ページ1に含まれる内容の要旨
®
Telguard Digital Model TG-9
Digital Cellular Alarm Communicator
Installation and Operating Instructions
Important: Read Before Installing Model TG-9
The following tools are required for installation:
Screwdriver and appropriate mounting screws
Confirm the presence of all required parts:
• 1x TG-9 Cellular Alarm Communicator
• 1x Dipole Antenna
• 6x End-Of-Line resistors
Before going to the site:
• Fill out and submit the Telular TG-9 Digital Cellular Service A
ページ2に含まれる内容の要旨
Device Profile Options The Telguard TG-9 Profile is stored in the Telular Communications Center and defines how each unit operates. One profile may be used for multiple units. The profile is uploaded to the Telguard TG-9 when it is activated, there is no field programming needed. Trip and Restore Reporting The TG-9 is programmed to send trips on all zones (not restorals). The profile can be set so that restores are transmitted. Changes will affect all trip zones. • Profile Options
ページ3に含まれる内容の要旨
Installation Instructions WARNING! DO NOT MOUNT THE UNIT YET! This unit is a cellular communications device. THE ANTENNA MUST NOT BE INSTALLED IN THE BASEMENT! 1. Connect the power. Connect the Telguard TG-9 to the 12v DC power output from the alarm panel or to a 9-15v DC (250 mA minimum) power supply. Ensure that the LEDs come on. Important: The 2.5mm port on the side of the TG-9 is for programming and diagnostics only. It is not a power input and installer shall not insert any
ページ4に含まれる内容の要旨
56037002 - 4 - © 2007 Telular Corporation
ページ5に含まれる内容の要旨
LED Functions & Description LED 1: Signal Strength LED 2: Operating Mode Green Solid Good Signal Strength Green Registered and Enabled Green Flashing Acceptable Signal Strength Green flash Transmitting Signal Yellow Flashing Weak Signal Strength Yellow Awaiting Response Red No Signal Strength Red Not Registered or Enabled Red Flashing Failed Registration, NACK LED 3: System Status LED 3: STC LED Table Green All OK One Flash, Pause
ページ6に含まれる内容の要旨
System Specifications Digital Cellular Radio The Telguard TG-9 radio supports GSM/GPRS cellular protocol. It is equipped with an integrated radio transceiver conforming to all the requirements of the GSM Phase 2+ tests specified in GSM 11.10. The TG-9 transceiver is FCC compliant, meeting all of the requirements of Part 24 and SAR testing. It is also compliant to the PTCRB NAPRD03 requirements. • Frequency range: GSM 850/1900MHz, 1. 850: Tx = 824MHz-849MHz & Rx = 869MHz-8
