ページ1に含まれる内容の要旨
Zeeter HL
ZTR®
Model Year 2004
ページ2に含まれる内容の要旨
IMPORTANT - READ CAREFULLY The Dixon® ZTR® mower is both easy and fun to operate. However, any power mower must be operated properly to be safe. It is not a toy or a recreational vehicle. Before you start to use the mower, read the operator’s manual carefully and become completely familiar with the controls. The information contained in this manual applies to all Dixon® ZTR® Zeeter HL Series mowers. Your Dixon dealer will gladly answer any questions. See your dealer for warranty service, pa
ページ3に含まれる内容の要旨
INDEX Page Safety. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-12 Warranty Policy. . . . . . . . . . . . . . . . . . . . . . . . . . .13 Specifications. . . . . . . . . . . . . . . . . . . . . . . . 14-16 Controls. . . . . . . . . . . . . . . . . . . . . . . . . . . . 17-19 Operation Instructions. . . . . . . . . . . . . . . . . . 20-30 Care & Maintenance. . . . . . . . . . . . . . . . . . . .31-43 Standard Service Parts List. . . . . . . . . . . . . . . . . 44 Troubleshooting .
ページ4に含まれる内容の要旨
SAFETY RIDING LAWN MOWERS, IF IMPROPERLY OPERATED CAN CAUSE SERIOUS INJURY OR DEATH The most common causes of injury to the operator or bystander... Blade Contact Tip Over Run Over Back Over ...read and understand this manual to prevent injuries. 4
ページ5に含まれる内容の要旨
SAFETY Safety Alert Symbol When you see this symbol, BE ALERT to the potential for injury. Follow recommended safety precautions and safe operating practices. DANGER (highlighted in red) indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING (highlighted in orange) indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. CAUTION (highlighted in yellow) indicates a potentially hazardous
ページ6に含まれる内容の要旨
SAFETY Failure to observe the following safety instructions could result in serious injury or death. GENERAL OPERATION: Read, understand, and follow all instructions in the manual and on the mower before starting. Only allow responsible adults, who are familiar with the instructions, to operate the mower. Clear the area of objects such as rocks, toys, wire, etc., which could be picked up and thrown by the blade. Be sure the area is clear of other people before mowing. Stop mower if anyone enter
ページ7に含まれる内容の要旨
SAFETY GENERAL OPERATION (continued): Stop engine before removing grass catcher or unclogging chute. Mow only in daylight or good artificial light. Do not operate the mower while under the influence of alcohol or drugs. Watch for traffic when operating near or crossing roadways. Use extra care when loading or unloading the mower into a trailer or truck. Do not ride the mower when loading and unloading. Always wear safety goggles or safety glasses with side shields when operating mower. Data in
ページ8に含まれる内容の要旨
SAFETY SLOPE OPERATION: Slopes are a major factor related to loss-of-control and tip-over accidents, which can result in severe injury or death. All slopes requires extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it! DO Mow across the slope with your Dixon ZTR - never up or down. Remove obstacles such as rocks, tree limbs, etc. Watch for holes, ruts or bumps. Uneven terrain could overturn the mower. Tall grass can hide obstacles. Use slow speed. Tires ma
ページ9に含まれる内容の要旨
SAFETY SLOPE OPERATION (continued): DO (continued): Avoid starting or stopping on a slope. If tires lose traction, disengage the blades and proceed slowly down the slope. If front wheels lift off the ground, pull the levers back to stabilize the mower. DO NOT Do not turn on slopes unless necessary, and then, turn slowly and gradually downhill, if possible. Do not mow near drop-offs, ditches, or embankments. The mower could suddenly turn over if a wheel is over the edge of a cliff or ditch or if
ページ10に含まれる内容の要旨
SAFETY SERVICE: Use extra care in handling gasoline and other fuels. They are flammable and vapors are explosive. Use only an approved container. Never remove fuel cap or add fuel with engine running. Allow engine to cool before refueling. Do not smoke while refueling. Never store the mower or fuel container inside a building where there is an open flame. If fuel is spilled on clothing, change clothing immediately. To prevent fire and explosion caused by static electricity: Never fill container
ページ11に含まれる内容の要旨
SAFETY SERVICE (continued): Never run a mower inside a closed area. The exhaust fumes are toxic. Keep nuts and bolts tight, especially blade attachment bolts, and keep equipment in good condition. Never tamper with safety devices. Check their proper operation regularly. Keep mower free of grass, leaves, or other debris build-up. Clean up oil or fuel spillage. Allow mower to cool before storing. Stop and inspect the equipment if you strike an object. Repair, if necessary, before restarting. Neve
