ページ1に含まれる内容の要旨
Mobile IP Roaming Gateway
MAP-2105
User’s Manual
1
ページ2に含まれる内容の要旨
Copyright Copyright (C) 2006 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed products of PLANET Technology, This User’s Manual contains proprietary information protected by copyright, and this User’s Manual and all accompanying hardware, software, and documentation are copyrighted. No part of this User’s Manual may be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable for
ページ3に含まれる内容の要旨
Trademarks The PLANET logo is a trademark of PLANET Technology. This documentation may refer to numerous hardware and software products by their trade names. In most, if not all cases, these designations are claimed as trademarks or registered trademarks by their respective companies. Revision User’s Manual for PLANET Mobile IP Roaming Gateway: Model: MAP-2105 Rev: 1.0 (July 2006) Part No.: EM-MAP2105 3
ページ4に含まれる内容の要旨
TABLE OF CONTENTS Chapter 1 Introduction .......................................................................................1 1.1 Features ......................................................................................................1 1.2 Package Contents .......................................................................................1 1.3 Network Planning ........................................................................................1 1.4 Hardware Installation
ページ5に含まれる内容の要旨
4.3.2 Status > System..................................................................................45 4.3.3 Status > MLRD ...................................................................................46 4.3.4 Config > System .................................................................................47 4.3.5 Config > Network > WAN....................................................................48 4.3.6 Config > Network > Route.................................................
ページ6に含まれる内容の要旨
Chapter 1 Introduction The MAP-2105 is a mobile IP roaming gateway which is specifically designed for PLANET wireless mesh network. It offers the full “mobility” to all users. Not like the layer-2 only capability in ordinary AP, the “mobility” defined in MAP-2105 is the ability of a user to change its attached node from one mesh AP to another while maintaining all existing communications and using the same IP address at this new link. Remote printing, remote login, VoIP sessions, and file t
ページ7に含まれる内容の要旨
The MAP-2105 should connect to the network that provide DHCP services (the first time installation) In this guide, we will base on XRT-401D (Internet Broadband Router) as the example for DHCP server, switch and router, this installation can vary on the network planning. The MAP-2105 should be installed in the same subnet to the Mesh Gateway for optimal performance. The MAP-2105 is optimized for 500-user registration; however, the overall network performance may vary on the real enviro
ページ8に含まれる内容の要旨
https://192.168.0.100. 6. The pop-up screen will ask for user name and password. By default, please key in “admin” for both name and password. Then bring up the screen. 7. Now, the MAP-2105 is ready for services. 3
ページ9に含まれる内容の要旨
Chapter 2 Basic Network Setup This chapter describes a basic network environment formed by three mesh AP and one MAP- 2105. The administrators can add the mesh AP freely according to real application. The sample network topology is as below. Ethernet Switch Mesh Gt Router MAP-2105 Mesh Relay DHCP Server Mesh Relay 802.11b/g Mobile User Step 1: Gateway Configuration: [Configuration -> Local Service -> VPN Server] Enable VPN Server = checked Add New User by pressing Add butto
ページ10に含まれる内容の要旨
[Configuration -> Local Service -> Mobile IP] Enable Transparent Mobile IP Service: checked Mobile IP Community Name: PLANET (it must be identical for all nodes in the same mesh network) Mobile Location Register Address: 10.16.1.7 (the IP address assigned in VPN Server screen) Step 2: Reboot the Gateway Step 3: Relay Configuration: [Configuration -> Local Service -> Mobile IP] Enable Transparent Mobile IP Service: checked 5
ページ11に含まれる内容の要旨
Mobile IP Community Name: PLANET (it must be identical for all nodes in the same mesh network) Mobile Location Register Address: 10.16.1.7 (the IP address assigned in Gateway VPN Server screen) Step 4: Reboot the Relay Step 5: MAP-2105 Configuration: [Configuration -> Local Service -> VPN Client] Enable PPTP Client: checked VPN Server: 192.168.0.99 (the Gateway WAN IP address) Remote Subnet: 10.0.0.0 (the subnet of Gateway’s Backhaul radio IP) Remote Netmask: 255.0.0.0 (the net mas
ページ12に含まれる内容の要旨
CN Info Two correspondent nodes connected with relevant info. Client Info Info of the mobile station recorded in the MAP-2105. 7
ページ13に含まれる内容の要旨
Chapter 3 Web Configuration To start the web configuration, 1. Start the web browser 2. Enter https://IP Address of the MAP-2105, in the address box (make sure HTTPS, but not HTTP) 3. Accept the security certificate and click ‘Yes’ to proceed. 4. The Web-based configuration login page opens after the security certification has been accepted. 5. Enter the user name and password. By default, the user name and password are both set to ‘admin’. 8
ページ14に含まれる内容の要旨
6. After login successfully, the Web-based configuration main page is open, which is appealed as below. The following table describes the navigation button in brief. Link Description System Settings Display the system settings page, which consists of general information about the system Network Display or hide the links to WAN and Route. WAN contains the configuration for network Route contains the configuration contains the configuration for static routing Local Service Di
ページ15に含まれる内容の要旨
contains the configuration to updates password for web management server SNMP contains the configuration for Simple Network Management Protocol Syslog Server contains the configuration for syslog server Tools Display or hide the links to Ping, Download, Firmware Update, and Settings Ping ping tools for network diagnostic Download contains configuration for TFTP file transfer Firmware Update web management firmware management Settings contains the configuration for w
ページ16に含まれる内容の要旨
System Settings contains the following: Device Name Enter a name for the device. Device Location Enter a location that the device is located. Contact Name Enter a name for the person to be contacted when consultant is needed regarding to the device. Contact Email Enter an email address to be contacted when consultant is needed. Contact Phone Enter a phone number to be contacted when consultant is needed. Object ID Display the object identification (OID) of Simple Ne
ページ17に含まれる内容の要旨
Display the IP address of the WAN interface of this device. For the first time operation, it display IP obtained from DHCP server. “Apply” Button Submit the changes. New settings are active after the device reboot. 3.2 Network 3.2.1 WAN DHCPC Dynamically assigns an IP to this device. Static IP Specify an IP address to this device. Please complete the network parameters portion. Configure Details and Save This button will lead to page according to the selected Interface Typ
ページ18に含まれる内容の要旨
-- Static IP selected Please enter the required field as follow: IP Enter an IP address for this device Netmask Enter a network mask for this IP Apply Press this button to save new settings. Back Back to previous page Gateway IP Address Specify the gateway IP address for this device. Leave blank when DHCPC is enabled, otherwise this entry will override the information obtained from DHCP server. Primary DNS Server IP Address Specify the IP address of the primary DNS ser
ページ19に含まれる内容の要旨
Secondary DNS Server IP Address Specify the IP address of the Secondary DNS server for this device. Leave blank when DHCPC is enabled, otherwise this entry will override the information obtained from DHCP server. Domain Name Specify the domain name. Apply Press this button to save new settings for Gateway IP Address, Primary and Secondary DNS Server IP Address, and Domain Name. 3.2.2 Route Route contains the following: Enable Static Routing Check or uncheck the box to enab
ページ20に含まれる内容の要旨
Static Routing Entry contains the following parameters: Subnet Enter a subnet IP address. Netmask Enter a netmask of the subnet IP address above. Gateway Select either gateway or device so that the traffic is through this selection. Please enter IP address for gateway selection. Device Select either WAN or VPN from the drop down list. All the traffic from the specified subnet will be routed to this selected device. Comment Optional comment can be added into this field. Statu
