ページ1に含まれる内容の要旨
PD-85_e 1 ページ ２００５年１月３１日 月曜日 午前１０時１１分
Owner’s Manual
Thank you, and congratulations on your choice of the Roland PD-85 V-Pad.
201a
Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES”
(p. 6; p. 7). These sections provide important information concerning the proper operation of the unit. Additionally,
in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner’s
manual should be read
ページ2に含まれる内容の要旨
PD-85_e 2 ページ ２００５年１月３１日 月曜日 午前１０時１１分 The band has a width of 7 mm. Use this for adjusting the head tension. 7 mm Features • Snare/tom pad with embedded-mesh head for superior • You can use cross-stick (closed rim shot), and rim shot playing feel, and quiet response. playing techniques. • Compact, eight-inch pad allows for greater versatility • Brushes (nylon) can be used for brush playing. when setting up. • Tonal changes can be expressed by varying the location at which the
ページ3に含まれる内容の要旨
PD-85_e 3 ページ ２００５年１月３１日 月曜日 午前１０時１１分 Attaching the Pad to a Stand Connecting To A Percussion Sound Module Attach the PD-85 to a stand (MDS series). fig.Stand.e Connecting to a percussion sound module (TD-20, TD-12, TD- Tighten 10, TD-8, TD-6V/6, TD-3, etc.). When you have finished connecting to your percussion sound module, refer to the owner’s manual supplied with the sound module, and make the settings for it. Loosen • To prevent malfunction and/or damage to speakers or other
ページ4に含まれる内容の要旨
PD-85_e 4 ページ ２００５年１月３１日 月曜日 午前１０時１１分 Sound Module Compatibility Chart Playing Methods TD-20, TD-12, TD-6V/6, TD-3 Head Shots TD-10, TD-8 Hit only the head of the pad. With certain snare sounds, Head Shot o o playing position will change the nuance of the sound. Positional Sensing o – fig.HeadShot.e Rim Shot o o Cross Stick o o * For more on settings and tones, see the respective module’s owner’s manual. Head Using with some sound module that has correspondence Rim Shots to t
ページ5に含まれる内容の要旨
PD-85_e 5 ページ ２００５年１月３１日 月曜日 午前１０時１１分 Head Replacement If a lock bushing happens to become separated from the frame while the head is being replaced, position the bushing so its four slots are aligned with the corresponding ridges in the frame, then press down When the Head Should Be Replaced firmly on the bushing. The head is an expendable item that eventually will wear out fig.LockBush.e and need to be replaced. Replace the head when the following Lock Bus
ページ6に含まれる内容の要旨
PD-85_e 6 ページ ２００５年１月３１日 月曜日 午前１０時１１分 USING THE UNIT SAFELY The symbol alerts the user to important instructions Used for instructions intended to alert or warnings.The specific meaning of the symbol is the user to the risk of death or severe determined by the design contained within the injury should the unit be used triangle. In the case of the symbol at left, it is used for improperly. general cautions, warnings, or alerts to danger. Used for instructi
ページ7に含まれる内容の要旨
PD-85_e 7 ページ ２００５年１月３１日 月曜日 午前１０時１１分 (Add) (Add) • Attach the pad to a stand with care to avoid danger • This unit is shipped from the factory with the head of pinching the fingers. tension loosened. Be sure to tighten the tension ............................................................................................................ before use. Striking the head when the head tension (Add) is loose may damage the sensor and head. • Do not apply e
ページ8に含まれる内容の要旨
PD-85_e 8 ページ ２００５年１月３１日 月曜日 午前１０時１１分 Information When you need repair service, call your nearest Roland Service Center or authorized Roland distributor in your country as shown below. PHILIPPINES COSTA RICA TRINIDAD NORWAY JORDAN AFRICA G.A. Yupangco & Co. Inc. JUAN Bansbach Instrumentos AMR Ltd Roland Scandinavia Avd. AMMAN Trading Agency 339 Gil J. Puyat Avenue Ground Floor Kontor Norge 245 Prince Mohammad St., EGYPT Musicales Makati, Metro Manila 1200, Maritime Plaza Amman 1118, JORDAN
