Hobie Wave Jibの取扱説明書

ページ1に含まれる内容の要旨

PAGE 1 of 2
#3899-9001 WAVE JIB KIT
2) With trampoline loosened, force hulls
1) Install bow spreader tangs on each
apart and place bow spreader in
bow under existing bridle wire tang as
position on pins installed on bows
shown. Pin faces towards center.
3) With swivel cleat mounted to
plate, install jib sheet jam
4) Install jib halyard
cleat plate under existing
block on pig tail
trampoline hook* as shown. This is
and place pigtail on
installed under center of three tramp
shroud shackle
hooks.

ページ2に含まれる内容の要旨

PAGE 2 of 2 #3899-9001 WAVE JIB KIT Club Wave Installation instructions Jib Cleat mounting plate Due to the different trampoline arrangement on the Club Wave, there are a few differences in the installation of the jib cleat mounting plate. The difference is that the trampoline is mounted in a track on the Club and the "tramp mounting hook" found on the standard Wave is not attached to the hull. The mounting plate will be installed behind/underneath the trampoline track. This will require loose