ページ1に含まれる内容の要旨
OWNER'S MANUAL
MODEL NO. WE13T38D
13.0 HP 38 Inch
Lawn Tractor
For Parts and Service, contact our authorized distributor: call 1-800-849-1297
For Technical Assistance: call 1-800-829-5886
®
178078 1.10.01 RD
PRINTED IN U.S.A.
ページ2に含まれる内容の要旨
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. I. GENERAL OPERATION DO NOT: • Read, understand, and follow all instructions in the • Do not turn on slopes unless necessary, and then, turn manual and on the machine before starting. slowly and gradually downhill, if possible. • Only allow responsible
ページ3に含まれる内容の要旨
SAFETY RULES Safe Operation Practices for Ride-On Mowers • Check brake operation frequently. Adjust and service as required. CAUTION: Do not coast down a hill in • Be sure the area is clear of other people before mowing. neutral, you may lose control of the Stop machine if anyone enters the area. tractor. • Never carry passengers or children even with the blades off. • Do not mow in reverse unless absolutely necessary. CAUTION: Tow only the attachments Always look down and behind before and
ページ4に含まれる内容の要旨
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES • Read and observe the safety rules. GASOLINE CAPACITY 1.25 GALLONS AND TYPE: UNLEADED REGULAR • Follow a regular schedule in maintaining, caring for and using your tractor. OIL TYPE (API-SF-SJ): SAE 30 (above 32°F) • Follow the instructions under “Customer Responsibili- SAE 5W-30 (below 32°F) ties” and “Storage” sections of this owner’s manual. OIL CAPACITY: 2 PINTS CONGRATULATIONS on your purchase of a new tractor. It has been designed, engine
ページ5に含まれる内容の要旨
UNASSEMBLED PARTS Steering Wheel Seat Steering Wheel Adapter Steering (1) Washer Extension 17/32 x 1-3/16 x 12 Gauge Shaft Steering Wheel (1) Lock Insert Washer 1/2 (1) Bolt Steering (1) Lockwasher 3/8 Boot (1) Locknut 5/16-18 (1) Large Flat Washer (1) Oil Drain Tube (1) Hex Bolt For Future Use 3/8-16 x 1 Keys Slope Sheet (2) Keys (1) Hex Bolt 5/16-18 x 1-1/4 5
ページ6に含まれる内容の要旨
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Standard INSERT wrench sizes are listed. 3/8 HEX BOLT (2) 1/2" wrenches Pliers 3/8 LOCK WASHER (1) 9/16" wrench
ページ7に含まれる内容の要旨
ASSEMBLY HOW TO SET UP YOUR TRACTOR SEAT CHECK BATTERY (See Fig. 2) • Lift seat pan to raised position and open battery box door. • If this battery is put into service after month and year indicated on label (label located between terminals) SEAT PAN charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in CUSTOMER RESPONSIBILITIES section of this manual for charging instructions). SHOULDER BOLT SEAT PAN LABEL BATTERY FLAT WASHER BOX DOOR LOCK WASHER TERMINAL TERMINAL ADJUSTMENT BO
ページ8に含まれる内容の要旨
ASSEMBLY TO DRIVE TRACTOR OFF SKID (See Opera- 3 CHECKLIST tion section, page 10, for location and func- BEFORE YOU OPERATE AND ENJOY YOUR NEW TRAC- tion of controls) TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PERFORMANCE AND SATISFACTION FROM THIS WARNING: Before starting, read, understand and follow QUALITY PRODUCT. all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in PLEASE REVIEW THE FOLLOWING CHECKLIST: front of t
ページ9に含まれる内容の要旨
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. BATTERY CAUTION OR REVERSE FORWARD FAST SLOW WARNING LIGHTS ON OVER TEMP ENGINE ON ENGINE OFF OIL PRESSURE LIGHT PARKING BRAKE UNLOCKED MOWER LIFT FUEL CHOKE MOWER HEIGHT LOCKED P ATTACHMENT REVERSE NEUTRAL HIGH LOW PARKING BRAKE CLUTCH ENGAGED 15 15 15 KEEP AREA CLEAR SLOPE HAZARDS ATTACHMENT (SEE SAFETY RULES SECTION) CLUTCH DISENGAGED IGNITION FREE WHEEL DANG
ページ10に含まれる内容の要旨
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. IGNITION ATTACHMENT LIGHT SWITCH SWITCH CLUTCH LEVER LIFT LEVER PLUNGER THROTTLE/CHOKE ATTACHMENT CONTROL LIFT LEVER CLUTCH/BRAKE PEDAL MOWER DECK HEIGHT ADJUSTMENT POSITIONS GEARSHIFT LEVER PARKING BRAKE FIG. 4 Our tractors conform to
ページ11に含まれる内容の要旨
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses. IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY HOW TO USE YOUR TRACTOR POSITION OTHER THAN "OFF" WILL CAUSE THE BATTERY TO BE DISCHARGED, (DEAD). TO SET PARKING BRAKE (See
ページ12に含まれる内容の要旨
