ページ1に含まれる内容の要旨
TL-WN751N/TL-WN751ND
150Mbps Wireless N PCI Adapter
Rev: 1.1.1
1910010749
ページ2に含まれる内容の要旨
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2013 TP-LINK TECHNOLOGIES CO.
ページ3に含まれる内容の要旨
FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarant
ページ4に含まれる内容の要旨
CE Mark Warning This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. This device has been designed to operate with the antennas listed below which have a maximum gain of 2 dBi. Antennas not included in this list or having a gain greater than 2 dBi are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. To reduce potential radio interferen
ページ5に含まれる内容の要旨
NCC Notice & BSMI Notice 注意！ 依據 低功率電波輻射性電機管理辦法 第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻 率、加大功率或變更原設計之特性或功能。 第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通行；經發現有干擾現象時，應立 即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信規定作業之無線電信。低功 率射頻電機需忍受合法通信或工業、科學以及醫療用電波輻射性電機設備之干擾。 安全諮詢及注意事項 請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。 清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。 注意防潮，請勿將水或其他液體潑灑到本產品上。 插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。 請勿將本產品置放於靠近熱源的地方。除非有正常的通風，否則不可放在密閉位置中。 請不要私自打開機殼，不要嘗試自行維修本產品，請由授權的專業人士進行此項工作。 Продукт сертифіковано
ページ6に含まれる内容の要旨
TP-LINK TECHNOLOGIES CO., LTD DECLARATION OF CONFORMITY For the following equipment: Product Description: 150Mbps Wireless N PCI Adapter Model No.: TL-WN751N/TL-WN751ND Trademark: TP-LINK We declare under our own responsibility that the above products satisfy all the technical regulations applicable to the product within the scope of Council Directives: Directives 1999/5/EC, Directives 2006/95/EC, Directives 1999/519/EC, Directives 2011/65/EU The above product is in conformity w
ページ7に含まれる内容の要旨
CONTENTS Chapter 1 Product Overview ................................................................................. 1 1.1 Package Contents................................................................................................... 1 1.2 Introduction ............................................................................................................. 1 1.3 Features...............................................................................................................
ページ8に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter Chapter 1 Product Overview 1.1 Package Contents Please verify that all the package contents below are available. One TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter Quick Installation Guide One resource CD for TL-WN751N/TL-WN751ND, including: • TP-LINK Wireless Configuration Utility (TWCU) and Drivers • User Guide • Other helpful information Make sure that the above items are contained in the package. If any of the above item
ページ9に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter With unmatched wireless performance, reception, and security protection, the TL-WN751ND is the best choice for easily adding or upgrading wireless connectivity to your desktop. 1.3 Features Complies with IEEE 802.11n, IEEE 802.11g, IEEE 802.11b standards Supports WPA/WPA2 data se curity, TKIP/AES encryption Supports high rate of up to 150Mbps fo r maximum throughput, supports automatically adjust to lower speeds due to distance or
ページ10に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter Chapter 2 Installation Please install the PCI adapter into your computer before installing the driver software from the resource CD. 2.1 Hardware Installation 1. Turn off your computer and unplug the power cord from the computer. 2. Open the case and locate an available PCI slot. Remove the metal slot cover on the back of the PC. Keep the screws. Turn to your computer manufacturer for instructions if needed. 3. Insert the PCI adapter
ページ11に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter 2. The InstallShield Wizard window will appear. Click Next to continue. Figure 2-2 3. Choose a setup type. It is recommended to select Install TP-LINK Wireless Configuration Utility and Driver. Selecting Install Driver Only will only install driver. Click Next to continue. Figure 2-3 4
ページ12に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter 4. Click Change to specify the destination location for the software or you can leave it default. Click Next in the screen below to continue. Figure 2-4 5. Click Install to continue the setup. Figure 2-5 5
ページ13に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter 6. The utility and drivers will install. This may take 1~2 minutes. Figure 2-6 7. After all the steps above, you will see the screen below. Click Finish to complete the setup. Figure 2-7 6
ページ14に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter 8. After installation, the utility configuration page will automatically pop up as shown in the following figure and the icon will appear in your system tray. To connect to a network, please refer to Chapter 3 Connect to a Wireless Network. Figure 2-8 7
ページ15に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter Chapter 3 Connect to a Wireless Network With both the hardware and software successfully installed into your computer, you can quickly connect to a wireless network using one of the following methods. Method One: To connect using TWCU TL-WN751ND uses the TP-LINK Wireless Configuration Utility as the management software. The utility provides you an easy interface to connect to a network and to change any settings related to the wirele
ページ16に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter SSID (Service Set Identifier) is the name of the wireless network. The adapter will automatically connect to your target network next time if you tick Connect automatically. Figure 3-2 3. If word None appears behind the SSID, this means the network to be connected is not security-enabled and you can connect to the network without entering a key. To prevent outside intrusion and safeguard your network, it is strongly recommended to set
ページ17に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter point, then click OK to continue. Or push the WPS button on your router if your router features the WPS function to quickly build a connection without having to enter a key. Figure 3-4 4. You have now successfully connected to your network. Click Close to enjoy the Internet. Figure 3-5 5. To view more information about the network currently connected, click Status in the tools section and the page will display information such as t
ページ18に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter Figure 3-6 3.2 To connect using WPS WPS (Wi-Fi Protected Setup) function allows you to add a new wireless device to an existing network quickly. If the wireless router supports Wi-Fi Protected Setup (WPS), you can establish a wireless connection between wireless card and router using either Push Button Configuration (PBC) method or PIN method. 3.2.1 PBC (Push Button Configuration) method 1. Press the WPS/RESET button for 2~3 secon
ページ19に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter Figure 3-7 3. The adapter will be connecting to the target network. Figure 3-8 12
ページ20に含まれる内容の要旨
TL-WN751N/TL-WN751ND 150Mbps Wireless N PCI Adapter 4. When the following window appears, you have successfully connected to the network. Figure 3-9 3.2.2 PIN method There are two ways to configure the WPS by PIN method: 1) Enter the PIN from your AP device. 2) Enter a PIN into your AP device. Following are detailed configuration procedures of each way. 3.2.2.1. Enter the PIN from your AP device 1. Open TWCU and click WPS tab. Select Enter the PIN of my access point or wireless r
