ページ1に含まれる内容の要旨
User’s Manual
RGB 190F
RGB 192
RGB 198
Extron Electronics, USA Extron Electronics, Europe Extron Electronics, Asia Extron Electronics, Japan
Analog Computer-Video Interface
1230 South Lewis Street Beeldschermweg 6C 135 Joo Seng Road, #04-01 Kyodo Building
Anaheim, CA 92805 3821 AH Amersfoort PM Industrial Building 16 Ichibancho
68-647-01 Rev. D
USA The Netherlands Singapore 368363 Chiyoda-ku, Tokyo 102-0082 Japan
05 06
714.491.1500 +31.33.453.4040 +65.6383.4400 +81.3.3511.7655
www.extron.c
ページ2に含まれる内容の要旨
Precautions Safety Instructions • English Warning FCC Class A Notice Power sources � This equipment should be operated only from the power source This symbol is intended to alert the user of important indicated on the product. This equipment is intended to be used with a main operating and maintenance (servicing) instructions power system with a grounded (neutral) conductor. The third (grounding) pin is Note: This equipment has been tested and found to comply with the limits for a in the litera
ページ3に含まれる内容の要旨
ページ4に含まれる内容の要旨
Table of Contents Chapter 1 • Introduction .......................................................... 1-1 RGB 190F, RGB 192, and 198 About this Manual ................................................................ 1-2 About the RGB 190F, RGB 192, and RGB 198 ........... 1-2 Features ...................................................................................... 1-3 Chapter 2 � Installation and Operation ......................... 2-1 Installation Overview.................................
ページ5に含まれる内容の要旨
� � � � Intr Introduction, cont’d oduction Each RGB interface has two or more model options: About this Manual Three RGB 190F models This manual contains information about the Extron RGB 190F, RGB 192, and RGB 198 universal interfaces, detailing how to • RGB 190FV for PC computers operate and configure them. The three interfaces are functionally identical, with the exception of the audio RGB 190FM for Macintosh computers capabilities of the RGB 192 and RGB 198. All interfaces are RGB 190FS for
ページ6に含まれる内容の要旨
Introduction, cont’d RGBHV, RGBS, or RGsB outputs — Select the output format RGB 190F, RGB 192, and 198 via cabling setup and front panel DIP switch. Serration pulse switch — This DIP switch-selectable feature adds or strips the serration pulses from the output signal to make it compatible with digital display devices. Use the serration pulse switch if flagging or bending occurs at the top of the video display. Chapter Two 2 Installation and Operation Installation Overview Mounting the Interfac
ページ7に含まれる内容の要旨
S E R R D DS P C O M P U TE R M O N I TO R H - S H I F T LS EO V G E L NM O. M AU OD NI.O AUDIO ON 1 2 3 4 5 6 RGB 192 C O M P U T E R M O N I TO R H- S H I F T SER SO RG DN DO S P M ON . L E V E L M. AU DIO AUDIO ON 1 2 3 4 5 6 RGB 192 Installation and Operation, cont’d Installation and Operation Installation Overview This is an overview of the installation process. You will find detailed installation and operation instructions in this chapter. Install and set up the RGB 190F, RGB 192, or RGB
ページ8に含まれる内容の要旨
S ER R D DS P C O M P U T E R M O NITO R H -S HIF T LS EO VG EL N O M O N . M. AU DIO AUDIO ON 1 2 3 4 5 6 R G B 1 9 2 RGB 198 UNIVERSAL INTERFACE S E R R D D S P AUDIO C U T R N T R H - H F T LS EO VG E L NM O. M AU OD NIO . ON 1 2 3 4 5 6 N U T U T U T V 50 V /6 O M P E M O I O S I I P O P 125 /60 Hz 5A 125 50 0 Hz 5A Installation and Operation, cont’d 6" Deep Rack Shelf 1/4 Rack Width Front False 3. Hold the interface with attached brackets against the Faceplate und
