ページ1に含まれる内容の要旨
MODEL 06621213 - 16
PECO
PECO OWNERS MANUAL
FOR A JOHN DEERE 717 & 727 UNIT
MODEL #717 Z-TRAK 48” DECK &
727 Z-TRAK 54” DECK
P# Q0285
CONGRATULATIONS AND THANK YOU FOR BUYING THIS PECO LAWN VACUUM.
Your new PECO Vac has been engineered and manufactured to PECO’s high
standards for safety, quality, dependability, and ease of operations.
SAVE THIS MANUAL FOR FUTURE REFERENCE
MODEL 06621213 - 16 JOHN DEERE 717 & 727
ページ2に含まれる内容の要旨
WARRANTY PECO PECO Limited Warranty for New Products A. WHAT IS WARRANTED? B. SECURING WARRANTY F. NO REPRESENTATIONS PECO extends the following ADJUSTMENTS ADDITIONAL WARRANTIES, warranties to the original Damaged or broken parts other DISCLAIMER. purchaser of each new PECO than engines or batteries, must Neither PECO, Inc. nor any company consumer product subject to the be returned to PECO, Inc., P.O. affiliated with it makes any warranties
ページ3に含まれる内容の要旨
SAFETY PECO Outdoor Power Equipment Institute Recommendations WARNING TO PURCHASERS OF INTERNAL COMBUSTION ENGINE EQUIPPED MACHINERY OR DEVICES IN THE STATE OF CALIFORNIA: The equipment which you have purchased does not have a spark arrester muffler. If this equipment is to be used on any forest covered and brush covered land or grass covered unimproved land in the state of California, the law requires that a spark arrester muffler be installed an
ページ4に含まれる内容の要旨
PARTS LIST PECO REF. NO. PART NO. DESCRIPTION 01 E1039 BOOT (48” DECK) 1 E1113 BOOT (54” DECK) 1 02 J6006 7”-8” HOSE CLAMPS 2 03 ****** 8” x 32” LOWER HOSE 1 04 E6009 8” BLOWER CONE 1 05 A602 5.5HP/BLOWER/BLADE ASSEMBLY 1 OR A638 6HP/BLOWER/BLADE ASSEMBLY 1 06 J6011 5”-6” HOSE CLAMPS 2 07 ****** 6” x 30” UPPER HOSE 1 08
ページ5に含まれる内容の要旨
PARTS DIAGRAM PECO 06 12 08 09 15 07 13 16 14 11 04 03 10 02 01 05 MODEL 06621213 - 16 JOHN DEERE 717 & 727 PECO 5
ページ6に含まれる内容の要旨
ASSEMBLY PECO STEP 1: Place the left main frame side leg (A) onto the rear sides of the mower. Secure the left main frame side leg (A) to the rear of the mower using the mower’s preexisting bolts (B). After the left main frame side leg is secure follow the same instructions to mount the right main frame side leg. Use the picture below for more detail. A B STEP 2: Place the outer motor mount tube (A) underneath the left
ページ7に含まれる内容の要旨
ASSEMBLY PECO STEP 3: Place the top frame assembly (A) onto the left and A right main frame side legs (B). Secure the top frame assembly (A) using (4) 3/8”-16 x 1” hex bolts (PN#K1191) (2 per side) & (4) 3/8-16 flange B BOLT LEGS ON nuts (PN#K1215) (2 per side). Use the diagram to OUTSIDE OF FRAME the right for more detail. STEP 4: On the right end of the outer motor mount tube (A) slide the motor mount arm assembly (B) in.
ページ8に含まれる内容の要旨
ASSEMBLY PECO STEP 7: B The ears of the cone (A) should fit underneath the two threaded bosses on the blowerface (B). Secure A with (2) 5/16”-18 x 2” hex bolts (PN#K1159). Use the diagram to the right for more detail. TIGHTEN ALL NUTS AND BOLTS! IMPELLER BLADE REPLACEMENT TO REMOVE: First remove hex bolts from hub, then screw the bolts into threaded holes to remove old blade. (This will push impeller off the hub.) If the impelle
ページ9に含まれる内容の要旨
ASSEMBLY PECO STEP 8: Place the hose clamps over each end of the 6” hose (A). Attach one end of the hose onto the blower hous- i ing (B). Attach the free end of the hose over the inlet (C). Tighten the hose clamps. Use the picture below f for more detail. C A B STEP 9: Place the hose clamps over each end of the lower hose (D). Attach one end of the hose over the blower cone (E). Slide the free end of the hose over the boot (
ページ10に含まれる内容の要旨
MAINTENANCE PECO Your PECO Lawn Vac was designed and built to provide years of service with only minor care. Certain tasks however must be performed to keep it in good operating condition and to avoid costly repairs. This section describes and provides procedures for the necessary care of the Lawn Vac. SCHEDULED CARE CARE REQUIRED Before Each Use Check engine oil. Check all hose connections. After Each Use Clean Collector Box, hoses and engine o
ページ11に含まれる内容の要旨
TROUBLE SHOOTING PECO Diagnostic Procedures Trouble shooting procedures are provided in the chart below. To use these procedures, first locate the problem below that best describes the trouble you have encountered. Check the possible causes in the list one at a time. Correct any problems that are found and operate the
ページ12に含まれる内容の要旨
PECO P.O BOX 1197 ARDEN, NORTH CAROLINA 28704 1-800-438-5823 OR (828) 684-1234 FAX-(828) 684-0858 E-MAIL: PECO@LAWNVAC.COM MODEL 06621213 - 16 JOHN DEERE 717 & 727 PECO 12
