ページ1に含まれる内容の要旨
3-867-185-11 (1)
Personal Audio
System
Operating Instructions
ZS-D5
1999 by Sony Corporation
ページ2に含まれる内容の要旨
Information Warning For customers in the United States To prevent fire or shock hazard, do not This equipment has been tested and found to expose the player to rain or moisture. comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordan
ページ3に含まれる内容の要旨
Basic Operations Table of contents Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape CD Player The Timer 12 Using the display 28 Setting the clock 13 Locating a specific track 29 Waking up to music 14 Playing tracks repeatedly 31 Falling asleep to music (Repeat Play) 32 Timer-recording radio programs 15 Playing a single track (Single Track Play) Setting Up 16 Playing tracks in random order 34 Choosing the power sources (Shuffle Play) 36 Connecting o
ページ4に含まれる内容の要旨
Basic Operations Playing a CD 3 1,2 Connect the supplied AC power cord (see page 34). 1 Press 6 PUSH OPEN/CLOSE and place the CD on the CD compartment. With the label side up 2 Close the CD compartment. Display 3 Press ^. (On the remote, press ( on the CD section.) The player turns on (direct power-on) and the player plays all the tracks once. Track number Playing time 4 Basic Operations
ページ5に含まれる内容の要旨
Basic Operations Use these buttons for additional operations POWER ^ p 6 PUSH OPEN/CLOSE VOLUME +, – =, + Tip To Press Next time you want to Adjust the volume VOLUME +, – listen to a CD, just press ^. The player Stop playback p turns on automatically and starts playing the Pause playback ^ CD. (On the remote, press P.). Press again to resume play after pause. Go to the next track + Go back to the previous track = Remove the CD 6 PUSH OPEN/CLOSE Turn on/off the player POWER Basic Operations 5
ページ6に含まれる内容の要旨
Listening to the radio 1 2 Connect the supplied AC power cord (see page 34). Display 1 Press BAND until the band you want appears in the display (direct power-on). 2 Hold down TUNE/TIME SET + Indicates an FM stereo broadcast. or – until the frequency digits begin to change in the display. The player automatically scans the radio frequencies and stops when it finds a clear station. If you can't tune in a station, press TUNE/TIME SET + or – until you tune in the station you want. 6 Basic Operation
ページ7に含まれる内容の要旨
Basic Operations Use these buttons for additional operations POWER MODE•MONO/ST ISS VOLUME +, – To Press Adjust the volume VOLUME +, – Turn on/off the radio POWER Tips To improve broadcast reception • If the FM broadcast is Reorient the antenna for FM. Reorient the player itself noisy, press for AM. MODE•MONO/ST ISS until “Mono” appears in the display and the radio will play in monaural. • Next time you want to listen to the radio, just press the BAND button. The player turns on automatically an
ページ8に含まれる内容の要旨
Playing a tape 3 1,2 Connect the supplied AC power cord (see page 34). 1 Press 6 PUSH OPEN/CLOSE to open the tape compartment and insert a recorded tape. Use TYPE I (normal), TYPE II (high position) and TYPE IV (metal) tapes. With the side you want to play facing forward 2 Press 6 PUSH OPEN/CLOSE to close the compartment. Display 3 Press (. (On the remote, press TAPE (.) The player turns on (direct power-on) and starts playing. Tape counter 8 Basic Operations
ページ9に含まれる内容の要旨
Basic Operations Use these buttons for additional operations POWER p 9 VOLUME +, – 0, ) DIR MODE COUNTER RESET Tips To Press • Press COUNTER Adjust the volume VOLUME +, – RESET to reset the counter to “000.” Stop playback p • Next time you want to Play the reverse side 9 listen to a tape, just press ( or 9. The Fast-forward or rewind the tape ) or 0 player turns on automatically and Eject the cassette 6 PUSH OPEN/CLOSE starts playing the tape. Turn on/off the player POWER To select the direction
ページ10に含まれる内容の要旨
Recording on a tape 31 Connect the supplied AC power cord (see page 34.) To record on a MiniDisc or DAT recorder, connect the component (see page 36). 1 Press 6 PUSH OPEN/CLOSE to open the tape compartment, and insert a blank tape. Use TYPE I (normal) tape only. Press 6 PUSH OPEN/CLOSE again to close the compartment. With the side you want to record on facing forward 2 Select the program source you want to record. Display To record from the CD player, insert a CD (see page 4) and press p on the
ページ11に含まれる内容の要旨
Basic Operations Recording from the CD 3 Start recording. player Press r/P and then (. To record on the reverse side, press 9. (On the remote, while keeping r/P pressed, press TAPE ( or 9.) To record from the CD player, Recording from the press ^ to start playing the CD radio tracks. (On the remote, press ( on the CD section.) Note On the player, press ( within 4 seconds after r/P is pressed. Tips Use these buttons for additional operations • Adjusting the volume or the audio emphasis (see POW
