ページ1に含まれる内容の要旨
BOOM ARM MOWER
Published 07/06 (Rev 02-20-07) Part No. 02984405
ASSEMBLY MANUAL
(STANDARD INSTRUCTIONS)
Tractors equipped with additional options, special equipment, tractor manufacturer modi-
fications, new tractor models, or Customer alterations may prevent this Mount Kit from
being properly mounted to the tractor. Alamo Group is not responsible for modifications to
the MountKit to accommodate these differences.
NOTE: This manual i
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
ページ4に含まれる内容の要旨
TO THE OWNER/OPERATOR/DEALER All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safety equipment properly attached to minimize the chance of accidents. BEFORE YOU START!! Read the safety messages on the implement and shown in your manual. Observe the rules of safety and common sens
ページ5に含まれる内容の要旨
NOTES Axtreme Boom General Assembly (02-06) (Rev 02-20-07) © 2006 Alamo Group Inc.
ページ6に含まれる内容の要旨
INTRODUCTION ABOUT THIS MANUAL: The intent of this publications to provide the competent technician with the information necessary to assemble the Alamo Industrial Product. This will, in turn provide for complete customer satisfaction. This manual is designed to be used as a basic component guide. The assembly drawings shipped with the unit will be used as to the assembly of components that are specific to a particular tractor model, these assembly drawings should always be kept with the other p
ページ7に含まれる内容の要旨
INDEX Section Page Index.......................................................................................................................... Index-1 to Index 2 Section 1 Safety Instructions.............................................................................. 1-1 to 1-6 Section 2 Model Specifications...........................................................................2-1 to 2-6 Section 3 Tractor Preperations.....................................................................
ページ8に含まれる内容の要旨
ページ9に含まれる内容の要旨
Section 1 Axtreme Boom SAFETY SECTION Axtreme Boom (Asy. Man.) 07/06 Section 1 - 1 © 2006Alamo Group Inc.
ページ10に含まれる内容の要旨
Safety Section Read these assembly instructions through completely and understand them before proceeding with the assembly of the equipement. A safe and careful operator is the best operator. Safety is of primary importance to the manufacturer and should be to the owner/operator. Most accidents can be avoided by being aware of your equipment, your surroundings, and observing certain precautions. The first section of this manual includes a list of Safety Messages that, if followed, will he
ページ11に含まれる内容の要旨
Safety Section PELIGRO! Si no lee Ingles, pida ayuda a alguien que si lo lea para que le traduzca las medidas de seguridad. (SG-3) !LEA EL INSTRUCTIVO! READ, UNDERSTAND, and FOLLOW the following Safety Messages. Serious injury or death may occur unless care is taken to follow the warnings and instructions stated in the Safety Messages. Always use good common sense to avoid hazards. (SG-2) PELIGRO! Si no lee Ingles, pida ayuda a alguien que LEA EL si lo lea para que le traduzca las me
ページ12に含まれる内容の要旨
Safety Section WARNING! Many of the parts are heavy and require lifting assistance. Do not try to lift the heavy parts by yourself. Get help from another employee or from an overhead crane. WARNING! The operator and all support personnel should wear hard hats, safety shoes, safety glasses, and proper hearing protection at all times for protection from injury including injury from items thrown by the equipment. (SG-16) WARNING! Always wear safety shoes with steel toes when working on this equipm
ページ13に含まれる内容の要旨
Safety Section DANGER! Before starting the mower make sure the area is clear and the floor has been swept. The mower blade can throw objects several hundred feet. Thrown objects could damge property or cause severe bodily injuries even death. WARNING! Make certain that the “Slow Moving Vehicle” (SMV) sign is installed in such a way as to be clearly visible and legible. When transporting the Equipment use the Tractor flashing warning lights and follow all local traffic regulations. (SG-6) DANGER
ページ14に含まれる内容の要旨
Safety Section DANGER! NEVER use drugs or alcohol immediately before or while operating the Tractor and Implement. Drugs and alcohol will affect an operator’s alertness and coordination and therefore affect the operator’s ability to operate the equipment safely. Before operating the Tractor or Imple- ment, an operator on prescription or over-the-counter medication must consult a medical professional regarding any side effects of the medi- cation that would hinder their ability to operate the
ページ15に含まれる内容の要旨
Section 2 Axtreme Boom Model Specifications Axtreme Boom - Asy Man (07/06) Section 2 - 1 © 2006 Alamo Industrial
ページ16に含まれる内容の要旨
SPECIFICATIONS - AXTREME BOOM READ THIS BEFORE BEGINNING ASSEMBLY: The Axtreme Boom has electronic components:. The electronic components can be damaged if care is not taken when performing repairs, testing and/or during assembly. DO NOT 1. DO NOT short any wires across or allow them to be shorted out. 2. DO NOT attempt to jump across any wires or supply them with alternate power source. 3. DO NOT install higher rated fuses than are recommended by manufacturer. 4. DO NOT do any welding on unit
ページ17に含まれる内容の要旨
SPECIFICATIONS - AXTREME BOOM 2. Fifty Inch (50") Cutting Head Specifications: Blade / Motor Rotation (Looking down from Top of Deck)...............Clockwise Blade Tip Speed........................................................................18,850 FPM / 210 MPH Blade carrier Type..................................................................... Pan or 3 Leaf bar Option Blade Pan Blade Qty.................................................................2 Blade or 3 Blade Option Blade Bar
ページ18に含まれる内容の要旨
SPECIFICATIONS - AXTREME BOOM 5. Control Valve: 5 Spool used with Rotary Heads w/ Door Valve Type................................................................................Open Center 5 Spool Valve Control (Manual Standard)................................................. Remote Cable Control Valve Control (Electonic Joystick Optional)..................................Joystick Electronic Control Pressure (Maximum)................................................................. 3500 PSI
ページ19に含まれる内容の要旨
SPECIFICATIONS - AXTREME BOOM Joystick Electronic Controled Valve (Optional) A A A A A "A" Port Side Pressure Supply (Port P1) 1234567 1234567 1234567 1234567 1234567 12 12 12 12 3 12 12 12 1 1 2 2 2 12 12 12 12 12 123 12 1 2 3 123 4 "B" Port Side B Return (Port T2) B B B B Note: Hose Colored Bands, Bands with stripes go to Cylinder Base. Solid Figure 2 color bands go to Cylinder rod end. 7. Valve Sections Function: Mechanical Control Vale (See Figure 1) Spool Cylinder Function Pres
ページ20に含まれる内容の要旨
SPECIFICATIONS - AXTREME BOOM 8. Hose End Fitting Torque Specification: Hose End Type: 37 Degree Angle End Steel Hose End Fittings* Dash Nominal Cyl. Torque Torque Size Size (in.) in. lbs. ft .lbs. -4 1/4" 140 12 -6 3/8" 230 19 -8 1/2" 450 38 -10 5/8" 650 54 -12 3/4" 900 75 -16 1" 1200 100 -20 1-1/4" 1600 133 -24 1-1/2" 2000 167 -32 2" 2800 233 * Straight Threads do not always seal better when higher torgues are used. Too much torque causes distortion and may lead to leakage. DO NOT
