ページ1に含まれる内容の要旨
Tank GT25
B5381
Service Engineer’s Manual
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Table of Contents Chapter 1:Overview 1.1 About the Transport GT25 B5381 . . . . . . . . . . . . . . . . . . . . . . . . .1 1.2 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 1.3 Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 1.3.1 Opening the Box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 1.3.2 Box Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ4に含まれる内容の要旨
3.5 Replacing the Slim CD-ROM . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42 3.6 Replacing the LED Control Board . . . . . . . . . . . . . . . . . . . . . . . .44 3.7 Replacing the M1012 Adapter Board . . . . . . . . . . . . . . . . . . . . . .46 3.7.1 M1012 Adapter Board Features for B5381 . . . . . . . . . . . . 48 3.7.2 System Fan Layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .49 3.7.3 M1012 Adapter Board Connector Pin Definition . . . . . . .50 3.8 Replacing
ページ5に含まれる内容の要旨
PREFACE Copyright This publication, including all photographs, illustrations, and soft- ware, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any material contained herein, may be reproduced without written consent of the manufacturer-. Copyright 2006 Version 1.0 Disclaimer Information contained in this document is furnished by TYAN Com- puter Corporation and has been reviewed for accuracy and reliability prior to printing. TYAN assumes no l
ページ6に含まれる内容の要旨
Federal Communications Commission (FCC) Notice for the USA Compliance Information State- ment (Declaration of Conformity Procedure) DoC FCC Part 15: This device complies with part 15 of the FCC Rules Operation is subject to the following conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received including inter- ference that may cause undesired operation. If this equipment does cause harmful interference to radio or television
ページ7に含まれる内容の要旨
About this Manual This manual provides you with instructions on installing your Tank GT25. This manual is intended for experienced users and inte- grators with hardware knowledge of personal computers. This manual consists of the following parts: Chapter 1: Provides an introduction to the GT25 B5381 bare- bones, packing list, describes the external compo- nents, gives a table of key components, and pro- vides block diagrams of the system. Chapter 2: Covers procedures on installing the CPU, mem
ページ8に含まれる内容の要旨
SAFETY INFORMATION Before installing and using the Tank GT25, take note of the following precautions: – Read all instructions carefully. – Do not place the unit on an unstable surface, cart, or stand. – Do not block the slots and opening on the unit, which are pro- vided for ventilation. – Only use the power source indicated on the marking label. If you are not sure, contact the power company. – The unit uses a three-wire ground cable, which is equipped with a third pin to ground the unit
ページ9に含まれる内容の要旨
Chapter 1: Overview 1.1 About the Tank GT25 B5381 TM Congratulations on your purchase of the TYAN Tank GT25 B5381, a highly-optimized rack-mountable barebone system. ® The Tank GT25 B5381 is designed to support dual Intel Dempsey and Woodcrest processors, providing a rich feature set and incredible performance. Leveraging advanced tech- ® nology from Intel , the Tank GT25 B5381 server system is capable of offering scalable 32 and 64-bit computing, high- bandwidth memory design, and a lightn
ページ10に含まれる内容の要旨
1.2 Features • (2) RJ-45 10/100/1000 ports Enclosure • (2) USB 2.0 ports • Industry 19” rack-mountable 1U • (1) 4-port SAS connector (SSF- chassis storage bay 8470) – (4) 3.5” HDD bays – (1) slim line DVD-ROM bay Front Panel Features – (1) slim line FDD bay •I/O • Dimensions: D 27.87 x W 17.17 x H – (2) USB 2.0 ports 1.71 inch (708x436x43.5mm) • LED indicators – Power LED Processor – (2) LAN LEDs • Two 771 sockets – HDD active LEDs ® • Supports up to two Intel Dempsey – System warning LED (106