ページ12に含まれる内容の要旨
The CD Player Using the display DISPLAY ENTER MEMORY You can check information about the CD using the display. Checking the total track number and playing time Press DISPLAY ENTER MEMORY in stop mode. Total track number Total playing time Checking the remaining time Press DISPLAY ENTER MEMORY while playing a CD. To display Press DISPLAY ENTER MEMORY The current track number Once and the remaining time on the current track* Remaining time on the CD Twice and the number of tracks left The current
ページ13に含まれる内容の要旨
The CD Player Locating a specific track You can quickly locate any track using the number buttons. You can also find a Number specific point in a track while playing a buttons CD. =, + Note To locate Press You cannot locate a A specific track directly Number button of the specific track if track. “SHUF” or “PGM” is lit in the display. Turn off A point while listening to = or + while playing the indication by the sound and hold down until you pressing p on the CD find the point. section. A point
ページ14に含まれる内容の要旨
Playing tracks repeatedly (Repeat Play) Number You can play tracks repeatedly in buttons normal, shuffle or program play modes (see pages 16 - 18). MODE ( p Note 1 Press p on the CD section. When you repeat a “Cd” appears in the display. single track or all the tracks, make sure 2 Proceed as follows. neither “SHUF” nor “PGM” is lit in the To repeat Do this display. If either is lit, A single track 1 Press MODE until “REP 1” turn it off by pressing appears. p on the CD section. 2 Press the number
ページ15に含まれる内容の要旨
The CD Player Playing a single track (Single Track Play) Number You can play a single track once, and buttons stop the player automatically. MODE ( p 1 Press p on the CD section. “Cd” appears in the display. On the player 2 Press MODE until “1TRACK” appears in the • Use MODE•MONO/ display. ST ISS to select “1TRACK”. 3 Press the number buttons to select the track you • Use = or + to want to play. select the track that you want, and then press ^. To cancel Single Track Play Press MODE until “1TRA
ページ16に含まれる内容の要旨
Playing tracks in random order (Shuffle Play) You can play tracks in random order. MODE ( p 1 Press p on the CD section. “Cd” appears in the display. On the player 2 Press MODE until “SHUF” appears in the display. Use MODE•MONO/ ST ISS to select 3 Press ( on the CD section to start shuffle play. “SHUF”. To cancel Shuffle Play Press MODE until “SHUF” disappears from the display. 16 The CD Player
ページ17に含まれる内容の要旨
The CD Player Creating your ^ PROGRAM•AUTO PRESET own program CHECK (Program Play) While listening to the CD, you can p select the track you want and arrange DISPLAY the playing order of up to 20 tracks on ENTER a CD. MEMORY =, + 1 Press ^ to start play. 2 Press PROGRAM•AUTO PRESET•CHECK until “PGM” appears in the display. Tips 3 Press = or + to select the track you want to • If you made a mistake, program, and press DISPLAY ENTER MEMORY. press CANCEL and re- Repeat this step. enter the track nu
ページ18に含まれる内容の要旨
Creating your own program (Program Play) (continued) Tips To cancel Program Play • If the program play is Press MODE•MONO/ST ISS until “PGM” disappears finished, the program is from the display. saved. You can play the same program again by pressing ^. To check the order of tracks before play • If you open the CD Press PROGRAM•AUTO PRESET•CHECK in stop compartment, the program is erased. mode until “CHECK” appears in the display. • You can record your As you press = or +, the track number appea
ページ19に含まれる内容の要旨
The Radio The Radio Presetting radio BAND PROGRAM•AUTO PRESET stations CHECK You can store radio stations into the player's memory. You can preset up to 20 radio stations, 10 for FM and AM in any order. 1 Press BAND until the band you want appears in the display. 2 Hold down PROGRAM•AUTO PRESET•CHECK until “AUTO” appears in the display. The stations are stored in memory from the lower frequencies unless a station has a weak signal. If a station cannot be preset automatically You need to preset
ページ20に含まれる内容の要旨
Playing preset radio stations Once you've preset the stations, use the number buttons on the remote or PRESET +/– on the player to tune in Number buttons your favorite stations. BAND On the player 1 Press BAND to tune in the band you want. Use PRESET + or – to 2 Press the number buttons to display the preset display the preset number of the station you want. number you want. Preset number 20 The Radio
