ページ1に含まれる内容の要旨
W2x Series
Fixed Wireless Terminals for WCDMA/HSDPA Mobile Networks
Technical Product Description
ページ2に含まれる内容の要旨
Contents 1 W2X SERIES OVERVIEW.........................................................5 1.1 INTRODUCTION ............................................................................5 1.2 ERICSSON W20/W21 - DATA TERMINAL .......................................5 1.3 ERICSSON W25 – DATA AND VOICE TERMINAL..............................6 1.4 ERICSSON W2X FEATURE SUMMARY............................................6 2 HARDWARE ARCHITECTURE ................................................8 2.1
ページ3に含まれる内容の要旨
3.2.10 SIP (W25 only).........................................................................18 3.3 USB SERVICES .........................................................................18 3.4 AUTHENTICATION.......................................................................19 4 TELEPHONY FEATURES (W25 ONLY).................................20 4.1 LINE INTERFACE ........................................................................20 4.1.1 Ringing Signal................................
ページ4に含まれる内容の要旨
9.4 ENVIRONMENTAL .......................................................................29 9.5 INTENDED USE ..........................................................................29 10 ACRONYMS AND ABBREVIATIONS.....................................30 4 221 02-FGB 101 327 Uen C - December 2006
ページ5に含まれる内容の要旨
1 W2x Series Overview 1.1 Introduction The Ericsson Fixed Wireless Terminal (FWT) W2x product series is the base for Ericsson WCDMA/HSDPA FWTs. The W2x product series is based on a platform concept aiming at providing a set of differentiated terminals from well-defined technical platforms. The W2x product series consist of different types of terminals. Currently there are three terminals in the W2x product series: • Ericsson W20 – Data Terminal - W20a for 850/1900 MHz frequency bands
ページ6に含まれる内容の要旨
1.3 Ericsson W25 – Data and Voice Terminal The Ericsson W25 data and voice terminal incorporates the same set of data features as the Ericsson W20/W21. Additionally, this model also includes voice and fax capabilities over standard analog telephone interfaces. A broad range of network services such as Prepaid Subscription, CLI (Calling Line Identification), Call Waiting, Call Barring, Call Forwarding, Multiparty Conference Calls are supported. WCDMS/HSDPA radio access is well suited for c
ページ7に含まれる内容の要旨
• Wireless LAN Access Point; IEEE 802.11b/g (Wi-Fi) • Wireless security; WEP, WPA-PSK, WPA2-PSK, MAC Association Control. • Analogue voice services (W25 only); Via a telephony line interface with high speech quality. • Analogue fax services (W25 only); Using T.38 Fax over IP protocol. • Local Administration; Built-in web based configuration tool with wizard support. • SW auto update • Remote Management Capability Via SSH 221 02-FGB 101 327 Uen C – December 2006 7
ページ8に含まれる内容の要旨
2 Hardware Architecture 2.1 Power Supply The W2x terminals can be powered from: • AC Mains via an external AC/DC power adapter (10-28 VDC) • Battery backup (Ericsson W25). 2.1.1 Power Adapter The provided power adapter has the following characteristics: Input: 100-240V AC, 50-60 Hz, 3 pole AC inlet connector (IEC 320 power inlet). Output: 12 VDC. Power consumption: 7.0 W (typical) and 11.4 W (maximum) for Ericsson W20/21 and 9.0 W (typical) and 16.2 W (maximum) for Ericsson W25. Na
ページ9に含まれる内容の要旨
2.2.3 HSDPA Throughput Rates The peak download speed is rated up to 1.8 Mbps for the Ericsson W20 and 3.6 Mbps for the Ericsson W21 and Ericsson W25. The peak up-link speed is 384 kbps. The rated HSDPA peak download speeds will eventually evolve up to 14.4 Mbps with enhanced radio performance (increased modulation and coding schemes) according to the table below (current W2x rated peak speeds highlighted): Category Peak data rate No of codes Modulation (HS-DSCH) (Mbps) (HS-DSCH) (16QAM/Q
ページ10に含まれる内容の要旨
2.2.4 Data Transmission The W2x terminals offer both circuit switched and packet switched of data transmission. The table below summarizes typical and theoretical data rates: Theoretical Typical Category/ max data Packet data service data rate Multislot class rate Upload 384 kbps Over 300 kbps Category 11 and 12 HSDPA 1.8 Mbps Download 500-800 kbps 1-6 and 11 (*) 3.6 Mbps (*) Upload 384 kbps Over 300 kbps WCDMA Download 384 kbps Over 300 kbps Upload 118 kbps 50-60 kbps Mu
ページ11に含まれる内容の要旨
2.2.5 Frequency Bands (W20) The Ericsson W20 supports frequency bands as shown in the table below: Conducted Conducted Frequencies Rx Transmit Band (MHz) sensitivity Power (dBm) (dBm) Band I Tx: 1920-1980 < -109 +23 W20e UMTS 2100 Rx: 2110-2170 Band II Tx: 1850-1910 < -109 +23 UMTS 1900 Rx: 1930-1990 W20a Band V Tx: 824-849 < -109 +23 UMTS 850 Rx: 869-894 Tx: 824-849 GSM850 < -106 Rx: 869-894 +32 (GMSK) +27 (8PSK) Tx: 880-915 EGSM 900 < -106 W20a Rx: 925-960 and Tx:
