ページ1に含まれる内容の要旨
CLASSIFICATION No. REV.
Einstufung DS-Eval4570-2400 C
SUBJECT EvalBoard PAN4570 PAGE
Thema Seite 1 of 20
CUSTOMER’S CODE
PANASONIC’S CODE DATE
EvalPAN4570 Datum 06.11.2006
Manual
Evaluation-Board for
PAN4570 Wireless Module
FIGURE 1 ISM RF TRANSCEIVER TESTBOARD WITH PAN4570 AND ANTENNA
APPROVED CHECKED DESIGNED
genehmigt geprüft Erstellt
European Technology Center
Panasonic Electronic Devices (EUROPE) GmbH
ページ2に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 2 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 TABLE OF CONTENTS 1. Overview ..............................................................................................................................3 1.1. Contents of the Evaluation Kit:.................................................................................3 1.2. Hardware needed.........
ページ3に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 3 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 1. OVERVIEW The EvalKit PAN4570 allows evaluation of the wireless module PAN4570. For a basic hardware evaluation the test software Ember Range Test Application V2.0 TM and the Ember embedded bootloader are programmed. The embedded bootloader can be used for loading other applications via the serial c
ページ4に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 4 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 Important: To install and run the programs you need Administrator rights on the test PC. Check for software updates at www.Ember.com. 2. SETTING UP THE EVALBOARD Plug a PAN4570 Carrierboard on one of the three 34-pins headers (B or C or D) as shown in Figures 1 and 2. Please take ca
ページ5に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 5 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 3. TESTBOARD LAYOUT power switch power supply inputs 7-9Vdc input buttons JP2 for connecting +5Vdc to carrierboards (not used on PAN4570 board) output RESET button LEDs BDM not used PAN4570 SMA socket Vcc voltage selector, JP4 set for 2,7Vdc 1 serial RS232 inter
ページ6に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 6 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 4. OPERATION OF THE TESTBOARD If not already done please follow the basic setting up instructions as in Chapter 2 Check if the jumper plugs are set as indicated in Figure 2. The functions of the jumpers are as follows: jumper function to set as in Figure 2 ame A Vcc for position A do not
ページ7に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 7 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 For use of the P2 2mm contacts the black socket P2-X1 is the negative/ground contact and the red socket P2-X2 is the positive terminal. A linear regulator on the testboard regulates the input voltage down to the +5V DC board supply. A second linear regulator regulates the +5V DC down to the module VCC suppl
ページ8に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 8 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 6. SERIAL PORT The evalboard is equipped with a serial port connector, which is linked to UART1 (SCI1) of EM250. The S1 switch has to be set as follows: UART1 1 2 3 4 5 6 7 8 active off off off off off off S1 ON ON settings (Table 3) 7. RESET Reset of the boards on
ページ9に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 9 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 8.2. UPLOAD OF EMBERZNET SAMPLE APPLICATIONS Insert the cd coming with this kit into the drive of your pc and navigate to the folder \software\images. Here two image files are provided for the >simple-lighting< application, simple-lighting-light.ebl and simple-lighting-switch.ebl. After launching the
ページ10に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 10 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 8.3. SELECTING THE HARDWARE PLATFORM TM TM The EmberZNet stack uses a Ember platform (Ember breakout board and RCM module), which is defined in a BOARD_HEADER file. This file is named dev0455.h and located in the folder ….\Ember\EmberZNet2.5.0\hal\micro\xap2b\em250\board\ IMPORTANT: Because t
ページ11に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 11 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 TM 8.4. EMBER INSIGHT ADAPTOR CONFIGURATION TM The Ember Insight Adaptor is used for programming and debugging of PAN4570 application software. As delivered the Adaptor is configured to support DHCP, in case your site is configured for static IP addresses the Adaptor has to be configured for static IP
ページ12に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 12 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 Connect the Ember™ Insight Adaptor to the SIF connector on the module carrierboard with the grey ribbon cable supplied with the Insight Adaptor. Please make sure that pin1 of the plug connects to pin1 of the header. 5. Connect the Ember™ Insight Adaptor via a USB cable or crossover network cable t
ページ13に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 13 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 The DOS entry window displays the progress of programming and finally displays >SUCCESS<. If not check again steps 3. to 5. 7. Remove the connection of the Insight Adaptor to the PAN4570 carrierboard. Plug the PAN4570 carrierboard to the testboard and push RESET on the testboard PAN4570 is now re
ページ14に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 14 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 9.2. DEVELOPMENT OF APPLICATIONS TM For software development the Insight Desktop , a comprehensive integrated TM development environment (IDE) and C-language compiler toolchain from Ember Inc. is TM TM required. Insight Desktop is part of Ember development kits and can currently be purchased togethe
ページ15に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 15 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 TM For more information on the items above see the website of Ember Inc. TM (www.ember.com) and the documentation included in the Ember Insight Desktop TM package as part of the Ember development kits. 9.4. TESTING FOR IEEE802.15.4 PARAMETERS TM The software on PAN4570 as delivered is the >Ember Ran
ページ16に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 16 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 10. SCHEMATIC OF THE ISM RF TRANSCEIVER TESTBOARD 10.1 SHEET 1 APPROVED CHECKED DESIGNED genehmigt geprüft Erstellt European Technology Center Panasonic Electronic Devices (EUROPE) GmbH
ページ17に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 17 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 10.2. SHEET 2 APPROVED CHECKED DESIGNED genehmigt geprüft Erstellt European Technology Center Panasonic Electronic Devices (EUROPE) GmbH
ページ18に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 18 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 10.3. PAN4570 CARRIERBOARD remarks: 1. PAN4570 is programmed per X2. 2. R1, R2 and R4 are not mounted 3. R3 is mounted as pulldown resistor at SIF_MOSI (10k typ.) X1-34 S_MOSI is connected to ground X1-33. The pulldown res. at SIF_MOSI is required for deep sleep current chars. AP
ページ19に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 19 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 11. RELATED DOCUMENTS [1] Data sheet PAN4570 DS-4570-2400-102-01 19/05/2006 TM [2] Data Sheet Ember EM250 Transceiver Version Rev. 5 TM [3] IEEE Std. 802.15.4 –2003 The following documentation can be found as part of the installed EmberZNet package: TM TM [4] Ember Developer Kit User´
ページ20に含まれる内容の要旨
CLASSIFICATION No. REV. Einstufung DS-Eval4570-2400 C SUBJECT EvalBoard PAN4570 PAGE Thema Seite 20 of 20 CUSTOMER’S CODE PANASONIC’S CODE DATE EvalPAN4570 Datum 06.11.2006 14. GENERAL INFORMATION This product description does not lodge the claim to be complete and free of mistakes. Please contact the related product manager in every case. If we deliver samples to the customer, these samples have the status Engineering Samples. This means, the design of this pro
