ページ1に含まれる内容の要旨
NPB-MDM Modem Card
INSTALLATION INSTRUCTIONS
SAFETY INSTRUCTIONS
GENERAL
Keep these Installation Instructions for industrial safety
and the prevention of accidents.
Only qualified personnel shall do mounting and
installation work with these devices, see section titled
CAUTION
Qualified Personnel.
This modem may require testing and
The information in these instructions must be read and
certification in some European and Asian
understood by every person using this device.
countries p
ページ2に含まれる内容の要旨
NPB-MDM MODEM CARD MOUNTING 4. Remove the Slot 1 blanking end plate. a. Retain the blanking end plate in case the WARNING NPB-MDM Modem Card must be removed at a Power to the WEB-201 Controller must be OFF later date. when installing or removing option cards, or 5. Carefully insert the pins of the NPB-MDM Modem damage will occur! Also, be very careful to Card into the socket of slot 1 option connectors. plug any option card into its connector The mounting holes on the option board should
ページ3に含まれる内容の要旨
NPB-MDM MODEM CARD WIRING SERIAL SHELL NOTES Connect a standard RJ-11 telephone cable to the If an NPB-MDM Modem Card is installed and the WEB- connector on the NPB-MDM Modem Card and the other 201 Controllers Mode Jumper (Refer to Fig. 4) is put in end to the working PSTN (dialup) telephone receptacle. Serial Shell position, the WEB-201 base RS-232 port becomes active immediately following a reboot. This allows an RS-232 connection to the Serial Shell for debugging purposes. The NPB-
ページ4に含まれる内容の要旨
NPB-MDM MODEM CARD Automation and Control Solutions Honeywell International Inc. Honeywell Limited-Honeywell Limitée 1985 Douglas Drive North 35 Dynamic Drive Golden Valley, MN 55422 Scarborough, Ontario M1V 4Z9 customer.honeywell.com ® U.S. Registered Trademark © 2006 Honeywell International Inc. 95-7730 J.I. 04-06
