ページ1に含まれる内容の要旨
Half Gallon
Hi-Power Blender
MX1000R
INSTRUCTION BOOKLET
ページ2に含まれる内容の要旨
IMPORTANT UNPACKING INSTRUCTIONS ® 1. Place the box containing your Waring Pro blender on a flat sturdy surface before unpacking. 2. Open corrugated flaps. 3. Remove Instruction Book and any printed materials from top of box. 4. Pull up corrugated material and remove. Remove jar and padding. CAUTION: Sharp blade inside blender jar. 5. Remove corrugated insert. Remove blender base from box and set aside. 6. Replace all corrugated inserts in the gift box and save the box for repacking. REPACKING
ページ3に含まれる内容の要旨
10. Keep hands and utensils out of container while blending to prevent the possibility of severe personal injury and/or damage to the blender. A rubber scraper may be used, but must be used only when the blender is not running. 11. Blades are sharp. Handle carefully. 12. Always operate blender with cover in place. 13. When blending hot liquids, remove center piece of two-piece cover. See Hot Blending Instructions. 14. The use of ear protection is recommended during extended operating
ページ4に含まれる内容の要旨
GROUNDING INSTRUCTIONS • For your protection, this appliance is equipped with a 3-conductor cord set. • 120 volt units are supplied with a molded 3-prong grounding-type plug (NEMA 5-15P) and should be used in combination with a properly connected grounding-type outlet as shown in Figure 1. If a grounding-type outlet is not available, an adapter, shown in Figure 2, may be utilized to enable a 2-slot wall outlet to be used with a 3-prong plug, except in Canada and Europe. Referring to Figure
ページ5に含まれる内容の要旨
7. Allow motor to come to a complete stop before removing container from blender base. Never place the container on the motor base or remove it from the motor base while motor is running. 8. Always hold container with one hand when starting and while blending. Never operate without container lid. 9. Wash and dry container after each use. See Cleaning and Sanitizing instructions. IMPORTANT HOT BLENDING INSTRUCTIONS To minimize the possibility of being scalded when blending hot materia
ページ6に含まれる内容の要旨
• In repetitive batch-processing applications, frequent cleaning of the container will prolong the life of the blade assembly. In no case should actual running time between cleanings exceed 1/2 hour. • Do not use container to store processed foods or beverages. To Wash and Rinse Container: 1. REMOVE CONTAINER FROM MOTOR BASE. Remove lid. Rinse container interior and lid under running water. Add washing solution to container. Scrub and flush out the container interior and lid to dis
ページ7に含まれる内容の要旨
ページ8に含まれる内容の要旨
Waring Consumer Products Division of Conair Corporation 150 Milford Rd East Windsor NJ 08520 027302 Printed in USA 08WR200 PG-5378 www.waringproducts.com
