ページ1に含まれる内容の要旨
Gigabit Ethernet Adapter
For 4600 & 5600 Series IP Phones
16-601543
Issue 1
September 2006
For all IP Telephone documentation,
go to Http://www.avaya.com/support
Installation and Safety Instructions
ページ2に含まれる内容の要旨
IMPORTANT USER SAFETY INSTRUCTIONS The most careful attention has been devoted to quality standards in the manufacture of your new Gigabit Ethernet Adapter. Safety is a major factor in the design of every Avaya Product. But, safety is YOUR responsibility too. Please read carefully the helpful tips listed below. These suggestions will enable you to take full advantage of this product. Then, retain these tips for later use. WARNING: This product is NOT for residential use. It is for business syste
ページ3に含まれる内容の要旨
AT6 Copyright 2006, Avaya Inc. All Rights Reserved Notice Every effort was made to ensure that the information in this document was complete and accurate at the time of printing. However, information is subject to change. Warranty Avaya Inc. provides a limited warranty on this product. Refer to your sales agreement to establish the terms of the limited warranty. In addition, Avaya's standard warranty language as well as information regarding support for this product, while under warranty, is ava
ページ4に含まれる内容の要旨
Electrical Fast Transient IEC 61000-4-4 Surge Immunity IEC 61000-4-5 Conducted Immunity IEC 61000-4-6 Power Frequency H-Field Immunity IEC 61000-4-8 Voltage Dips & Variations Immunity IEC 61000-4-11 Federal Communications Commission Statement, Part 15: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that ma
ページ5に含まれる内容の要旨
Ethernet Adapter markings is a good first step in determining which agency approvals have been granted. For inquiries regarding specific certifications, contact your local or regional Avaya representative. To order copies of this and other documents: Call: Avaya Publications Center Voice 1.800.457.1235 or 1.207.866.6701 FAX 1.800.457.1764 or 1.207.626.7269 Write: Globalware Solutions 200 Ward Hill Avenue Haverhill, MA 01835 USA Attention: Avaya Account Management E-mail: totalware@gwsmail.com Fo
ページ6に含まれる内容の要旨
connect the optional power supply to the Gigabit Ethernet Adapter's power connector; if the power supply is already connected to the Gigabit Ethernet Adapter and the power indicator LED is still not illuminated, please contact your dealer of purchase to ask for help. In the final step, please build the connection between the IP phone, computer and the Gigabit Ethernet Adapter's computer download port (Using a CAT6 cable is recommended). After that, switch the IP Phone and computer on, and try th
ページ7に含まれる内容の要旨
Note: The use of PoE and local power simultaneously is not supported and will prevent the adapter from working properly, nor is it intended to serve as a fail-over option. The power cable must be removed from the Gigabit Ethernet Adapter to allow for use of PoE. Avaya Limited Warranty What is covered: Any defect in materials or workmanship. For how Long: One year. What will we do: If your Avaya product is defective in material and workmanship and is returned within one year of date it was purcha
ページ8に含まれる内容の要旨
Figure 2 Powering Option for 4602SW, 5602SW, 4602SW+, 5602SW+, 4610SW, 5610SW IP phones Note: These Telephone models are powered over network cabling from a central location using an IEEE 802.3af compliant switch or power supply as 1151C1/C2 Power Supply. The use of PoE and local power simultaneously is not supported and will prevent the adapter from working properly, nor is it intended to serve as a fail-over option. The power cable must be removed from the Gigabit adapter to allow for use of P
ページ9に含まれる内容の要旨
Figure 3 Powering Option for 4620, 4620SW, 5620SW, 4621SW, 5621SW, 4622SW, 4625SW IP Telephones Note: These Telephone models are powered over network cabling from a central location using an IEEE 802.3af compliant switch or power supply as 1151C1/C2 Power Supply. The use of PoE and local power simultaneously is not supported and will prevent the adapter from working properly, nor is it intended to serve as a fail-over option. The power cable must be removed from the Gigabit adapter to allow for
ページ10に含まれる内容の要旨
Figure 4 Powering Option for 4630SW IP Telephone with PoE Switch Note: This Telephone model is powered over network cabling from a central location using an IEEE 802.3af compliant switch or power supply as 1151C1/C2 Power Supply. The use of PoE and local power simultaneously is not supported and will prevent the adapter from working properly, nor is it intended to serve as a fail-over option. The power cable must be removed from the Gigabit adapter to allow for use of PoE. ---=optional Rep
ページ11に含まれる内容の要旨
Troubleshooting Q&A If your Gigabit Ethernet Adapter does not function properly, before you send it to the dealer requesting service, please follow the troubleshooting guide first, it could help you solve the problem. Q: The Power Indicator LED is not illuminated. A1: This means your Gigabit Ethernet Adapter is not correctly powered. If you didn't use an 1151 type AC adapter with this product, please make sure the Ethernet socket you connected to is PoE-capable. If you're not sure, please ask yo