OPERATION TO OPERATE MOWER (See Fig. 6) TO TRANSPORT • Raise attachment lift to highest position with attachment Your tractor is equipped with an operator presence sensing lift control. switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will • When pushing or towing your tractor, be sure gearshift shut off the engine. lever is in neutral (N) position. • Select desired height of cut. • Do not push or tow tractor at more than five (5)
ページ13に含まれる内容の要旨
OPERATION TO START ENGINE (See Fig. 5) MOWING TIPS • Tire chains cannot be used when the mower housing is When starting the engine for the first time or if the engine has attached to tractor. run out of fuel, it will take extra cranking time to move fuel • Mower should be properly leveled for best mowing from the tank to the engine. performance. See “TO LEVEL MOWER HOUSING” in • Sit on seat in operating position, depress clutch/brake the Service and Adjustments section of this manual. pedal and
ページ14に含まれる内容の要旨
CUSTOMER RESPONSIBILITIES MAINTENANCE SCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and Interlock Systems T Check for Loose Fasteners R 7 A Sharpen/Replace Mower Blades 4 C Lubrication Chart T Check Battery Level 6 0 Clean Battery and Terminals R Check Transaxle Cooling Adjust Blade Belt(s) Tension 5 Adjust Motion Drive Belt(s) Tension 5 Check Engine Oil Level Change Engine Oil 1 1,2,3 Clean Air Filter 2 E C
ページ15に含まれる内容の要旨
CUSTOMER RESPONSIBILITIES TRACTOR MANDREL ASSEMBLY Always observe safety rules when performing any mainte- TRAILING nance. EDGE UP CENTER HOLE BRAKE OPERATION If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted. LOCK WASHER (See “TO ADJUST BRAKE” in the Service and Adjustments section of this manual). STAR TIRES FLAT WASHER • Maintain proper air pressure in all tires (See “PRODUCT HEX BOLT (GRADE 8)* BLADE SPECIFICATIONS” sectio
ページ16に含まれる内容の要旨
CUSTOMER RESPONSIBILITIES TO CLEAN BATTERY AND TERMINALS • After oil has drained completely, close and lock the drain Corrosion and dirt on the battery and terminals can cause the valve by pushing inward and turning clockwise until the battery to “leak” power. pin is in the locked position as shown. • Open battery box door. • Remove the drain tube and replace the cap onto to the • Disconnect BLACK battery cable first then RED battery bottom fitting of the drain valve. cable and remove battery
ページ17に含まれる内容の要旨
CUSTOMER RESPONSIBILITIES CLEANING We do not recommend using a garden hose to clean your tractor unless the electrical system, muffler, air filter and • Clean engine, battery, seat, finish, etc. of all foreign carburetor are covered to keep water out. Water in engine matter. can result in a shortened engine life. • Keep finished surfaces and wheels free of all gasoline, oil, etc. • Protect painted surfaces with automotive type wax. CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: Depre
ページ18に含まれる内容の要旨
SERVICE AND ADJUSTMENTS • When distance “D” is 1/8" to 1/2" lower at front than rear, TO LEVEL MOWER HOUSING tighten nuts “F” against trunnion on both front links. Adjust the mower while tractor is parked on level ground or • To raise front of mower, loosen nut “F” from trunnion on driveway. Make sure tires are properly inflated (See “PROD- both front links. Tighten nut “E” on both front links an UCT SPECIFICATIONS” section of this manual). If tires are equal number of turns. over or underinf
ページ19に含まれる内容の要旨
SERVICE AND ADJUSTMENTS TO ADJUST BRAKE (See Fig. 19) TO ADJUST STEERING WHEEL ALIGNMENT Your tractor is equipped with an adjustable brake system If steering wheel crossbars are not horizontal (left to right) which is mounted on the right side of the transaxle. when wheels are positioned straight forward, remove steer- If tractor requires more than six (6) feet stopping distance at ing wheel and reassemble per instructions in the Assembly high speed in highest gear on a level dry concrete or pa
ページ20に含まれる内容の要旨
SERVICE AND ADJUSTMENTS TO ATTACH JUMPER CABLES - • Connect each end of the RED cable to the POSITIVE (+) SEAT PAN terminal of each battery, taking care not to short against chassis. • Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery. BATTERY BOX DOOR • Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery. TO REMOVE CABLES, REVERSE ORDER - • BLACK cable first from chassis and then from the fully charged battery.
