ページ1に含まれる内容の要旨
IMPORTANT MANUAL DO NOT THROW AWAY
5000
OPERATOR'S MANUAL
WARNING:
MODEL:
Read this Man u al and follow all Warnings
and Safety Instructions. Fail ure to do so
can re sult in serious in ju ry.
PXT12538
LAWN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
Visit our website: www.poulan-pro.com
431147 10.26.09 SR Printed in the U.S.A.
ページ2に含まれる内容の要旨
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Slow down before turning. WARNING: In order to prevent ac ci den tal • Never leave a running machine unattended. Always starting when setting up, trans port ing, turn off blades, set parking brake, stop engine, and ad just ing or making repairs,
ページ3に含まれる内容の要旨
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN Tragic accidents can occur if the operator is not alert to GENERAL SERVICE the presence of children. Children are often attracted to • Never operate machine in a closed area. the ma chine and the mowing activity. Never assume that • Keep all nuts and bolts tight to be sure the equipment children will remain where you last saw them. is in safe working condition. • Keep children out of the mowing area and in the watchful
ページ4に含まれる内容の要旨
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu fac tured to give GASOLINE CAPACITY 1.50 GALLONS you the best possible dependability and performance. AND TYPE: UNLEADED REGULAR Should you experience any problem you cannot easily remedy, please contact your nearest authorized service OIL TYPE (API: SF-SJ): SAE 30 (above 32°F) center/department. We have com pe tent, well-trained tech ni- SAE 5W-30 (below 32°F) cian
ページ5に含まれる内容の要旨
UNASSEMBLED PARTS Steering (1) Bolt Steering Wheel Insert Steering Wheel Steering Extension (1) Large Flat Washer Shaft Steering Boot Steering Wheel (1) Lock Washer Adapter Seat (1) Lock Washer (1) Large Flat Washer (1) Seat (1) Bolt Keys Slope Sheet (1) Oil Drain Tube For Future Use Key(s) 5
ページ6に含まれる内容の要旨
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TO INSTALL STEERING WHEEL (See Fig. 2) TOOLS REQUIRED FOR ASSEMBLY ASSEMBLE EXTENSION SHAFT AND BOOT A socket wrench set will make assembly easier. Stan dard wrench sizes are listed. •
ページ7に含まれる内容の要旨
ASSEMBLY INSTALL SEAT (See Fig. 3) CHECK TIRE PRESSURE Adjust seat before tightening adjustment bolt. The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important • Remove adjustment bolt, lock washer and flat washer for best cutting performance. se cur ing seat to cardboard packing and set aside for as sem bly of seat to tractor. • Reduce tire pressure to PSI shown on tires. • Pivot seat upward and remove from the cardboard pack- CHEC
ページ8に含まれる内容の要旨
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. REVERSE HIGH LOW FAST SLOW NEUTRAL CHOKE IGNITION SWITCH P ENGINE START ENGINE OFF REVERSE ENGINE ON PARKING BRAKE PARKING BRAKE PARKING BRAKE OPERATION LOCKED UNLOCKED SYSTEM (ROS) LIGHTS ON BATTERY FUEL REVERSE FORWARD MOWER HEIGHT MOWER LIFT 15 15 ATTACHMENT ATTACHMENT BRAKE/CLUTCH SLOPE HAZARDS CLUTCH ENGAGED KEEP AREA CLEAR CLUTCH DISENGAGED PEDAL (SEE SAFET
ページ9に含まれる内容の要旨
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. ATTACHMENT ROS "ON" IGNITION CLUTCH LEVER POSITION SWITCH LIFT LEVER PLUNGER LIGHT SWITCH ATTACHMENT THROTTLE/CHOKE LIFT LEVER CONTROL CLUTCH/BRAKE PEDAL PARKING BRAKE GEAR SHIFT LEVER 02829 FIG. 4 Our tractors conform to the ap
ページ10に含まれる内容の要旨
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. NOTE: Under certain conditions when tractor is standing HOW TO USE YOUR TRACTOR idle with the engine running, hot engine exhaust gases may cause “brown ing”
ページ11に含まれる内容の要旨
OPERATION TO OPERATE MOWER (See Fig. 6) REVERSE OPERATION SYSTEM (ROS) (See Fig. 7) Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with Your tractor is equipped with a Reverse Operation System the engine running and the attachment clutch engaged (ROS). Any attempt by the operator to travel in the reverse will shut off the engine. You must remain fully and centrally direction with the attachment clutch engaged will shut off
