ページ1に含まれる内容の要旨
401x QUAD
4-Channel VHF Wireless Microphone System
OWNER’S MANUAL
ページ2に含まれる内容の要旨
Table of ConTenTs System Features ................................................................................................................................2 Operation: 401X QUAD Receiver.......................................................................................................3 WHT Handheld Microphone Transmitter .........................................................................5 WLT Lavalier/Lapel or Headworn Microphone ...............................................
ページ3に含まれる内容の要旨
opeRa TIon 401x QUAD Receiver 1. Powering the Receiver Plug the 16V AC/DC ADAPTER (1) provided into the DC INPUT JACK (11) on the back of the receiver. Then plug the power supply into an AC outlet. [Note: Any 16V DC source with 800mA capability can also be used.] Turn VOLUME CONTROL (6) for all four channels counterclockwise to mimimum located on the front of the receiver. Once the receiver is connected to a power source, press the POWER SWITCH (3) to ON position. The POWER ON LED (4) indica
ページ4に含まれる内容の要旨
opeRa TIon a. Instrument Connection (using the WGT instrument transmitter) Insert an audio cord with a ¼” mono phone plug in the AF OUTPUT JACK (8) on the rear panel of the receiver . Plug the other end of the cord into amplifier , effect or mixing board. Adjust the VOLUME CONTROL (6) on the 401X QUAD clockwise to about ¾ rotation until the volume level is comfortable for your application. This setting is roughly equivalent to direct instrument cord connection. Turning the volume up to
ページ5に含まれる内容の要旨
opeRa TIon WHT Handheld Microphone Transmitter 1. Unscrew the BATTERY COMPARTMENT COVER (12) and remove, exposing the BATTERY HOLDER (13). Insert a fresh 9V ALKALINE BATTERY (14), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fresh a l k a l i n e b a t t e r y c a n l a s t u p t o 1 5 h o u r s i n u s e , b u t i n o r d e r t o e n s u r e o p t i m u m p e r f o r m
ページ6に含まれる内容の要旨
opeRa TIon WLT Lavalier/Lapel or Headworn Microphone Bodypack Transmitter 1. Snap open the BATTERY COMPARTMENT (17) and insert a fresh 9V BATTERY (18), observing the correct polarity. Close the compartment. 2. The WL T is provided with a 3.5 mm LOCKING JACK (19) for connecting the microphone. Plug in either the LAVALIER/LAPEL (20) or the HEADWORN MICROPHONE (21), as supplied. To secure the c o n n e c t i o n , t u r n t h e m e t a l s l i p r i n g o n t h e p l u g c l o
ページ7に含まれる内容の要旨
opeRa TIon Opening Battery Compartment 17 18 19 24 23 22 21 17 20 Headworn Microphone 7
ページ8に含まれる内容の要旨
opeRa TIon WGT Instrument Bodypack Transmitter 1. Snap open the BATTERY COMPARTMENT (25) and insert a fresh 9V BATTERY (26), observing the correct polarity . Close the compartment. The WGT -15 is provided with a 3.5 mm LOCKING JACK (27) for connecting the INSTRUMENT CABLE (28). To secure the connection, turn the metal slip ring on the p l u g c l o c k w i s e t o t h r e a d i t o n t o t h e j a c k . T o u n p l u g , r e v e r s e t h e p r o c e s s . S l i p
ページ9に含まれる内容の要旨
opeRa TIon Opening Battery Compartment 25 26 27 31 30 29 25 28 9
ページ10に含まれる内容の要旨
speCIfICa TIons Overall SyStem PerfOrmance Frequency Response ................................................................................................... 30-18KHz (-3dB) Dynamic Range ........................................................................................................ 120dB (20-20KHz) Total Harmonic Distortion ............................................................................................. <0.5% (typical) RF Carrier Frequency Range .......................
ページ11に含まれる内容の要旨
seR vICe InfoRMa TIon In the U.S. If you are experiencing operational problems with your system, please refer to the Support page at www .nady .com for assistance. Should your wireless system require service, please contact the Nady Service Department at (510) 652-2411 for a Return Authorization (R/A) Number and service quote (if out of warranty). Make sure the R/A Number is clearly marked on the outside of the package that you are returning. If your unit is out of warranty , pl
ページ12に含まれる内容の要旨
Nady wireless microphone systems are type accepted under FCC rules parts 90, 74, and 15. This device complies with RSS-210 of Industry & Science Canada. Operation is subject to the following two conditions: (1) this device may not cause h a r m f u l i n t e r f e r e n c e a n d ( 2 ) t h i s d e v i c e m u s t a c c e p t a n y i n t e r f e r e n c e r e c e i v e d , including interference that may cause undesired operation. 6701 Shellmound Street | Emeryville,