ページ1に含まれる内容の要旨
BL600 SERIES BLENDER
ページ2に含まれる内容の要旨
BLENDER SAFETY DANGER Electricity GENERAL Caution DANGER Risk of Electrical Shock DANGER Keep Hands Clear IMPORTANT: Please adhere to all safety guidelines contained in this manual. DANGER: You can be seriously injured if you do not follow these intructions. WARNING WARNING Moving Parts! Electrical Shock Hazard Always cover the lid on the container when Plug into a grounded outlet. blending. Do not remove ground. Do not put hands, spoons or other utensils in container when blending. Do not use a
ページ3に含まれる内容の要旨
IMPORTANT SAFEGUARDS When using electrical appliances, basic 14. Screw on locking ring firmly. Injury can safety precautions should always be result if moving blades accidentally be- followed, including the following: come exposed. 1. Read all the instructions before using the 15. Always operate blender with lid in place. blender. 16. When blending hot liquids, place a hand 2. Plug into a grounded outlet. towel over the cover. Do not fill blender con- tainer beyond 2-3 full. Always begin process
ページ4に含まれる内容の要旨
BLENDER OPERATION To operate the blender, proceed as follows 1. For the first time user, wash the container assembly, including the lid, before using it. (Refer to "Cleaning Instruction") Do not put the container assembly & blender base assembly in the dishwasher. 2. Place the blender on a dry, clean, level surface, and press OFF. 3. Place the container onto the blender base. Make sure it rests securely on the base. 4. Plug the blender into an electric outlet. 5. Place the ingredients into the c
ページ5に含まれる内容の要旨
CLEANING INSTRUCTION Omega blender container parts are corrosion resistant, sanitary and easily cleaned. Do not put the container assembly & blender base assembly in the dishwasher. 1.Before first use and after every use, separate container parts from the base. 2.Add cleaning solution to the container. Use washing solution of tepid water (less than 115°F/46°C) and a non-sudsing detergent. Use the recommended amount of detergent. 3.Scrub and flush out the container interior lid and feeder cap to
ページ6に含まれる内容の要旨
TROUBLESHOOTING Problem Solution 1. Place container properly on the base 2. Check to ensure controls are clean and moving freely. 3. Double-check to ensure power cord is securely plugged into the electric outlet. 1. Blender fails to start. 4. Check to see if the circuit breaker has tripped or if the fuse for the electric out- let has blown. 4. Check the onboard reset switch lo- cated at the rear of the blender base. 1. Check the onboard reset switch lo- cated at the rear of the blender base.
ページ7に含まれる内容の要旨
MAINTENANCE Inspect the blender and its various parts and replace as follows: 1. Unplug the blender and remove the container from the base. 2. Inspect the container blades for wear, Daily nicks, and broken or loose blades. Re- place if necessary. 1. Unplug the blender. 2. Inspect the power cord insulation and Weekly power plug for cracks. Refer to "Techni- cal Service" for repair or replacement. 1. Review the condition of the container assembly and Mushroom Clutch Set at Quarterly least every 90
ページ8に含まれる内容の要旨
OMEGA BL600 3 2011 Rev A