ページ12に含まれる内容の要旨
2.2.6 Frequency Bands (W21/W25) The Ericsson W21/W25 support frequency bands as shown in the table below: Conducted Conducted Rx Frequencies Transmit Band sensitivity Power (MHz) (dBm) (dBm) Band I Tx: 1920-1980 < -109 +23 UMTS 2100 Rx: 2110-2170 Band II Tx: 1850-1910 < -109 +23 UMTS 1900 Rx: 1930-1990 Band V Tx: 824-849 < -110 +23 UMTS 850 Rx: 869-894 Tx: 824-849 GSM850 < -106 Rx: 869-894 +32 (GMSK) Tx: 880-915 +27 (8PSK) EGSM 900 < -106 Rx: 925-960 Tx: 1710-1785 DCS
ページ13に含まれる内容の要旨
The Ericsson W20e, W21 and W25 support 1.8 and 3V SIM while the Ericsson W20a only supports 3V SIM. 2.3 Wireless LAN (WLAN) Interface The W2x terminals act as wireless Access Point (AP) supporting IEEE 802.11b/g standards. IEEE 802.11b operates in the unlicensed 2.4 GHz band and can theoretically achieve 11 Mb/s. Practical throughput, ranges from ~7 Mb/s (using UDP) to ~6 Mb/s (using TCP). IEEE 802.11g operates in the same band as 802.11b and has a theoretical top speed of 54 Mb/s. In
ページ14に含まれる内容の要旨
2.4 USB Interface The W2x terminals include a USB 2.0 Host Controller with two (2) ports (type A) supporting both full speed and high-speed. The USB interface supports one low power device per port hence the maximum power consumption of a device is 100 mA. Maximum practical cable length for USB is 5 m. 2.5 Ethernet Interface The W2x terminals include an Ethernet switch with four (4) external LAN 4x10/100BaseTx ports (female RJ45) for connection to PC equipment. Each Ethernet port suppor
ページ15に含まれる内容の要旨
Text Type Function 10-28 Circular Standard power inlet for connecting the included VDC power supply adapter. Reset Switch A small hole in the housing. Used to restore the unit to its factory default configuration. USB 2 x USB-A USB connectors, for connecting USB devices to the unit, e.g. printer or mass storage. LAN 1-4 4 x RJ45 Ethernet LAN connectors for connecting the unit to client PCs or an Ethernet switch/hub. 2.7.2 W25 Connectors The Ericsson W25 is equipped with the followi
ページ16に含まれる内容の要旨
2.8.1 W20/W21 LED Indicators The following LED indicators are visible on the front of the Ericsson W20/W21: Text Color Function Power Green Power is on. Unlit Power is off. Mobile Network Green The UMTS network is available. Red The GSM (GPRS/EDGE) network is available. Flashing Searching for a connection. Unlit No connection to the mobile network. Internet Green Connection to Internet established. Unlit No Internet connection. Green The Wireless LAN is active. Wireless LAN Unlit
ページ17に含まれる内容の要旨
3 Data Features and Function 3.1 Layer 2 Functions 3.1.1 Bridging LAN and WLAN The W2x terminals support bridging/switching traffic between the LAN and WLAN interfaces. 3.1.2 WLAN Whitelist The W2x terminals support WLAN whitelist, also known as “MAC Association Control” or “MAC Access List”. Up to 20 WLAN MAC addresses can be added to the list and the use of the whitelist is possible to enable/disable. 3.2 Internet Protocol Services The Internet Services in the W2x terminals are base
ページ18に含まれる内容の要旨
3.2.5.1 NAT Port Forwarding The NAT Port Forwarding feature, sometimes referred to as Virtual Server, redirects traffic from the WAN side to a server on the LAN side. The Port Forwarding feature requires a public WAN IP address on the W2x terminals. 3.2.5.2 NAT ALGs An ALG enables the transfer of specific application streams through firewall policies and NAT. This is enabled by creating dynamic holes in the firewall policy and NAT and changing IP addresses in network protocol headers, a
ページ19に含まれる内容の要旨
It is possible to have two storage devices or a storage device and a printer connected to the W2x terminal at the same time. When an external hub is connected, the W2x terminals support connection of up to two storage devices and one printer at the same time. Both USB 1.1 and 2.0 (full speed and high-speed) are supported. 3.4 Authentication Authentication towards the UMTS/GSM radio network can be done via either PIN code or PPP username and password. 221 02-FGB 101 327 Uen C – December
ページ20に含まれる内容の要旨
4 Telephony Features (W25 only) The Ericsson W25 provides analogue voice services via the telephony line interface with high speech quality. 4.1 Line Interface The POTS (FxS) interface can be configured, i.e. impedance, frequency, cadence, levels etc. DTMF dialing is supported. 4.1.1 Ringing Signal It is possible to configure different ringing signals depending on the call type. The mapping and ring frequency are also configurable. 4.1.2 CLIP, CWI and Voice Mail Alert The Ericsson W
