Snapper Mの取扱説明書

ページ1に含まれる内容の要旨

DEALER SET-UP INSTRUCTIONS for EUROPEAN SNAPPER
21” STEEL DECK “M” MODEL WALK BEHIND MOWERS

This SNAPPER Walk Behind Mower uses a handle engine control bail system to kill the engine for the SAFETY of
the operator. These mowers are designed for quick set-up. The checklist on Page 4 should be filled out by the
dealer as the items are checked off and/or performed and the Consumer/Operator Product Registration card filled
out and sent to the Customer Service department at SNAPPER when comp

ページ2に含まれる内容の要旨

STEP 5: Handle height is adjustable for different height of STEP 6: Set-up is now complete for push models operators. Loosen the two nuts on the inside of each of without self-propelled drive system. For self-propelled the lower handles. See Figure 4. Move the handle up or models continue to the “Self-Propelled Models” Section. down to the desired height. See Figure 5. Retighten all Proceed to the pre-sale checklist page of this instruction nuts securely after adjustment. Pull blade control

ページ3に含まれる内容の要旨

STEP 8: Driven disc to drive disc adjustment is set up at C. Slide driven disc assembly over until 1/8” from the factory. In case driven disc may need adjustment, outside edge of drive disc. Maintaining the 1/8” proceed as follows: measurement, remove any looseness from the linkage. This can be done by holding the transfer rod and A. Place speed control rod in the number six speed applying pressure to the left (as viewed from operators position. See Figure 7. position), then retighten the

ページ4に含まれる内容の要旨

DEALER PRE SALE CHECKLIST for SNAPPER 21” STEEL DECK “M” MODEL WALK BEHIND MOWERS The following must be accomplished prior to sale. Refer to the previous pages in this instruction for detailed set-up instructions. Review this checklist with purchaser. Check (✓ ) items actually performed and signed on checklist. SET-UP CHECKLIST _____ FOAM SHIPPING BLOCK removed from cutting blade. _____ UPPER HANDLE & LOWER HANDLE secured in place and hardware tightened securely. _____ SIDE CHUTE, R