ページ11に含まれる内容の要旨
Motherboard • TYAN S5381 system board • Customized 15”x16” (381x406mm BIOS • PHOENIX BIOS on 8Mbit LPC Flash ROM • Serial console redirect • Supports APM 1.2 and ACPI 2.0 • PnP, DMI 2.0, WfM 2.0 power man- agement Server Management • System fan speed control and moni- toring • Chassis intrusion alert • Supports Tyan Server Management (TSM) • TYAN SMDC, IPMI 2.0 compliant remote server management kit (optional) System Cooling • (7) 40*40*56mm 15000rpm heavy- duty fans • (2) passive CPU heat
ページ12に含まれる内容の要旨
1.3 Unpacking This section describes the Tank GT25 B5381 package con- tents and accessories. 1.3.1 Opening the Box Open the box carefully and ensure that all components are present and undamaged. The product should arrive pack- aged as illustrated below. Packaged accessories 4 Chapter 1: Overview
ページ13に含まれる内容の要旨
1.3.2 Box Contents Component Description Industry standard 1U chassis, (4) hot-swap HDD bays Tyan S5381 system board (pre-installed) 8x slim DVD-ROM drive (pre-installed) LED and USB control board (pre-installed) (A) EPS 1U 650W PSU model for single power (pre-installed) (B) EPS 1U 650W 1+1 PSU model for redundant power (C) Redundant PSU power board A B C (7) System fans (40 mm x 56 mm) Chapter 1: Overview 5
ページ14に含まれる内容の要旨
Component Description M1210 Adapter board M5002 Note: In the future, an FPC cable, as shown below, will be supplied instead of the M5002. 6 Chapter 1: Overview
ページ15に含まれる内容の要旨
1.3.3 Accessories If any items are missing or appear damaged, contact your retailer or browse to TYAN’s website for service: http://www.tyan.com. The Web site also provides information on other TYAN prod- ucts, plus FAQs, compatibility lists, BIOS settings, and more. 1 x Tyan Barebone Driver CD 2 x Heatsink Power Cables HDD Screws Left to right: Europe, US Barebone Manual Mounting Ears & Screws Riser Card Chapter 1: Overview 7
ページ16に含まれる内容の要旨
Rail Kit Mounting Bracket x 4 Screw Kit Sliding Rail x 2 Sliding Brackets Front L-Bracket x 2 Rear L-Bracket x 2 FDD Kit FDD Backplane Cable FDD Cable FDD Rails & Screws 8 Chapter 1: Overview
ページ17に含まれる内容の要旨
1.4 About the Product The following views show you the product. 1.4.1 Front View Reset switch Warning LED NMI switch HDD activity LED ID Switch Power LED ID LED DVD-ROM Drive Power switch USB ports 2 x LAN LEDs Hard Drive Bay x 4 1.4.2 Rear View Case A (Single Power) COM1 VGA Port Port USB Ports PCI-X Slot Power Supply Socket SAS B5381G25W4H (Optional) PS/2 PCI-E Key- Slot LAN Port (NIC2) board LAN Port (NIC1) Port Chapter 1: Overview 9
ページ18に含まれる内容の要旨
Case B (Redundant Power) COM1 VGA PCI-X USB Port Port Slot Power Supply Sockets Ports ID LED PS/2 Power Supply Fans PCI-E ID Switch Key- Slot board SAS B5381G25W4H (Optional) Port LAN Port (NIC2) LAN Port (NIC1) 1.4.3 LED Definitions Front Panel LED Color State Description Power Green ON Power ON OFF OFF Power OFF HDD Activity Amber Random Blink HDD access activity OFF OFF No disk activity LAN1/LAN2 Linkage Green ON Linked to LAN Green Blinking Accessing LAN OFF OFF No LAN link Warning Red
ページ19に含まれる内容の要旨
Rear I/O LED *Right or Left is viewed from the rear. LED Color State Description RJ45 NIC1 Linkage Green ON Linked to LAN (Left Side) Green Blinking Accessing LAN OFF OFF No LAN link RJ45 NIC1 Mode Yellow ON Gigabit mode (Right Side) Green ON 100M mode OFF OFF 10M mode RJ45 NIC2 Linkage Green ON Linked to LAN (Left Side) Green Blinking Accessing LAN OFF OFF No LAN link RJ45 NIC2 Mode Yellow ON Gigabit mode (Right Side) Green ON 100M mode OFF OFF 10M mode ID LE
ページ20に含まれる内容の要旨
1.4.4 Internal View Case A - Single Power 1 234 5 6 7 8 12 9 11 10 1. Power Supply 7. Fans 2. SAS Connector 8. M1210 Adapter Board 3. Link Bar 9. Four SATA / SAS HDD Bays 4. Fully Buffered DIMM Memory 10. LED Control Board Cable Slots 11. DVD-ROM Power Cable 5. Fully Buffered DIMM Memory 12. DVD-ROM Cable Slots 6. CPU Sockets 12 Chapter 1: Overview
