Linksys Owtalkの取扱説明書

ページ1に含まれる内容の要旨

Steps to configure
Linksys - PAP2 Analog Telephone Adaptor
Configuration Guide

ページ2に含まれる内容の要旨

Overview This guide shows how to configure Linksys PAP2 Analog Telephone Adaptor (ATA) so you can use the Owtalk service. But first you must be an Owtalk subscriber. Linksys ATA can be available in preconfigured mode, labeled as Owtalk Preconfigured on the surface of the packaging box. Under the preconfigured mode, all Owtalk SIP account information are pre-programmed, you don’t need to go through the following procedures. Please refer to Appendix A on how to activate an Owta

ページ3に含まれる内容の要旨

Overview This guide shows how to configure Linksys PAP2 Analog Telephone Adaptor (ATA) so you can use the Owtalk service. But first you must be an Owtalk subscriber. Linksys ATA can be available in preconfigured mode, labeled as Owtalk Preconfigured on the surface of the packaging box. Under the preconfigured Open Internet Explorer (or any other) web browser on your computer. 5 mode, all Owtalk SIP account information are pre-programmed, you don’t Enter the IP address of the

ページ4に含まれる内容の要旨

The SIP port number is set at 6060. For the remaining tabs, you can accept the 8 default settings, or you change them to suit your setup. Click Save Settings to enable the settings. 9 After the ATA set up procedure is complete, the device is ready for use and you 10 can now receive and make outgoing calls.

ページ5に含まれる内容の要旨

The SIP port number is set at 6060. For the remaining tabs, you can accept the 8 default settings, or you change them to suit your setup. Click Save Settings to enable the settings. 9 Appendix A Owtalk Preconfigured Linksys ATA To activate your Owtalk preconfigured device, you need to obtain an activation number. Go to My Account after sign-up for Owtalk at After the ATA set up procedure is complete, the device is ready for use and you 10 http://www.owtalk.com. Press Port