ページ1に含まれる内容の要旨
Operator’s Manual
22” Rotary Mowers
Model 084
IMPORTANT: Read safety rules and instructions carefully before operating equipment.
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-
covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective workin
ページ2に含まれる内容の要旨
TABLE OF CONTENTS Content Page Important Safe Operation Practices.....................................................................3 Slope Gauge........................................................................................................6 Assembling Your Lawn Mower ............................................................................7 Know Your Lawn Mower......................................................................................9 Operating Your Lawn Mower ........
ページ3に含まれる内容の要旨
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol - heed its warning. WARNING: Engine Exhaust, some of its constituents, and certain vehicle componen
ページ4に含まれる内容の要旨
12. Shut the engine off and wait until the blade comes to a 4. Use extreme care when approaching blind corners, complete stop before removing the grass catcher or doorways, shrubs, trees, or other objects that may unclogging the chute. The cutting blade continues to obscure your vision of a child who may run into the rotate for a few seconds after the engine is shut off. Never mower. place any part of the body in the blade area until you are 5. Keep children away from hot or running engines.
ページ5に含まれる内容の要旨
for damage (e.g., bent, cracked, worn) Replace blade replace immediately with original equipment with the original equipment manufacture’s (O.E.M.) blade manufacturer’s (O.E.M.) parts only, listed in this manual. only, listed in this manual. “Use of parts which do not “Use of parts which do not meet the original equipment meet the original equipment specifications may lead to specifications may lead to improper performance and improper performance and compromise safety!” compromise safety!”
ページ6に含まれる内容の要旨
FOLD ON DOTTED LINE, REPRESENTING A 15° SLOPE SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE A POWER POLE A CORNER OF A BUILDING OR A FENCE POST 15° WARNING Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). A riding mower could overturn and cause serious injury. If operating a walk-behind mower on such a slope, it is extremely difficult to maintain your footing and you could slip, resulting in serious injury. Operate RIDING mowers u
ページ7に含まれる内容の要旨
SECTION 3: ASSEMBLING YOUR LAWN MOWER Tighten the wing nuts at the end of the lower handle Removing Unit From Carton to secure the handle to handle bracket assemblies. Remove staples, break glue, or cut tape at carton See Figure 3. end and peel along top flap to open carton. Remove loose parts if included with unit (i.e., Lower operator’s manual, etc.) Handle Carefully cut along corners, lay carton down flat, Wing and remove packing material. Nuts Roll or slide unit out of carto
ページ8に含まれる内容の要旨
NOTE: Install bottom lip inside chute opening Removing Chute Retainer (indicated by 1 in the figure below) before placing hooks For shipping purposes, the chute deflector on your over the hinge pin (indicated by 2 in the figure below). mower is held in an upright position by a retainer . Remove the retainer, by following the steps below, Hinge before running the mower for the first time. Pin Push the chute deflector up and towards the engine. Holding the deflector in this position, remo
ページ9に含まれる内容の要旨
SECTION 4: KNOW YOUR LAWN MOWER Read this operator’s manual and safety rules before operating your lawn mower. Compare the illustration in Blade Control Figure 8 with your lawn mower to familiarize yourself Handle with the location of various controls and adjustments. Save this manual for future reference. NOTE: The shroud shown here may not resemble the shroud WARNING: The operation of any lawn on your mower. mower can result in foreign objects being thrown into the eyes, which can damag
ページ10に含まれる内容の要旨
Before Starting Mower Using Your Lawn Mower Attach spark plug wire to spark plug. Make certain WARNING: If you strike a foreign object, the metal cap on the end of the spark plug wire stop the engine. Remove wire from the spark (inside the rubber boot) is fastened securely over plug, thoroughly inspect the mower for any the metal tip on the spark plug. damage, and repair the damage before restarting and operating the mower. Extensive Starting Engine vibration of the mower during operat
ページ11に含まれる内容の要旨
Handle Height Your mower is shipped with the handle in the higher Lower height position. For convenience of operating, you may Handle lower the handle height as follows: Wing Nuts Remove the starter rope from the rope guide. Disconnect the lower handle from the handle bracket assemblies by removing the wing nuts. See Figure 10. Position each handle bracket assembly stud into the top hole in the lower handle. Handle NOTE: Each end of the lower handle must be placed in Bracket same rela
ページ12に含まれる内容の要旨
Disconnect spark plug wire. Turn mower on its side making sure that the air filter Drain the gasoline from the lawn mower, or place a and the carburetor are up. piece of plastic under the gas cap. Remove the bolt and the blade bell support which Tip the mower so that it rests on the housing. Keep hold the blade and the blade adapter to the engine the side with the air cleaner facing up. Hold the crankshaft. See Figure 12. mower firmly. Remove blade and adapter from the crankshaft.
ページ13に含まれる内容の要旨
SECTION 8: STORING YOUR LAWN MOWER The following steps should be taken to prepare your Coat mower’s cutting blade with chassis grease to lawn mower for storage. prevent rusting. Store mower in a dry, clean area. Do not store next Clean and lubricate mower thoroughly as described to corrosive materials, such as fertilizer. in the lubrication instructions. NOTE: When storing any type of power equipment in a IMPORTANT: We do not recommend the use of a poorly ventilated or metal storage s
ページ14に含まれる内容の要旨
SECTION 10: PARTS LIST FOR MODEL 084 1 2 39 5 3 4 8 9 6 7 6 12 11 13 15 14 16 17 18 25 27 19 24 10 43 42 44 18 21 23 19 17 22 35 28 36 43 37 29 42 21 30 34 23 44 31 32 40 33 14
ページ15に含まれる内容の要旨
Model 084 Ref. Ref. Part No. Part Description Part No. Part Description No. No. 1. 747-1161A Blade Control Handle 22. 738-1173 Shoulder Screw 2. 749-1092A Upper Handle 23. 736-0741 Bell Washer .760 ID x 1.25 OD 3. 720-0279 Wing Nut 24. 734-1987 Rear Wheel 8 x 1.8 4. 710-1205 Eye Bolt 25. 710-0514 Hex Cap Screw 3/8-16 x 1.0 5. 710-1174 Carriage Bolt 5/16-18 x 2.0 27. 736-0270 Bell Washer .265 ID x .75 OD 6. 720-0284 Wing Nut 28. 738-1172 Shoulder Screw 7. 736-0451 Shoulder Washer .320 ID x .9
ページ16に含まれる内容の要旨
MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Troy-Bilt LLC d. Troy-Bilt LLC does not extend any warranty for with respect to new merchandise purchased and used in the products sold or exported outside of the United States, United States, its possessions and territories. its possessions and territories, except those sold through Troy-Bilt LLC’s authorized channels of export Troy-Bilt LLC warrants this product against defects for a distribution. period
