Paradyne UIM-1000Tの取扱説明書

ページ1に含まれる内容の要旨

Installation Instructions

UIM-1000T
Gigabit Ethernet Uplink Interface Module





Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when
CAUTION
handling this equipment.


1.0 INSTALLATION

1.1 Unpack and Inspect the Equipment
The following components should be included:

1 UIM-1000T
4 #6 Phillips Panhead Nylon Locking Screws
2 #6 Phillips Beige Flathead Screws

If there is visible damage, do not attempt to insta

ページ2に含まれる内容の要旨

Ensure that the mounting holes on the UIM-1000T are lined up with the corresponding pems on the MUM2000-2 circuit board and that the board-to-board connector key pins are properly aligned. Gently press down on the back end of the UIM-1000T, over the board-to-board connector. You will feel a slight click as it becomes fully seated. Secure the UIM-1000T circuit board to the MUM2000-2 circuit board, at the pems, with the (4) provided panhead screws. Secure the UIM-1000T faceplat

ページ3に含まれる内容の要旨

1000Base-T RJ45 Port Pinout PIN CONNECTION 1 TP0+ 2 TP0- 3 TP1+ 4 TP2+ 5 TP2- 6 TP1- 7 TP3+ 8 TP3- 3.0 ADDITIONAL INFORMATION 3.1 LED Indications LED State Indication Additional Information Dplx solid green Full Duplex Ethernet The UIM-1000T Ethernet connection only operates (Duplex) connection is under full duplex data transmission. As such, whenever established an Ethernet connection is present, the Dplx LED will be illuminated. no no Ethernet If the Dplx LED is not illum

ページ4に含まれる内容の要旨

protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Caution: Chang