ページ1に含まれる内容の要旨
Owner’s Manual
DKW-3 HT
wireless VHF Microphone system
ページ2に含まれる内容の要旨
Contents Introduction ............................................................................................................................. 2 System Features ..................................................................................................................... 2 Operation ................................................................................................................................. 3 Specifications .........................................................
ページ3に含まれる内容の要旨
Operation receiver 1 1. Plug the AC/DC adapter (provided) into 3. The / ” auDIO OuTPuT JaCK (5) provides 4 the 9VDC InPuT JaCK (3) on the back of the a fixed, unbalanced MIC level audio output 1 receiver. Then plug the power supply into for connection to your mixer with the / ” 4 1 an AC outlet. Switch the POwer (1) to the to / ” cord supplied. As when making any 4 “On” position. The POwer On leD (2) will connection, make sure the mixing board’s now light and the receiver is operational. vo
ページ4に含まれる内容の要旨
Handheld Microphone Transmitter 1. Unscrew the BaTTer Y COMParTMenT 3. The microphone is now ready to use. COVer (8) and remove. Insert a fresh The corresponding rX leD (7) on the DKW-3 9V BaTTer Y (9), observing correct polarity receiver should now be lit, indicating as marked, and screw the cover back on a received signal from the transmitter. to the microphone. To ensure proper battery Adjust the VOluMe (6) control of the contact, the cover must be screwed on receiver channels you are us
ページ5に含まれる内容の要旨
Specifications OVerall sYsTeM PerFOrManCe Frequency response 80-14,000 Hz, +/-3dB Dynamic range 95dB Total Harmonic Distortion <0.7% rF Carrier Frequency range 170-216 MHz Frequency stability +/- 0.005%, crystal controlled Modulation FM (F3E), +/-15KHz max. Operating range 150 ft. typical-up to 300+ ft. line-of-sight TransMITTer audio Input Nady DM-20D unidirectional dynamic cartridge Controls Off/On switch leD Indicator unit “On” (single flash), Low Battery Alert (steady) rF Power Out 50mW (Max
ページ6に含まれる内容の要旨
Service Information In the u.s. If you are experiencing operational problems with your system, please refer to the Support page at www.nady.com for assistance. Should your wireless system require service, please contact the Nady Service Department at (510) 652-2411 to obtain a Return Authorization (R/A) Number and service quote (if out of warranty). Make sure the R/A Number is clearly marked on the outside of the package that you are returning. If your unit is out of warranty, please enclos
ページ7に含まれる内容の要旨
90-Days Limited Warranty Nady Systems, Inc. warrants to the original consumer purchaser (U.S.A. only) that the unit is free from any defects in material or workmanship for a period of 90 days from the date of original retail purchase. If any such defect is discovered within the warranty period, Nady Systems, Inc. will repair or replace the unit free of charge, subject to verification of the defect or malfunction upon return to Nady Systems. Please do not return your Nady product to the store
ページ8に含まれる内容の要旨
| 6701 Shellmound Street Emeryville, CA USA 94608 T 510.652.2411 | F 510.652.5075 | www.nady.com
