ページ1に含まれる内容の要旨
Operating & Maintenance
Instructions
Model Series
Covered in
This Manual
91200
92200
94200
Model Type Code
Note: General Model Series numbers noted above include many specific numbers
Month Day Year
like the ones on your engine. To get replacement parts or technical assistance in
the future, write your engine Model, Type, Code and date of purchase here.
TABLE OF CONTENTS
WARNING
Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-5
Briggs & Stratton does not approve or aut
ページ2に含まれる内容の要旨
THE POWER IN POWER EQUIPMENT Thank you for selecting a Briggs & Stratton engine to power your equipment. Briggs & Stratton is committed to producing a line of engines which will make your life’s chores easier to perform. We have, at the same time, improved the design of our engines so they are environmentally friendly. Since 1995, we have succeeded in reducing smog-forming exhaust emissions from our engines by 70%. Briggs & Stratton’s efforts have not stopped there. We are also committed to des
ページ3に含まれる内容の要旨
274778 BEFORE OPERATING ENGINE • Read entire Operating & Maintenance Instructions AND the instructions for the equipment this engine powers.* • Failure to follow instructions could result in serious injury or death. THE OPERATING & MAINTENANCE INSTRUCTIONS CONTAIN SAFETY INFORMATION TO • Make you aware of hazards associated with engines • Inform you of the risk of injury associated with those hazards, and • Tell you how to avoid or reduce the risk of injury. The safety alert symbol ( ) is used t
ページ4に含まれる内容の要旨
SAFETY WARNING WARNING Gasoline and its vapors are extremely flammable Unintentional sparking can result in fire or electric and explosive. shock. Fire or explosion can cause severe burns or death. Unintentional start-up can result in entanglement, traumatic amputation, or laceration. WHEN ADDING FUEL BEFORE PERFORMING ADJUSTMENTS OR • Turn engine OFF and let engine cool at least 2 REPAIRS minutes before removing gas cap. • Fill fuel tank outdoors or in well-ventilated area. • Disconnect spark p
ページ5に含まれる内容の要旨
SAFETY WARNING WARNING Engines give off carbon monoxide, an odorless, Rotating parts can contact or entangle hands, feet, colorless, poison gas. hair, clothing, or accessories. Breathing carbon monoxide can cause nausea, Traumatic amputation or severe laceration can fainting or death. result. • Start and run engine outdoors. • Operate equipment with guards in place. • Do not start or run engine in enclosed area, even if • Keep hands and feet away from rotating parts. doors or windows are open. •
ページ6に含まれる内容の要旨
ENGINE PARTS 6 7 5 8 4 9 14 3 13 10 12 11 1 2 8. Stop switch (if equipped) 9. Engine Model Type Code 1. Blower housing xxxxx xxxx xx xxxxxxxx 2. Finger guard/ 10. Oil level Rotating screen 11. Oil fill cap 3. Rope handle 12. Oil drain plug 4. Fuel fill 13. Muffler/(Muffler guard, if equipped)/ 5. Control levers (Spark arrester, if equipped) 6. Air cleaner 14. Carburetor 7. Spark plug wire GENERAL INFORMATION THE INTERNATIONAL SYMBOLS USED ENGINE MODEL ON THE ENGINE OR IN THIS MANUAL INCLUDE: Thi
ページ7に含まれる内容の要旨
274778 OIL SAE Viscosity Grades CAUTION: This engine is shipped from Briggs & Stratton without oil. Check oil level before starting engine. If you start the engine without oil, the engine ** will be damaged beyond repair and will not be * covered under warranty. Note: If this engine is equipped with gear reduction, gear reduction case must be filled with oil prior to operating en- -20 0 20 32 40 60 80 100 °F gine. See gear reduction oil filling instructions on page 12. -30 -20 -10 0 10 20 30 40
ページ8に含まれる内容の要旨
FUEL TYPE OF FUEL TO USE •Use clean, fresh, regular unleaded gasoline with a minimum of 77 octane. Fresh fuel prevents gum from forming in the fuel system or on essential carburetor parts. Purchase fuel in quantity that can be used within 30 days. • Do not use gasoline which contains Methanol. • Do not mix oil with gasoline. • For engine protection use Briggs & Stratton Gasoline Additive available from your Authorized Briggs & Stratton Dealer (P/N 5041 or single use pouch). • This engine is cert
ページ9に含まれる内容の要旨
STARTING WARNING • Do not use pressurized starting fluids. • Vapors are flammable. STARTING AND OPERATING TIPS ♦Store and fuel equipment in level position. ♦Periodically remove any debris buildup from the machine (See Maintenance.) ♦Use fresh fuel. (See Fuel.) ♦After engine has started, let it warm up several ♦Use correct type of oil for expected starting seconds to several minutes, depending on outside temperature. (See Oil.) temperature. ♦Remove external equipment/engine loads. (See ♦For maxim
ページ10に含まれる内容の要旨
STARTING AND STOPPING REWIND (MANUAL) STARTER TO START ENGINE Throttle OIL LEVEL Choke Throttle [2] Move throttle (if equipped) to FAST. Operate engine with throttle in FAST. [1] Check oil level (see p. 8). [3] Move choke control lever to CHOKE. [6] Let engine warm up. Choke Equipped: Move ON choke control lever toward RUN a short dis- OFF tance at a time over sev- eral seconds in warm weather or minutes in cold WARNING weather. Let engine run Stop Switch smoothly before each change. Operate wit