ページ12に含まれる内容の要旨
OPERATION COLD WEATHER STARTING ( 50°F/10°C and below) ADD GASOLINE • When engine starts, allow engine to run with the throttle • Fill fuel tank to bottom of filler neck. Do not overfill. Use control in the choke ( ) position until the engine runs fresh, clean, regular un lead ed gasoline with a minimum roughly, then move throttle control to fast position. This of 87 octane. (Use of leaded gasoline will increase may require an engine warm-up period from several sec- carbon and lead oxi
ページ13に含まれる内容の要旨
maint_sch-tractore.ROS.e MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1
ページ14に含まれる内容の要旨
MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be kept sharp. Re place Always observe safety rules when per form ing any bent or damaged blades. main te nance. CAUTION: Use only a replacement blade ap- BRAKE OPERATION proved by the manufacturer of your tractor. If tractor requires more than five (5) feet to stop at highest Using a blade not approved by the manu- speed in high est gear on a level, dry concrete or paved facturer of your tractor is hazardous, could surface
ページ15に含まれる内容の要旨
MAINTENANCE V-BELTS Check V-belts for deterioration and wear after 100 hours OIL DRAIN HOLE of operation and replace if necessary. The belts are not ad just able. Re place belts if they begin to slip from wear. OIL DRAIN TRANSAXLE MAINTENANCE PLUG Keep transaxle free from build-up of dirt and chaff which can restrict cooling. Do not attempt to clean transaxle while engine is running or while the transaxle is hot. To prevent pos si ble damage to seals, do not use high pressure water or ste
ページ16に含まれる内容の要旨
00667 MAINTENANCE ENGINE COOLING SYSTEM (See Fig. 12) Debris may clog the engine's air cooling system. Remove blower housing and clean the area shown to prevent over- heating and engine damage. CLEAN OUT CHAFF AND DEBRIS AIR SCREEN 02744 Fig. 12 MUFFLER Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or damage. SPARK PLUGS Replace spark plugs at the beginning of each mowing sea- son or after every 100 hours of use, whichever comes
ページ17に含まれる内容の要旨
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: • Depress clutch/brake pedal fully and set parking brake. • Place gearshift lever in neutral position. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TO REMOVE MOWER (Se
ページ18に含まれる内容の要旨
SERVICE AND ADJUSTMENTS BOTH FRONT LINKS MUST BE EQUAL IN LENGTH SIDE-TO-SIDE ADJUSTMENT (See Figs. 15 and 16) • Raise mower to its highest position. • At the midpoint of both sides of mower, measure height from bot tom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other. • If adjustment is necessary, make adjustment on one NUT “F” NUT “E” side of mower only. • To raise one side of mower, tighten lift link ad just ment TRUNNION nut
ページ19に含まれる内容の要旨
SERVICE AND ADJUSTMENTS 2. Place gear shift lever in neutral (N) position. NOTE: If additional clearance is needed to get to ad just ment The rear wheels must lock and skid when you try to manually bolt, move mower deck height to the lowest position. push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center. GEARSHIFT NEUTRAL LEVER LOCK TO REPLACE MOTION DRIVE BEL T(See Fig. 20) GATE Park the tractor on level surface. En
ページ20に含まれる内容の要旨
SERVICE AND ADJUSTMENTS If “jumper ca bles” are used for emer gen cy starting, use the NUT TERMINAL BOLT following pro ce dure: COVER IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 POSITIVE VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO NEGATIVE (RED) START OTHER VEHICLES. (BLACK) CABLE 02603 CABLE TO ATTACH JUMPER CABLES - • Connect one end of the RED cable to the POSITIVE FIG. 25 (+) terminal of each battery(A-B), taking care not to