ページ12に含まれる内容の要旨
SAFETY CHILDREN: Tragic accidents can occur if the operator is not alert to the presence of children. Children are attracted to lawn mowers and the mowing activity. NEVER assume children will stay where they were last seen. Be alert to avoid accidents. Keep children out of the mowing area and under the watchful care of another responsible adult. Be alert and turn mower off if a child enters the area. Before and during backing look BEHIND and DOWN for small children. Never carry children. They
ページ13に含まれる内容の要旨
DIXON LIMITED WARRANTY POLICY RESIDENTIAL HYDRO DIXON ZTR MOWERS ARE WARRANTED AGAINST DEFECTS IN MATERIALS AND WORKMANSHIP AND PROVIDES FOR REPLACEMENT OR REPAIR OF PARTS INCLUDING LABOR COSTS. THIS WARRANTY IS SUBJECT TO THE FOLLOWING CONDITIONS AND LIMITATIONS. 1. Home Owner Application: Dixon ZTR Residential Hydro units used only at owner’s primary place of residence are warranted for a period of two (2) years from date of purchase. Frame, body panels and fenders are warranted for the lif
ページ14に含まれる内容の要旨
SPECIFICATIONS ZEETER HL 30” CHASSIS: 11 gauge welded channel frame BODY: All body parts made of rotational molded polyethylene. Front body contains access panel for battery service. MOWER DECK: 11 GA stamped steel construction. Single 30” cut blade. Cut height approximately 1-1/2”- 4” via 7-position lift handle. BLADE DRIVE: Mechanical; hand lever engagement TRANSMISSION: Each rear wheel is independently driven by a Hydro Gear EZT self contained hydrostatic drive. ENGINE: 11 HP Briggs & Stratto
ページ15に含まれる内容の要旨
SPECIFICATIONS ZEETER HL 36” CHASSIS: 11 gauge welded channel frame BODY: All body parts made of rotational molded polyethylene. Front body contains access panel for battery service. MOWER DECK: 11 GA laser cut fabricated. Two blades, 36” cut width. Cut height approximately 1-1/2”- 4” via 7-position lift handle. BLADE DRIVE: Electric clutch TRANSMISSION: Each rear wheel is independently driven by a Hydro Gear EZT self contained hydrostatic drive. ENGINE: 13 HP Briggs & Stratton I/C, 4-cycle, sin
ページ16に含まれる内容の要旨
SPECIFICATIONS ZEETER HL 42” CHASSIS: 11 gauge welded channel frame BODY: All body parts made of rotational molded polyethylene. Front body contains access panel for battery service. MOWER DECK: 13 GA stamped steel construction. Three blades, 42” cut width. Cut height approximately 1-1/2”- 4” via 7-position lift handle. BLADE DRIVE: Electric clutch TRANSMISSION: Each rear wheel is independently driven by a Hydro Gear EZT self contained hydrostatic drive. ENGINE: 14.5 HP Briggs & Stratton I/C, 4-
ページ17に含まれる内容の要旨
CONTROLS CONTROL LEVERS Note: For access to the seat, move control levers to neutral position and swing them outward. TO GO FORWARD •From neutral position, gently push control levers forward. To increase speed, move levers further forward. TO GO BACKWARDS From neutral position, gently pull control levers toward you. TURNING Turning is controlled by moving one control lever slightly forward or rearward of the other. To turn left, move left lever rearward of the right lever. To turn rig
ページ18に含まれる内容の要旨
CONTROLS The Dixon ZEETER HL has a hydrostatic drive that requires only two drive levers to control braking, turning, speed and direction. On initial operation, set throttle speed on slow. Operate with mower blade in “OFF” position. To avoid “over-controlling” the mower, use a light touch on the drive levers. Slight movements using fingertip control is all that is necessary. PARKING BRAKE: The parking brake is designed to hold the mower from moving and is not intended for use in stop- ping th
ページ19に含まれる内容の要旨
CONTROLS TRANSMISSION DRIVE SYSTEM Allows the mower to turn on its own axis “ZERO TURNING RADIUS”. Each lever controls one side of the mower. NOTE: The pressure required to operate the mower is very light. BLADE DRIVE (30”): Located to left of the operator. To engage the mower blade, turn lever on floor slowly to the “ON” position. To disengage mower blade, turn lever to the “OFF” position. 30” BLADE DRIVE (36” & 42”): Located on the control panel, operator’s right. To engage the mowe
ページ20に含まれる内容の要旨
OPERATION INSTRUCTIONS The safe and successful operation of the ZEETER HL Mower will depend upon the operator having the correct knowledge of all controls used on the mower and making good judgements about the terrain to be mowed. NEVER allow anyone to operate the mower without complete knowledge of all controls and their functions. During initial operation, “learning to drive”, set throttle at slow speed. Sound judgement by the operator will prevent accidents. TOWING: Towing a trailer or other
