ページ1に含まれる内容の要旨
OVER THE RANGE MODELS
R-1405, R-1406
R-1405/06-B318 1 7/15/02, 9:54 AM
ページ2に含まれる内容の要旨
FOR CUSTOMER ASSISTANCE To aid in reporting this microwave oven in case of loss or theft, please record below the model number and serial number located on the unit. We also suggest you record all the information listed and retain for future reference. MODEL NUMBER ________________________ SERIAL NUMBER ______________ DATE OF PURCHASE ______________________ DEALER ____________________________ TELEPHONE ________________ SERVICER ___________________________ TELEPHONE ________________ TO PHONE: DIA
ページ3に含まれる内容の要旨
CONTENTS For Customer Assistance.......................... 2 Special Features......................................... 22-27 Precautions to Avoid Possible Popcorn..................................................... 22 Exposure to Excessive Reheat ...................................................... 22-23 Microwave Energy .................................. 2 Cook.......................................................... 24 Contents...................................................... 3 Defros
ページ4に含まれる内容の要旨
CONSUMER LIMITED WARRANTY SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the “Product”), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the period(s) set forth below. This warranty does not
ページ5に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances basic safety precautions should be followed, including the following: WARNING - To reduce the risk of burns, electric shock, fire, injury to persons or exposure to excessive microwave energy: 1. READ ALL INSTRUCTIONS BEFORE example, near a kitchen sink, in a wet USING THE APPLIANCE. basement or near a swimming pool, and the like. 2. Read and follow the specific “PRECAU- 13. Do not immerse cord or plug in water. TIONS TO AVOID POSSIBL
ページ6に含まれる内容の要旨
UNPACKING AND INSTALLATION INSTRUCTIONS UNPACKING AND EXAMINING YOUR OVEN Open the bottom of the carton, bend the carton flaps back and tilt the oven over to rest on plasticfoam pad. Lift carton off oven and remove all packing materials, WALL and TOP CABINET TEMPLATE, Turntable, and Turntable Support. SAVE THE CARTON AS IT MAY MAKE INSTALLATION EASIER. 1. Remove the feature sticker from the outside of the door, if there is one. Oven cavity 2. DO NOT REMOVE THE WAVEGUIDE COVER, which is located
ページ7に含まれる内容の要旨
UNP ACKING AND INST ALLA TION INSTRUCTIONS 3 ELECTRICAL GROUNDING INSTRUCTIONS This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk of electric shock by providing an escape wire for the electric current. WARN
ページ8に含まれる内容の要旨
UNP ACKING AND INST ALLA TION INSTRUCTIONS 5 TOOLS RECOMMENDED FOR INSTALLATION • Phillips Screwdriver • Saw to cut exhaust opening • Scissors (if needed) • Electric Drill • Pencil • Protective Drop Cloth for product • 1/2”, 5/8” and 3/32” Drill Bits • Measure and range - you may also use • 1-1/2” Wood Bit or Metal Hole • Tape carton for protection Cutter (if metal cabinet is used) 6 INSTALLATION HARDWARE The INSTALLATION HARDWARE items 1 - 7 are in a small bag. Items 8 - " are packed separate
ページ9に含まれる内容の要旨
UNP ACKING AND INST ALLA TION INSTRUCTIONS 7 PREPARATION OF THE OVEN rs 1. Turn oven on the side. See Figure 5. 2. Follow steps (A)-(D) to remove mounting plate from the back of the oven as shown in Figure 5. re (A) Release mounting plate by pulling out the lever that is on the bottom of the oven. See Figure 6. (B) When lever is out, pull that side of the mounting plate away from the oven. See Figure 5. (C) Repeat step (A) on other side. (D) Repeat step (B) on other side. Figure 5 (A) (B) (D) (
ページ10に含まれる内容の要旨
UNP ACKING AND INST ALLA TION INSTRUCTIONS 8 VENTILATION SYSTEM (PREPARING OVEN FOR INSTALLATION) This Microwave Oven/Hood is designed for adaptation to three types of hood ventilation systems. Select the type required for your installation. Recirculating — non-vented, ductless. Follow installation procedure (A). Recirculating requires the use of the Charcoal Filter. Horizontal Exhaust — outside ventilation. Follow installation procedure (B). Vertical Exhaust — outside ventilation. Follow insta
ページ11に含まれる内容の要旨
UNP ACKING AND INST ALLA TION INSTRUCTIONS (C) VERTICAL EXHAUST: OUTSIDE VENTILATION 1. Remove and save 2 screws from back edge and 3 screws from the top center of the Fan Cover Bracket. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket as shown in Figure 11. 2. Lift Hood Fan Unit carefully and slip wires out of cavity. See Figure 12. CAUTION: Do not pull or stretch hood fan wiring. 3. Rotate the Hood Fan Unit 90˚ so that the fan blade opening
