access to the Configuration Editor Accessing the Configuration Editor from the Main Menu 2
ページ16に含まれる内容の要旨
Operator’s Reference Part I is divided into fourteen chapters corresponding to the options listed in the Configuration menu: Figure 1-1. The Configuration Menu 3
ページ17に含まれる内容の要旨
Operator’s Reference To find a parameter description, turn to the chapter corresponding to the Configuration menu option containing that parameter. Then locate the pa- rameter by finding it in its alphabetic order. (You can also locate the parame- ter description by using the page/parameter listing at the beginning of each chapter.) Within each chapter, the parameters are listed alphabetically, with descrip- tions of their functions and associated options. For example, the following sample of
ページ18に含まれる内容の要旨
Operator’s Reference Example of Dictionary Entries in Operator’s Reference Specifies the link-level control. It always must remain set to LLC1, the default, for Quality of Service 802.3, 802.5, and PPP circuits. Parameter Name Default: LLC1 Default Setting for Quality of Service LLC1 Datagram service; best-effort delivery. LLC2 Reliable service, provides link-level control that includes error detection and error recovery by retransmission. Results in these additional parameters: Options for the
ページ19に含まれる内容の要旨
ページ20に含まれる内容の要旨
Part I Part I Dictionary of Configuration Parameters