ページ9に含まれる内容の要旨
Installation and Operation, cont’d 6 DIP switches — This bank of DIP switches is used to configure 1 2 4 11 3 5 6 10 the interface. The switches control: � Level RGB 198 UNIVERSAL INTERFACE SERR DDSP COMPUTER MONITOR SOG NO MON. AUDIO H-SHIFT LEVEL M. AUDIO ON � SOG (sync on green) 1 2 3 4 5 6 INPUT OUTPUT 125V 50/60 Hz 5A 125V 50/60 Hz 5A � Serration pulses 100-240V 10.5-3.6A MAX OUTPUT ANAHEIM, CA RGB HV S �DDSP MADE IN USA AUDIO LISTED 1T23 L/MONO R I.T.E � Monitor or no mon
ページ10に含まれる内容の要旨
AA Installation and Operation, cont’d 4 — DDSP To verify the polarity before connection, check the no-load power supply output with a voltmeter. DDSP disables all sync processing. This feature may be necessary for digital display devices such as LCD, DLP 8 BNC output connectors — Connect a coaxial cable between the (digital light processor) and plasma displays. Use this display (projector or monitor) and these rear panel BNC option if the image is not displayed properly after other connectors.
ページ11に含まれる内容の要旨
� � � � � L/ R Mono L/ R Mono Installation and Operation, cont’d 4. For digital display devices (including LCD, DLP and Wiring the audio incorrectly can damage the audio CAUTION plasma devices), try turning the DDSP DIP switch output circuits. (switch 4) On (up) or Off (down) on the front panel. Connect the sleeve(s) to ground (GND). 5. To test the system setup and output, substitute a video test Connecting the sleeve(s) to a negative (-) terminal generator for the computer input. Unplug the in
ページ12に含まれる内容の要旨
Installation and Operation, cont’d RGB 190F, RGB 192, and 198 Appendix A A Reference Information Specifications Included Parts Optional Accessories Cables RGB 190F, RGB 192, and RGB 198 � Installation and Operation 2-12
ページ13に含まれる内容の要旨
Refer Refer ence Information, cont’d ence Information Input impedance .......................... 510 ohms Specifications Output impedance ...................... 75 ohms Max. propagation delay .............. 57 ns Video Max. rise/fall time ....................... 4 ns Gain ............................................... Unity (0.7 V), (0.8 V) 15% with 3 dB peaking Polarity .......................................... RGBHV input: positive or negative (follows input) Bandwidth ......................
ページ14に含まれる内容の要旨
Reference Information, cont’d External power supply (RGB 190F, RGB 192) Included Parts 100 VAC to 240 VAC, 50/60 Hz, external, Unless otherwise noted, these items are included in each order autoswitchable; to 12 VDC, 1 A, regulated, for an RGB 190F, RGB 192, or RGB 198: included Power input requirements (RGB 190F, RGB 192) Interface Part number 12 VDC, 0.35 A Temperature/humidity .............. Storage -40° to +158°F (-40° to +70°C) / RGB 190FV 60-486-61 10% to 90%, noncondensing VGA M 6’ MHR (
ページ15に含まれる内容の要旨
Reference Information, cont’d Cables Included items Part number BNC cable Part number Rubber feet BNC-5 Mini HR 3’ 26-260-15 IEC power cord BNC-5 Mini HR 6’ 26-260-01 Tweeker BNC-5 Mini HR 12’ 26-260-02 Universal 12VDC external power supply BNC-5 Mini HR 25’ 26-260-03 (RGB 190 and RGB 192 only) 70-055-01 BNC-5 Mini HR 50’ 26-260-04 Under-desk mounting kit instruction card 68-461-01 BNC-5 Mini HR 75’ 26-260-16 3.5 mm, 5-pole captive screw connector 10-319-10 BNC-5 Mini HR 100’ 26-260-05
ページ16に含まれる内容の要旨
Reference Information, cont’d RGB 190F, RGB 192, and RGB 198 � Reference Information A-8