ページ12に含まれる内容の要旨
UNP ACKING AND INST ALLA TION INSTRUCTIONS 9 OVEN INSTALLATION THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUC- TIONS FOUND ON WALL AND TOP CABINET TEMPLATES. THE NEXT STEP IS TO READ AND FOLLOW MOUNTING INFORMATION ON WALL AND TOP CABINET TEMPLATES. THIS OVEN MUST BE ATTACHED TO AT LEAST ONE WALL STUD. SEE WALL CONSTRUC- TION ON PAGE 6. WHEN DONE WITH TEMPLATES, PROCEED TO MOUNTING SCALE PLATE SECTION. MOUNTING SCALE PLATE Attach 2 Scale Plates ! with tape (not
ページ13に含まれる内容の要旨
UNP ACKING AND INST ALLA TION INSTRUCTIONS 10 PREPARATION AND USE OF THE CARTON TO ASSIST IN THE INSTALLATION OF THE MICROWAVE OVEN Utilization of the carton may make installation easier. 1. Place carton upside down. See Figure 20. 2. Using cutting line around the carton, cut into two pieces (A) and (B). See Figure 21. 3. Position oven to assist in mounting to the wall. See Figure 22. Figure 20 Figure 21 (A) Top Side Cutting Line (B) Figure 22 13 R-1405/06-B318 13 7/15/02, 9:54 AM
ページ14に含まれる内容の要旨
UNP ACKING AND INST ALLA TION INSTRUCTIONS MOUNTING OVEN TO THE WALL Two people are recommended to attach the Microwave Oven/Hood to the Mounting Plate. 1. Thread the Power Supply Cord through the hole made in the bottom of the top cabinet. Install the oven by snapping it onto the Mounting Plate. See Figure 23. 2. Use two Tapping Screws 5 to secure the levers that are on the bottom of the oven. See Figure 24. 3. Use two Top Cabinet Screws 3 and two Flat Washers 6, supplied in the INSTALLATION HA
ページ15に含まれる内容の要旨
INFORMATION YOU NEED TO KNOW ABOUT YOUR OVEN This Operation Manual is valuable: read it carefully When using the oven at power levels below 100%, you and always save it for reference. may hear the magnetron cycling on and off. It is normal for the exterior of the oven to be warm to the touch A good microwave cookbook is a valuable asset. when cooking or reheating. Check it for microwave cooking principles, techniques, hints and recipes. See pages 29 and 30 for ordering the Condensation is a norm
ページ16に含まれる内容の要旨
INFORMA TION YOU NEED TO KNOW ABOUT UTENSILS AND COVERINGS It is not necessary to buy all new cookware. Many becomes very hot should not be used. pieces already in your kitchen can be used success- The following coverings are ideal: fully in your new microwave oven. Make sure the utensil does not touch the interior walls during cooking. • Paper towels are good for covering foods for re- heating and absorbing fat while cooking bacon. Use these utensils for safe microwave cooking • Wax paper can b
ページ17に含まれる内容の要旨
INFORMA TION YOU NEED TO KNOW ABOUT MICROWAVE COOKING • Arrange food carefully. Place thickest areas towards • Rearrange foods such as meatballs halfway outside of dish. through cooking both from top to bottom and from the center of the dish to the outside. • Watch cooking time. Cook for the shortest amount of time indicated and add more as needed. Food • Add standing time. Remove food from oven and severely overcooked can smoke or ignite. stir, if possible. Cover for standing time which allows
ページ18に含まれる内容の要旨
PART NAMES FRONT VIEW 10 7 2 12 8 13 9 6 1 11 4 3 5 6 BOTTOM VIEW 14 (Front of Microwave) (Rear of Microwave) 15 1 Oven door with see-through window 9 One touch DOOR OPEN button. Push to open door. Be careful with the edge of the oven door as it is glass and could chip or break. 10 Louver 2 Door hinges 11 Nameplate 3 Waveguide cover: DO NOT REMOVE. 12 Removable turntable 4 Turntable motor shaft The turntable will rotate clockwise or counterclock- wise. Only remove for cleaning. 5 Oven light 13 R
ページ19に含まれる内容の要旨
P A R T NAMES CONTROL PANEL R-1405/R-1406 Words in the lower portion of the display will light to indicate what function is in progress. Indicators 22 22-23 24 25 26 21 20 20 26 27 27 Number next to the control panel illustration indicates pages on which there are feature descriptions and usage information. 19 R-1405/06-B318 19 7/15/02, 9:55 AM
ページ20に含まれる内容の要旨
BEFORE OPERATING • Before operating your new microwave oven make sure you read and understand this operation manual completely. • Before the oven can be used, follow these procedures: 1. Plug in the oven. Close the door. The oven display will then begin flashing . 88:88 : 2. Touch the STOP/CLEAR pad. will appear. 3. Set clock. TO SET THE CLOCK This is a 12 hour clock. If you attempt to enter an • Suppose you want to enter the correct time of day incorrect clock time,
