ページ1に含まれる内容の要旨
MICROWAVE DRAWER
M Mi ic cr ro ow wav ave Dr e Drawe awer r
INSTALLATION MANUAL
SPECIAL WARNING
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL
INSPECTOR’S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CLEARANCES AND DIMENSIONS
For SAFETY CONSIDERATIONS do not install drawer in any combustible cabinetry, which is not in
accord with the stated clearances and dimensions on pages 2 and 3. See Figure
ページ2に含まれる内容の要旨
INSTALLATION MANUAL To reduce the risk of tipping, the Microwave UNPACKING YOUR MICROWAVE DRAWER Drawer must be secured by a properly installed Anti-Tip • Remove all packing block. Sealing Surface materials from inside • This Microwave Drawer must be electrically grounded in the Microwave Drawer. accordance with local codes. Waveguide DO NOT REMOVE Cover • Make sure the wall coverings and the cabinets around the THE WAVEGUIDE Microwave Drawer can withstand the heat generated by t
ページ3に含まれる内容の要旨
INSTALLATION MANUAL el ec tr i ca l outl e t 6" l oca t i o n 2x4 An ti- MICROWAVE DRAWER MEASUREMENTS Tip bloc k 3 1/ 2" 5" 4 " 14 3/ 4 " 2 8 7/ 1 6 " to bott om ope n i n g a ll o w 1 / 4 " of A nti- T ip ove rl ap a llow 3 / 4 " b loc k o v e rla p 14 3/ 4 " o pening 2 3 1/2 " a l lo w 3 / 4 " mi n d ept h ove rla p 3 6 " c ou n t er top floor mus t h e i gh t a l l ow 7 /16" s upport ove rl ap 1 00 lbs . 8 4 " w a l l c a b i n e t 19 " op t i o n a l w a l l oven c ut ou t i l lu s t ra t
ページ4に含まれる内容の要旨
INSTALLATION MANUAL DRAWER INSTALLATION ELECTRICAL OUTLET ( 6 " ) e l e c t r i c a l o u t l e t l o c a t i on 2x 4 A n t i - T i p b l o c k 5" 4 " Figure 6 Figure 5 Part s Supp lied 1. Place the drawer adjacent to the wall or The electrical requirements are a 120 volt 60 Hz, AC only, 15 cabinet opening. Plug the power supply cord amp. or more protected electrical supply. It is recommended that into the electrical outlet. a separate circuit serving only this appliance be provided.
