ページ1に含まれる内容の要旨
Built-In
Convection
use. inspector’s
REFERENCE. FUTURE FOR INSTRUCTIONS INSTALLATION KEEP
electrical local for Instructions Installation Save
UNIT. THIS INSTALL TO START YOU BEFORE INSTRUCTIONS THESE READ
reference. future
for Instructions Installation Keep Homeowner:
Homeowner.
the with Instructions Installation Leave Installer:
IMPORTANT:
L Hood
Microwave
30”
Instructions Installation
-
ページ2に含まれる内容の要旨
WAVE ....................................................................... Accessories .13 ................................................... Installation.. for List Check .13 ..................................................... Product Mounting 11 ...................................................... Plates.. Mounting 11 Installation Product .............................................................. 11 ........................................ .10 Bolts Toggle of Preparati
ページ3に含まれる内容の要旨
A for It of to on door on front of from to support of 150 of or from draft doors, for l l a on a l l l l l l l For a of of 1 system. Oven/Hood Microwave the bottom the and backsplash range the top the between necessary is space l-inch servicing, and installation proper energy. microwave excessive to exposure in result may instructed as except men microwave use to Failure made. is repair a if leakage microwave for check person repair qualified a Have . person. repair qu
ページ4に含まれる内容の要旨
WALL CONSTRUCTION l l x l l find of of -- a a to to find a 2” x 4” WOOD a to find a of 16” or 24” to of In to to of Wall for to to to 127 to support. the test cabinet top the inside pounds up weight extra Place wall. the attached securely is it ensure tested be should cabinet top The details. Template See screws. cabinet top and bolts toggle the placement the in care special use necessary be will it stud, any by supported be unable be will unit the that event the NOTE: mark.
ページ5に含まれる内容の要旨
l l l l A 15- or to or It a For a cord a cord a 1.) If a not of to a a 0 I\ l l affecW 3 shock electrical in result could so do to Failure circuit power disconnect and product this of installation the by be could that circuits electrical any Locate shock electrical in result could them with contact and covering wall the behind concealed be may wires Electrical wall. the into holes drilling when care special Ike Hazard Shock Electrical 1 Figure receptacle wall type groun
ページ6に含まれる内容の要旨
When hood to a (do not duct). hood to to a 3-l/4” If round a do not a If a or to to or to For of or 6” round not 140 WALL, to flow to a of When of of of of for flow 140 ELBOW ELBOW ELBOW ELBOW ELBOW WALL WALL 4 DAMPER. BACK-DRAFT HAVE MUST USED CAPS ROOF AND IT.) 04 CAP ROOF FT.1 (40 CAP FT.1 US 90° FT.) (5 45. FT.) (10 WIDE (r FT.1 (5 ADAPTOR FT.) (5 45’ FT.1 (10 90° ff2 DUCT EXHAUST feet. than less total should which equivalent, resistance air calculating paren
ページ7に含まれる内容の要旨
or l/2”, 5/8” 1 Wood or (if to (if for of for HARDWARE l- 8) 1 6 1 Wood 5 x 30 4 2 6 2 3 5 x 55 mm 2 4 30 mm 2 5 1 6 1 7 1 8 or on 7 0 2 0 e cord to fit. 8 0 Cut opening. power Surround cabinets. metal with se installation. depending bolts toggle screws leftover be may *There Assembly Adaptor Exhaust Grommet Hanger Cord Power Screw Decorative diameter Washer Flat Screw Cabinet Top inch* 3/l Bolt Toggle mm* Screw NAME ITEM QUANTITY I following: the co
ページ8に含まれる内容の要旨
of from 1. from for door, door or or on door. If do not IQ: cs= irs 1. Figure 0 e . . . . $7 . . . m I \ > levers Slider Hooks Upper / Plates Mounting wall. the to unit the mounting for procedure proper the of aware be will you so fevers slider the and hooks upper the of operation the with yourself Familiarize right. the to it sliding and you toward plate each pulling gently by product the of back the from plates mounting the emove R hooks. plate mounting the release
ページ9に含まれる内容の要旨
OF -- -- -- for for follow to if a If to a to or for a to 9 for 2 from fan to fan on of 2 to on 10. P 3 1. fan 3 7 Figure - - - Bracket Cover Fan / 3. Figure in shown bracket cover Remove screws. save and Remove Ventilation Outside EXHAUST: HORIZONTAL B. 2 Figure - - - Assembly Adaptor Exhaust page Cabinet Top and Wall of Preparation Proceed 2. Figure in shown as provided screws tapping the with cabinet outercase the top the cover the Adaptor Exhaust the Attach cover.
ページ10に含まれる内容の要旨
2. Withdraw hood fan 3. hood fan turn 5 4. hood fan not to hood fan 8 6 Figure (Fig.6). unit the and bracket inner the between wire lead the pinch careful Be unit. oven the into unit Replace Figure Figure5 in shown as l/4 unit Rotate 4 Figure 1. (Fig.4). carefully upward unit (Continued) EXHAUST HORIZONTAL
ページ11に含まれる内容の要旨
1 ,, .:y 2. -- .; . . . -A.,~*;-,-, .-. 5. fan fan to 3 hood fan for 7 11 for 1. 3 fan 7. 2. Withdraw hood fan 8) 3. to fan out of of to 8. 4. hood fan front of fan front of 5. hood fan not to hood fan 6. fan If not fit hood fan 3 4 7. to 3 7. 1. not for exhaust. recirculating required is assembly adaptor exhaust The NOTE: page 3, Figure in shown as screws with unit oven the cover the Attach 9 Figure again. and steps Check placed. improperly is unit the proper
ページ12に含まれる内容の要旨
WALL FOLLOW WALL WALL I 1. If not to fill for 2. Wall for of 66”from floor 30”from For of of NOW WALL from of to ofthe onto If a a do not If D not follow for E F. to to a of of of fin If do not nut not to on of a nut from 4. turn to 10 12). (Fig. tighten clockwise and you toward bolt toggle Pull bolts. toggle tightening while position in hold and carefully plates mounting the Align insertion. before position correct the in are toggles all sure make therefore hole,
ページ13に含まれる内容の要旨
5. If to of on on to to 13). to on of 11 14 Figure surface. cooking range protected the top the product the Place plates: mounting the system Oven/Hood Microwave the attach To PRODUCT MOUNTING damage. property in result could countertop or surface cooking protect to Failure cover. plastic a use Not Do oven. microwave the installing before range and countertop the over material heavy another or carton of portion a Place Hazard Damage Property (Fig. plates the assembly the secure
ページ14に含まれる内容の要旨
cord of ton I on of cord to of (In of a for cord to I of (2). a I 12 Screw Decorative 15. Figure See screwdriver. head Phillips with screw each Tighten screws decorative insert and unit the against up unit the bottom the at levers slider Raise I damage. property or injury personal in result could so do to Failure support. your remove you before secure be must unit the and engaged be must hooks upper Both Hazard Damage Property Or Injury Personal oortions. carton the Remove enla
ページ15に含まれる内容の要旨
8. (C) (D), to to If to to (for 6 9. a of cord to of cord short cord to from or from 1. to 2. from 3. cord. 4. FOR 1. to 2. from 3. cord. 4. 5. for 13 use. inspector’s electrical local the Instructions Installation these Keep Manual. Operation the Read power the in Plug oven. the material packing all Remove instructions. the according installed been has unit the sure Make INSTALLATION LIST CHECK Manual. Guide Care and Use the Read power the in Plug oven. the material
ページ16に含まれる内容の要旨
U.S.A. IN PRINTED KHMCIOGW NO. PART 4S72 I-? 4
