ページ1に含まれる内容の要旨
MODEL NO. PO17542STD
17.5 HP 42 Inch
Lawn Tractor
For Parts and Service, contact our authorized distributor: call 1-800-849-1297
For Technical Assistance: call 1-800-829-5886
192087 03.10.04 TR
PRINTED IN U.S.A.
ページ2に含まれる内容の要旨
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. Avoid starting or stopping on a slope. If tires lose trac- I. GENERAL OPERATION tion, disengage the blades and proceed slowly straight Read, understand, and follow all instructions in the down the slope. manual and on the machine before
ページ3に含まれる内容の要旨
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS Be sure the area is clear of other people before mowing. Stop WARNING: In order to prevent ac- machine if anyone enters the area. ci den tal starting when setting up, Never carry passengers or children even with the blades trans port ing, ad just ing or making re- off. pairs, alwa ys dis con nect spark plug Do not mow in reverse unless absolutely necessary. Al ways wire and place wire where it can not look down an
ページ4に含まれる内容の要旨
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu factured to giv e you the best possible dependability and performance. GASOLINE CAPACITY 1.25 GALLONS AND TYPE: UNLEADED REGULAR Should you experience any problem you cannot easily rem- edy, please contact your nearest authorized service center/ OIL TYPE (API-SF-SJ): SAE 30 (above 32°F) department. We have com pe tent, well-trained tech
ページ5に含まれる内容の要旨
CONTENTS OF HARDWARE PACK Steering Wheel Seat Steering Boot (1) Washer 17/32 x 1-3/16 x 12 Gauge Steering Wheel Steering (1) Lock Insert Extension Washer 1/2 Shaft (1) Bolt Steering Wheel Adapter (1) Oil Drain Tube (1) Locknut 1/2-20 Keys Slope Sheet (2) Keys (1) Locknut 1/4-28 (1) Large Flat Washer (1) Hex Bolt 1/4-28 x 1-1/4 5
ページ6に含まれる内容の要旨
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY INSERT A socket wrench set will make assembly easier. Stan dard wrench sizes are listed. (2) 7/16" wrenches Utility knife 1/2 HEX NUT (2) 3/4" wrench Tire
ページ7に含まれる内容の要旨
ASSEMBLY HOW TO SET UP YOUR TRACTOR SEAT PAN INSTALL SEAT (See Fig. 2) Adjust seat before tightening adjustment bolt. LABEL Remove adjustment bolt, lock washer and fl at washer se curing seat to cardboard pac king and set aside for as sem bly of seat to tractor. Pivot seat upward and remove from the cardboard pack- TERMINAL ing. Remove the cardboard packing and discard. TERMINAL Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan. 02602
ページ8に含まれる内容の要旨
ASSEMBLY CHECK TIRE PRESSURE ✓CHECKLIST The tires on your tractor were overinfl ated at the factory BEFORE YOU OPERATE AND ENJOY YOUR NEW TRAC- for shipping purposes. Correct tire pressure is important TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE for best cutting performance. BEST PER FOR MANCE AND SATISFACTION FROM THIS Reduce tire pressure to PSI shown in “PRODUCT QUALITY PROD UCT. SPEC I FI CATIONS” section of this manual. PLEASE REVIEW THE FOLLOWING CHECKLIST: ✓ All assembly in
ページ9に含まれる内容の要旨
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. IGNITION REVERSE HIGH LOW FAST SLOW NEUTRAL CHOKE P LIGHTSON ENGINEON ENGINESTART PARKINGBRAKE PARKINGBRAKE PARKINGBRAKE ENGINEOFF LOCKED UNLOCKED FUEL OILPRESSURE BATTERY REVERSE FORWARD OVERTEMP MOWERHEIGHT MOWERLIFT LIGHT 15 15 ATTACHMENT ATTACHMENT SLOPEHAZARDS CLUTCHENGAGED CLUTCHDISENGAGED DANGER,KEEPHANDS KEEPAREACLEAR ANDFEETAWAY (SEESAFETYRULESSECTION) DA
ページ10に含まれる内容の要旨
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. IGNITION LIGHT SWITCH SWITCH ATTACHMENT POSITION CLUTCH LEVER AMMETER LIFT LEVER THROTTLE/ PLUNGER CHOKE CONTROL ATTACHMENT LIFT LEVER HEIGHT CLUTCH/ ADJUSTMENT BRAKE LEVER PEDAL PARKING BRAKE GEAR SHIFT LEVER FIG. 4 Our tract
ページ11に含まれる内容の要旨
OPERATION The operation of an y tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. 00155 NOTE: Under certain conditions when tractor is standing HOW TO USE YOUR TRACTOR idle with the engine running, hot engine exhaust gases may cause “brown
ページ12に含まれる内容の要旨
