ページ1に含まれる内容の要旨
®
Microwave Drawer
Itallnsta In M o aaunl
SPECIAL WARNING
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE ThIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL INSPECTOR’S USE.
READ AND SAVE ThESE INSTRUCTIONS FOR FUTURE REFERENCE.
CLEARANCES ANd dI m ENSIo NS
For SAFETY CONSIDERATIONS do not install drawer in any combustible cabinetry, which is not in accord with the stated
clearances and dimensions on pages 2 and 3. See Figure 1 (for 24") or Figures 3 and 4 (for
ページ2に含まれる内容の要旨
CLEARANCES ANd dI m ENSIo NS • Dimensions that are shown in Figure 1 (for 24") or Figures • Check location where the Microwave Drawer will be 3 and 4 (for 30") must be used. Given dimensions provide installed for proper electrical supply. minimum clearance. Locate electrical outlet in the shaded • Y o u r o v e n c a n b e b u i l t i n t o a c ab i n e t o r w a l l b y i t s e l f o r area in the upper left-hand corner of the cutout. See Figure 7. under a gas or electric
ページ3に含まれる内容の要旨
30" mICR o WAv E dRAWER mEASURE m ENt S A. 6" (152.40 mm) C Figures 3, 4 and 5 contain many Microwave Drawer measurements A B B. Suggested electrical for reference when planning the drawer’s location. outlet location* E D This Microwave Drawer can be installed below any electric or C. Anti-Tip block gas wall oven. F D. 5" (127 mm) G K H * Can also be installed using an electrical outlet in an adjacent E. 3-1/2" (88.90 mm) I Q cabinet within the area where the provided electrical cord can F.
ページ4に含まれる内容の要旨
ELECt RICAL oU t LEt dRAWER INSt ALLAt Io N Anti-Tip block 6" Suggested electrical (152.4 mm) outlet location* 5" (127 mm) Mounting flange 3 1/2" (89 mm) 4" Figure 8A (101.6 mm) Parts supplied Figure 7 1. Place the drawer adjacent to the wall or cabinet opening. Plug the power supply cord T h e e l e c t r i c a l r e q u i r e me n t s a r e a 1 2 0 v o l t 6 0 H z , A C o n l y , into the electrical outlet. 15 amp. or more protected electrical supply. It is recommended 2. Carefully gui
