Snapper 7-4375の取扱説明書

ページ1に含まれる内容の要旨

DEALER SET-UP INSTRUCTIONS & PRE-SALE CHECKLIST for
EUROPEAN SNAPPER LT SERIES TRACTORS

INTRODUCTION: Snapper LT (One Piece Frame) Tractors are shipped with the steering wheel and seat
cushions removed. The following steps are required for set-up. Complete all items on the Dealer Pre-Sale
Checklist at time of purchase.

NOTE: Figure 1 shows the seat assembled to the seat

pedestal assembly. Some models are shipped
SEAT KNOB


with the seat loose and will require installation.

ページ2に含まれる内容の要旨

4. With cell caps removed, connect battery charger to Step 5: REDUCE TIRE PRESSURE battery terminals; RED to positive (+) and BLACK to 1. The tires are over-inflated for shipping. Reduce tire negative (-) terminal. pressure in front tires to 12 PSI and in rear tires to 12 5. If time allows, slow charge at 1 amp for 10 hours, or PSI. as an alternative, fast charge at not more than 2.5 amps for 4 hours to bring the battery to full charge. STEP 6: INSTALL OPERATOR’S SEAT NOTE: Slo

ページ3に含まれる内容の要旨

Step 7: CHECK INTERLOCK SYSTEM HINGE PLATE The interlock system includes a seat switch, a clutch switch and a mower blade (PTO) switch. The system INSERT HAIR PIN INTO HINGE ROD functions in the following way: BETWEEN HINGE PLATE AND SEAT A. ENGINE MUST NOT START IF: PEDESTAL. 1. The blade lever is in the ON position. 2. Clutch pedal is not completely depressed. 3. Operator is not seated on tractor. B. ENGINE MUST START ONLY WHEN: SEAT PEDESTAL 1. Blade lever is shifted

ページ4に含まれる内容の要旨

DEALER PRE-SALE CHECKLIST The following must be accomplished prior sale. Refer to pages 1 - 3 for detailed set-up instructions. Review this list with purchaser. Check (✓ ) items actually performed and signed on this page. CUTTING BLADE & MOWER _____ BLADE RETAINING hardware checked for proper tightness. _____ BLADE TIP CLEARANCE inside lower edge of mower checked and corrected as needed. _____ MOWER CUTTING HEIGHT settings checked and adjusted as needed (with tires properly inflated)