ページ11に含まれる内容の要旨
MAINTENANCE MAINTENANCE EMISSION CONTROL Regular maintenance will improve the performance and Maintenance, replacement or repair of the emission extend the life of the engine. See any Authorized Briggs & control devices and systems may be performed by any Stratton Dealer for service. Use only genuine Briggs & nonroad engine repair establishment or individual. Stratton parts. Other parts may not perform as well, However, to obtain no charge repairs under the terms and may damage the engine, and m
ページ12に含まれる内容の要旨
MAINTENANCE CHANGING OIL IN GEAR REDUCTION (if REMOVING AND RE-INSTALLING AIR CLEANER equipped) [1] Loosen screws and remove cover. Change oil in gear reduction after every 100 hours of operation. [2] Remove pre-cleaner (if equipped) and cartridge carefully to prevent debris from entering carburetor. OIL FILLER PLUG [3] Re-install clean (or new) air cleaner assembly in base. VENT HOLE [4] Replace cover and tighten screws. 4 GEAR CASE CLEANING PRE-CLEANER AND CARTRIDGE COVER SCREWS CAUTION: Do no
ページ13に含まれる内容の要旨
MAINTENANCE ENGINE AND ENGINE PARTS We recommend that you see an authorized Briggs & Stratton Service Dealer for all maintenance and service of the engine and engine parts. Use only genuine Briggs & Stratton parts. If you perform any maintenance on the engine, first disconnect the spark plug wire from the spark plug, and disconnect the battery at the negative terminal (electric WARNING starter engines only) to prevent unintentional sparking. Unintentional sparking can result in fire or electric
ページ14に含まれる内容の要旨
ADJUSTMENTS THROTTLE ADJUSTMENT CARBURETOR ADJUSTMENT If the engine does not start or if it runs roughly, the remote throttle control may need adjustment. See your authorized Briggs & Stratton dealer or follow the instructions below. WARNING The manufacturer of the equipment on which this WARNING engine is installed specifies top speed at which the engine will be operated. DO NOT EXCEED this speed. Air cleaner and air cleaner cover must be assembled to carburetor before starting engine. (Air cle
ページ15に含まれる内容の要旨
SERVICE & STORAGE An illustrated shop manual includes PARTIAL LIST OF GENUINE BRIGGS & common specifications and detailed in- STRATTON PARTS formation covering adjustment, tune-up BRIGGS & STRATTON and repair of Briggs & Stratton single cylinder, L-head, 4 cycle engines. It is PART PART NO. (or equivalent) available for purchase from an Autho- Flat air cleaner cartridge 491588 (5043) rized Briggs & Stratton Service Dealer or Flat air cleaner pre-cleaner 491435 you can order it from the factory.
ページ16に含まれる内容の要旨
SERVICE & STORAGE [2] While engine is still warm, change oil. STORAGE Engines stored over 30 days need special attention. [3] Remove spark plug and pour about 1/2 oz. (15 ml) of [1] To prevent gum from forming in fuel system or on engine oil into cylinder. Replace spark plug and crank essential carburetor parts: slowly to distribute oil. a) if fuel tank contains oxygenated or reformulated gasoline (gasoline blended with an alcohol or an [4] Clean engine of surface debris, chaff or grass. ether),
ページ17に含まれる内容の要旨
Briggs & Stratton Corporation (B&S), the California Air Resources Board (CARB) and the United States Environmental Protection Agency (U.S. EPA) Emission Control System Warranty Statement (Owner’s Defect Warranty Rights and Obligations) EMISSION CONTROL WARRANTY COVERAGE IS APPLICABLE TO CERTIFIED MODEL YEAR 1997 AND LATER ENGINES TO CERTIFIED ENGINES PURCHASED IN CALIFORNIA IN 1995 WHICH ARE PURCHASED AND USED ELSEWHERE IN THE AND THEREAFTER,
ページ18に含まれる内容の要旨
About your engine warranty: (see next page for statement of LIMITED WARRANTY). Briggs & Stratton welcomes warranty repair and apologizes 4. Parts which are scored or broken because an engine was to you for being inconvenienced. Any Authorized Service operated with insufficient or contaminated lubricating oil, Dealer may perform warranty repairs. Most warranty repairs or an incorrect grade of lubricating oil (check oil level daily are handled routinely, but sometimes requests for warranty or afte
ページ19に含まれる内容の要旨
BRIGGS & STRATTON ENGINE OWNER WARRANTY POLICY effective July 1, 1999 Replaces all undated Warranties and all Warranties dated before July 1, 1999 LIMITED WARRANTY “Briggs & Stratton Corporation will repair or replace, free of charge, any part, or parts of the engine that are defective in material or workmanship or both. Transportation charges on parts submitted for repair or replacement under this Warranty must be borne by purchaser. This warranty is effective for the time periods and subject t
ページ20に含まれる内容の要旨
!
"
# $%& !
%
%
'
% ! " #$%%! %% & !' , - ' # # $ # # 0 %# ) ( # $ #
