ページ1に含まれる内容の要旨
Contents
1. INSTRUCTIONS FOR SAFE AND PROPER USE________________ 4
2. INSTALLATION OF THE APPLIANCE_________________________ 6
3. ADAPTATION TO DIFFERENT TYPES OF GAS _______________ 11
4. FINAL OPERATIONS_____________________________________ 13
5. DESCRIPTION OF CONTROLS ____________________________ 15
6. USE OF THE HOB _______________________________________ 20
7. USE OF THE OVENS_____________________________________ 21
8. AVAILABLE ACCESSORIES _______________________________ 22
9
ページ2に含まれる内容の要旨
Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THERE IN BEFORE USING THE COOKER. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND CONFORMS TO CURRENT REGULATION
ページ3に含まれる内容の要旨
Introduction THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND BRAND NAME IS POSITIONED VISIBLY IN THE STORAGE COMPARTMENT. THE PLATE MUST NOT BE REMOVED. DO NOT PUT PANS WITHOUT PERFECTLY SMOOTH AND FLAT BOTTOMS ON THE HOB GRIDS. DO NOT USE CONTAINERS OR BROILERS THAT EXTEND BEYOND THE OUTER PERIMETER OF THE HOB. THE APPLIANCE IS DESIGNED FOR USE BY ADULTS. DO NOT ALLOW CHILDREN OR INFIRM PERSONS TO GO NEAR OR PLAY WITH IT. DURING USE THE APPLIANCE BECOME
ページ4に含まれる内容の要旨
Instructions for the installer 2. INSTALLATION OF THE APPLIANCE It is the law that all gas appliances are installed by authorised persons. Clearance around the cooker must comply with the requirements of AGA601. 2.1 Electrical connection Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment. This rating plate must never be removed. On the power line, install a two-pole cut-off device wi
ページ5に含まれる内容の要旨
Instructions for the installer 2.2 Gas connection This appliance is suitable for installation with Natural Gas or LPG. Refer to page 12 for the relevant burner pressure and appropriate injector sizes. When the appliance is to be connected to Natural Gas then the pressure regulator supplied must be fitted to the gas inlet. A test point (for checking the gas pressure) is supplied either with the regulator or as a separate fitting in the case of LPG appliances. Connection of the appli
ページ6に含まれる内容の要旨
Instructions for the installer 2.3 Room ventilation Caution – This cooker may only be installed and operated in rooms permanently ventilated in accordance with current regulations. For proper operation of a gas appliance it is essential for the air necessary for combustion of the gas to be able to flow naturally into the room. Air must flow directly into the room through openings in its outside walls. This (these) opening (s) must have a free passage cross-section of at 2 2 least 1
ページ7に含まれる内容の要旨
Instructions for the installer REQUIREMENTS 1 Overhead clearances – (Measurement A) Range hoods and exhaust fans shall be installed in accordance with the manufacturer’s instructions. However, in no case shall the clearance between the highest part of the hob of the cooking appliance and a range hood be less than 600 mm or, for an overhead exhaust fan, 750 mm. Any other downward facing combustible surface less than 600 mm above the highest part of the hob shall be protected for
ページ8に含まれる内容の要旨
Instructions for the installer 2.5 Instruction for wall fixing 1) Fix the screw to the wall and hook the chain (B); 2) Hook the chain to the hole positioned at the rear of the cooker by the gas pipe (A); 3) Once the chain is in position, push the cooker against the wall; 4) The height of the screw hole from floor level must not exceed 800 mm (C). B A C 10
ページ9に含まれる内容の要旨
Instructions for the installer 3. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The hob of the cooker is adjusted for use with natural gas at a pressure of 1.0kPa. If used with other types of gas, you have to replace the nozzles and regulate the primary air to the burners. Then adjust the minimum flame on the gas taps. For nozzle replacement and burner adjustment you must raise the hob
ページ10に含まれる内容の要旨
Instructions for the installer 3.2 Adjustment for LPG Loosen screw A and push air regulator B to the bottom. With a 7 mm wrench, remove nozzle C and replace it with the proper one (follow the instructions on the reference tables for the type of gas to be used). The torque wrench setting of the nozzle must not exceed 3 Nm. Adjust the air by sliding regulator B until reaching distance “X” shown in the table in paragraph “3.4 Regulation of primary air”. Lock regulator B by tighten
ページ11に含まれる内容の要旨