01994 OPERATION TO OPERATE MOWER (See Fig. 6) TO TRANSPORT Your tractor is equipped with an operator presence sens- Raise attachment lift to highest position with at tach ment lift control. ing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged When pushing or towing your tractor, be sure gearshift will shut off the engine. You must remain fully and centrally lever is in neutral (N) position. positioned in the seat to
ページ13に含まれる内容の要旨
OPERATION MOWING TIPS CAUTION: Alcohol blended fuels (called Mower should be properly leveled for best mowing per- gas o hol or using ethanol or methanol) can at- for mance. See "TO LEVEL MOWER HOUSING" in the tract moisture which leads to sep a ra tion and forma tion of acids during storage. Acidic gas Service and Adjustments section of this manual. can damage the fuel system of an engine while The left hand side of mower should be used for trim- in storage. To avoid engine
ページ14に含まれる内容の要旨
maint_sch-tractore.new1 MAINTENANCE MAINTENANCESCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and Interlock Systems T Check for Loose Fasteners R 5 A Sharpen/Replace Mower Blades 3 C Lubrication Chart T Check Battery Level 4 0 Clean Battery and Terminals R Check Transaxle Cooling Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 Change Engine Oil (without oil filter) 1,2 E Clean Air
ページ15に含まれる内容の要旨
MAINTENANCE TRACTOR TRAILING MANDREL EDGE UP ASSEMBLY BLADE Always observe safety rules when performing any main- te nance. CENTER HOLE BRAKE OPERATION FLAT WASHER If tractor requires more than six (6) feet stopping distance LOCK WASHER at high speed in highest gear, then brake must be adjusted. STAR (See “TO ADJUST BRAKE” in the Service and Ad just ments section of this manual). BLADE BOLT TIRES Maintain proper air pressure in all tires (See “PROD UCT SPECIFICATIONS” section of this
ページ16に含まれる内容の要旨
MAINTENANCE TO CLEAN BATTERY AND TERMINALS TO CHANGE ENGINE OIL (See Figs. 10 and 11) Corrosion and dirt on the battery and terminals can cause Determine temperature range expected before oil change. the battery to “leak” power. All oil must meet API service classifi cation SF-SJ. Disconnect BLACK battery cable fi rst then RED bat- Be sure tractor is on level surface. tery cable and remove battery from tractor. Oil will drain more freely when warm. Rinse the battery with
ページ17に含まれる内容の要旨
00667 MAINTENANCE AIR FILTER IN-LINE FUEL FILTER (See Fig. 12) Your engine will not run properly using a dirty air fi lter. The fuel fi lter should be replaced once each season. If fuel Service air cleaner more often under dusty conditions. See fi lter becomes clogged, ob struct ing fuel fl ow to car bure tor, Engine Manual. re place ment is re quired. With engine cool, remove fi lter and plug fuel line sec- MUFFLER tions . Inspect and replace corroded muffl er and spark arrester
ページ18に含まれる内容の要旨
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key to “STOP” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTAN
ページ19に含まれる内容の要旨
01156 SERVICE AND ADJUSTMENTS FRONT-TO-BACK ADJUSTMENT (See Figs. 16 and 17) TO LEVEL MOWER HOUSING IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE Adjust the mower while tractor is parked on level ground FOLLOWING FRONT -TO-BACK ADJUSTMENT IS NECESSARY , or driveway. Make sure tires are properly infl ated (See BE SURE TO AD JUST BOTH FRONT LINKS EQUAL LY SO “PROD UCT SPECIFICATIONS” section of this manual). If MOWER WILL STAY LEVEL SIDE-TO-SIDE. tires are over or underinfl
ページ20に含まれる内容の要旨
02314 SERVICE AND ADJUSTMENTS TO REPLACE MOWER BLADE DRIVE BELT TO CHECK AND ADJUST BRAKE (See Fig. 18) (See Fig. 19) The mower blade drive belt may be replaced without tools. Your tractor is equipped with an ad just able brake system Park the tractor on level surface. Engage parking brake. which is mounted on the right side of the transaxle. BELT REMOVAL - If tractor requires more than fi ve (5) feet to stop at highest Remove mower from tractor (See “TO REMOVE speed in high est
