ページ1に含まれる内容の要旨
TOSHIBASYSTEM PRACTICES
INSTALLATION-INTRODUCTION
OIGITALKEYTELEPHONESYSTEMS
SECTION 100-816-201
MARCH 1993
INSTALLATION
Chapter One - Introduction Section 100-816-201
Chapter Two - Site Requirements Section 100-816-202
Chapter Three - System Configuration Section 100-816-203
Chapter Four - DK8 KSU and PCB Installation Section 100-816-204
Chapter Five - DK16 KSU and PCB Installation
Section 100-816-205
Chapter Six - Station Apparatus Installation Section 100-816-206
Peripheral Insta
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
TOSHIBASYSTEM PRACTICES INSTALLATION-INTRODUCTION DIGITALKEYTELEPHONESYSTEMS SECTION lOO-816-201 MARCH1993 INSTALLATION CHAPTER ONE INTRODUCTION
ページ4に含まれる内容の要旨
ページ5に含まれる内容の要旨
INSTALLATION-INTRODUCTION SECTION lOO-816-201 MARCH1993 TABLEOFCONTENTS PARAGRAPH SUBJECT PAGE 1 PURPOSE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-l 2 ORGANIZATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ6に含まれる内容の要旨
ページ7に含まれる内容の要旨
INSTALLATION-INTRODUCTION SECTION 100-816-201 MARCH 1993 telephones, standard telephones, direct station 1 PURPOSE selection consoles, add-on modules and data in- 1.00 The purpose of this section is to provide terface units. detailed step-by-step instructions for installing the 3.40 Fault Finding Procedures: Hardware trou- STRATA DK8 and STRATA DK16 systems. bleshooting and diagnostic information presented 1.01 This chapter provides an overview of the in flowchart form. entire inst
ページ8に含まれる内容の要旨
INSTALLATION-INTRODUCTION SECTION 100-816-201 MARCH 1993 There are two types of DSS consoles: the DDSS CODECs: Coder/Decoders-&emiconductors that allow the system to process analog-to-digital console and the HDSS console. The chief differ- ence between them is that the DDSS console and digital-to-analog conversions. can be connected to designated digital tele- phone circuits, while the HDSS console can DDCB: Digital Door Phone/Lock Control Unit-A only be connected to designated electr
ページ9に含まれる内容の要旨
INSTALLATION-INTRODUCTION SECTION lOO-816-201 MARCH 1993 IMDU: Remote Maintenance Modem Interface LED: Light Emitting Diode-Status indicators lo- Unit (STRATA DK16 only)-A subassembly cated on printed circuit boards, digital telephones, installed on a PIOU or PIOUS PCB in the op- and electronic telephones. tional DK16 Expansion Key Service Unit that allows the system to be connected with a remote LSI: Large Scale Integration-Related to circuit maintenance/administration terminal. de
ページ10に含まれる内容の要旨
INSTALLATION-INTRODUCTION SECTION 100-816-201 MARCH 1993 Stand-alone Data Interface Units (PDIU-DSs). support the same single-line devices as the The PDIU-DI is also used to provide personal KSTU and the PSTU. computer access to outside dial-up data ser- vices and/or bulletin boards. PFT: Power Failure Transfer Interface-Dedicated standard telephone interface located on the NOTE: motherboard in the DKSUBI 6 (STRATA DK16) or DKSU8 (STRATA DK8) to provide emergency The PDIU-DI and the P
ページ11に含まれる内容の要旨
INSTALLATION-INTRODUCTION SECTION 100-816-201 MARCH 1993 provide interface for eight standard telephones QSTU: Standard Telephone Interface Unit or optional hardware peripherals (voice mail (STRATA DK8 only)-Optional printed circuit devices, fax machine, Background Musicsource, board that can be installed in the KSU to provide two standard telephone circuits. etc). PSTU2: Standard Telephone interface Unit RAM: Random Access Memory-Refers to the (STRATA DK16 only)-Provides the same type
ページ12に含まれる内容の要旨
ページ13に含まれる内容の要旨
TOSHIBASYSTEM PRACTICES INSTALLATION-SITEREQUIREMENTS SECTION 100-816-202 OIGITALKEYTELEPHONE SYSTEMS MARCH1993 INSTALLATION CHAPTER TWO SITE REQUIREMENTS
ページ14に含まれる内容の要旨
ページ15に含まれる内容の要旨
INSTALLATION-SITE REQUIREMENTS SECTiON lOO-816-202 MARCH1993 TABLEOFCONTENTS SUBJECT PAGE PARAGRAPH 2-1 ............................................................................................................... 1 GENERAL ......................................................................... 2-1 INPUT POWER REQUIREMENTS 2 2-1 ....................................................................................... SITE CONSIDERATIONS 3 .......................................
ページ16に含まれる内容の要旨
ページ17に含まれる内容の要旨
INSTALLATION-SIJE REQUIREMENTS SECTION 100-816-202 MARCH 1993 1 GENERAL 2.02 An option Reserve Power Battery and Charger (HPFB) is available for use with the 1 .OO This chapter defines the installation site re- STRATA DK8 to serve as a power failure backup. quirements necessary to ensure a proper operat- For the STRATA DKl6, a reserve power source ing environment for the STRATA DK8 and DK16. (two customer-supplied 12-volt batteries) may be Also included are grounding requirements. co
ページ18に含まれる内容の要旨
INSTALLATION-SITE REQUIREMENTS SECTION 100-816-202 MARCH 1993 3.03 If reserve power is to be installed for the DK16 BASE AND EXPANSION STRATA DK16, the batteries will require a well- UNIT CLEARANCE ventilated location close (within nine feet) to the FRONT VIEW DKSUB16 (the optional Toshiba-supplied battery -4 2+----- 20” ------4 2”+- 2” cable is 9 feet in length). The STRATA DK8 reserve battery (HPFB) should be mounted di- rectly above the DKSU8 as shown in Figure 2-l. 3.10 Electri
ページ19に含まれる内容の要旨
INSTALLATION-SITE REQUIREMENTS SECTION lOO-816-202 MARCH1993 TABLE 2-A SUMMARY OF ELECTRICAL/ENVIRONMENTAL CHARACTERISTICS GENERAL Primary power Input AC 85 - 135VAC 50/60 Hz AC frequency DK8-46 watts maximum, DK16-75 watts maximum Power Environmental specifications Operating temperature 32 - 104°F (0 - 40°C) Operating humidity 20 - 80% relative humidity without condensation - 4 - 158°F (-20 - 70°C) Storage temperature Power supply DK16 DK8 -24VDC: (-26.3 - -27.8VDC) +24VDC: (
ページ20に含まれる内容の要旨
INSTALLATION-SITE REQUIREMENTS SECTION 100-816-202 MARCH 1993 If a reading of zero volts on one terminal, and 5) 4.20 Alternate or Additional Ground a reading of 100 - 120 VAC on the other terminal is obtained, remove both probes from 4.21 If the “third wire” AC ground can not practi- the outlet. cally be improved or if extreme motor noise or other disturbance causes system malfunction, or if local area lightning storms exist, a separate direct Set the meter to the “OHMS/Rxl”scale. Pl