Instructions for the installer 3.4 Regulation of primary air Referred to distance “X” in mm. Models CSA19 / CSA196 / CSA20 Burner NG LPG 1.00 kPa 2.75 kPa Auxiliary 3.0 2.5 Semi rapid 3.0 2.0 Rapid 3.0 2.0 Wok 4.0 2.5 Fish burner (*) 4.0 4.0 (*) Models CSA19 / CSA196 4. FINAL OPERATIONS Having carried out the above adjustments, reassemble the appliance following, backwards, the instructions in paragraph “3.1 Raising of the hob”. 4.1 Adjustment of m
ページ12に含まれる内容の要旨
Instructions for the installer 4.3 Arrangement of burners on the hob Model CSA19 Model CSA196 Model CSA20 Burners 1 Auxiliary 2 Semi rapid 3 Rapid 4 - 5 Wok 6 Fish burner 4.4 Positioning and levelling of the appliance Having carried out the electricity and gas hook-up, level the appliance using the four adjustable legs. 4.5 Lubrication of gas taps With time it may happen that the gas taps get blocked and hard to turn. Clean them inside a
ページ13に含まれる内容の要旨
Instructions for the user 5. DESCRIPTION OF CONTROLS 5.1 Front control panel All the cooker controls and commands are on the front panel. Model CSA19 Model CSA196 Model CSA20 Before using the main oven check that the electronic programmer is showing the symbol (see paragraph “5.2.1 Clock adjustment”). DESCRIPTION OF SYMBOLS BACK LEFT BURNER BACK RIGHT BURNER FRONT LEFT BURNER FRONT RIGHT BURNER WHERE AVAILABLE FRONT CENTRAL B
ページ14に含まれる内容の要旨
Instructions for the user HOB BURNER COMMAND KNOB The flame is lit by pressing the knob and turning it anticlockwise to maximum flame . To adjust the flame turn the knob between maximum ( ) and minimum ( ). The burner goes out when the knob is returned to the position . THERMOSTAT KNOB (OVENS) Selection of cooking temperature is carried out by turning the knob clockwise to the required temperature, between 50° and 250°C. The tell-tale light comes on to indicate that the oven is
ページ15に含まれる内容の要旨
Instructions for the user 5.2 Electronic Programmer The programmer user instructions are valid only for the main oven. LIST OF FUNCTIONS MINUTE-COUNTER KEY COOKING TIME KEY END-OF-COOKING KEY DECREASE TIME KEY INCREASE TIME KEY 5.2.1 Clock adjustment When using the oven for the first time, or after a power failure, the display flashes regularly and indicates . Press the keys and at the same time the keys o : e
ページ16に含まれる内容の要旨
Instructions for the user 5.2.2 Semiautomatic cooking Use this setting for automatic oven switch-off at the end of cooking time. By pressing key , the display lights up, showing ; keep the key pressed and at the same time, press keys o to set the cooking time. Release key to start the programmed cooking time count. The display will now show the right time together with symbols A and . 5.2.3 Automatic cooking Use this setting to automatically start and stop the oven. By p
ページ17に含まれる内容の要旨
Instructions for the user 5.2.5 Adjusting alarm volume The acoustic alarm has three different settings. These can be operated, while the alarm is sounding, by pressing key . 5.2.6 Switching off the alarm The alarm switches off automatically after seven minutes. They can be manually de-activated by pressing the keys and together. 5.2.7 Minute Counter The programmer can also be used as a simple minute counter. By pressing key , the display shows ; keep the key pressed an
ページ18に含まれる内容の要旨
Instructions for the user 6. USE OF THE HOB 6.1 Lighting of the hob burners Before lighting the hob burners check that the flame cap crowns are properly positioned with their appropriate burner caps: niche A must be centred with pin B. Grid C should be used with Chinese woks. Each knob corresponds to the burner indicated. The appliance is equipped with an electronic lighting device. Just press and turn the knob anticlockwise to the maximum flame symbol until th
ページ19に含まれる内容の要旨
Instructions for the user 6.3 Diameter of containers Models CSA19 / CSA196 / CSA20 (*) Burners Ø min. and max. (in cm) 1 Auxiliary 12-14 Semi rapid 16-20 2 3 Rapid 18-24 4 Wok 20-26 5 Wok (Model CSA20) 20-24 Fish burner (Models CSA19 / CSA196) Special oval-shaped pan 6 (*) For burner reference numbers, see page 14. 7. USE OF THE OVENS 7.1 Warnings and general advice Before using the oven for the first time, pre
ページ20に含まれる内容の要旨
Instructions for the user 8. AVAILABLE ACCESSORIES The oven features 4 support positions for plates and racks of different height. Models CSA19 / CSA196 Model CSA20 Main Auxiliary Oven grill: for cooking food on plates, small cakes, roasts or food requiring light grilling. Plate grill: for placing above plate for cooking foods that might drip. Oven plate: useful for catching fat from foods on the grill above. Pastry plate: for baking c
