ページ1に含まれる内容の要旨
IMPORTANT MANUAL DO NOT THROW AWAY
03076
OPERATOR'S MANUAL
WARNING:
Read this Man u al and follow all Warnings
and Safety Instructions. Fail ure to do so
MODEL:
can re sult in serious in ju ry.
PPH23B48
LAWN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
Visit our website: www.poulan-pro.com
427118 02.06.09 SR Printed in the U.S.A.
ページ2に含まれる内容の要旨
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Slow down before turning. WARNING: In order to prevent ac ci den tal • Never leave a running machine unattended. Always starting when setting up, trans port ing, turn off blades, set parking brake, stop engine, and ad just ing or making repairs,
ページ3に含まれる内容の要旨
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN Tragic accidents can occur if the operator is not alert to • If fuel is spilled on clothing, change clothing im- the presence of children. Children are often attracted mediately. to the ma chine and the mowing activity. Never assume • Never overfill fuel tank. Replace gas cap and tighten that children will remain where you last saw them. securely. • Keep children out of the mowing area and in the GENERAL SERVICE watchful
ページ4に含まれる内容の要旨
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES • Read and observe the safety rules. Gasoline Capacity 3 Gallons • Follow a regular schedule in maintaining, caring for and type: Unleaded Regular and using your tractor. Oil Type (API-SG-SL): SAE 30 (above 32°F) • Follow the instructions under “Maintenance” and “Stor- SAE 5W-30 (below 32°F) age” sec tions of this own er’s manual. Oil Capacity: W/ Filter: 64 oz W/O Filter: 60 oz. WARNING: This tractor is equipped with an internal co
ページ5に含まれる内容の要旨
UNASSEMBLED PARTS Slope Sheet Key (1) Oil Drain Tube (2) Keys ASSEMBLY Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. TO CHECK BATTERY (See Fig. 2) TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard • Lift hood to raised position. wrench sizes are listed. NOTE: If this battery is put into service after month and (1) 1/2" wrench Tire pressure gauge year indicated on label (label is
ページ6に含まれる内容の要旨
ASSEMBLY CHECK TIRE PRESSURE ✓CHECKLIST The tires on your tractor were overinflated at the factory BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE for shipping purposes. Correct tire pressure is important WISH TO ASSURE THAT YOU RECEIVE THE BEST for best cutting performance. PERFORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT. • Reduce tire pressure to PSI shown on tires. PLEASE REVIEW THE FOLLOWING CHECKLIST: CHECK DECK LEVELNESS ✓ All assembly instructions have been com plet ed. For best cu
ページ7に含まれる内容の要旨
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF REVERSE OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON BATTERY CRUISE CONTROL FUEL REVERSE FORWARD PEDAL 15 15 ATTACHMENT DANGER, KEEP HANDS ATTACHMENT SLOPE HAZARDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAF
ページ8に含まれる内容の要旨
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. G E H P D B F C J A K M L Fig. 3 Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER - Used to raise and lower (H) LIGHT SWITCH - Turns the headlights on an
ページ9に含まれる内容の要旨
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any ad just ments or repairs. We rec om mend standard safety glasses or a wide vision safety mask worn over spectacles. NOTE: Failure to move throttle control between half and full HOW TO USE YOUR TRAC TOR speed (fast) position, before stop ping may cause engine to “backfi
ページ10に含まれる内容の要旨
OPERATION • The average lawn should be cut to approximately 2-1/2 TO MOVE FORWARD AND BACKWARD inches during the cool season and to over 3 inches (See Fig. 7) during hot months. For healthier and better looking The direction and speed of movement is controlled by the lawns, mow often and after moderate growth. forward and reverse drive pedals. • For best cutting performance, grass over 6 inches • Start tractor and release parking brake. in height should be mowed twice. Make the first cut
ページ11に含まれる内容の要旨
OPERATION TO OPERATE MOWER TO OPERATE ON HILLS Your tractor is equipped with an operator presence sensing CAUTION: Do not drive up or down hills switch. Any attempt by the operator to leave the seat with with slopes greater than 15° and do not the engine running and the attachment clutch engaged will drive across any slope. shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitat- ing or cutting off when operating your equipment o
ページ12に含まれる内容の要旨
OPERATION TO START ENGINE (See Fig. 3) BEFORE STARTING THE ENGINE When starting the engine for the first time or if the engine CHECK ENGINE OIL LEVEL has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine. The engine in your tractor has been shipped, from the factory, already filled with sum mer weight oil. • Be sure freewheel control is in the transmission en gaged position. • Check engine oil with tractor on level ground. • Sit on seat in operati
ページ13に含まれる内容の要旨
OPERATION PURGE TRANSMISSION MOWING TIPS • Tire chains cannot be used when the mower hous ing CAUTION: Never engage or disengage is attached to tractor. freewheel lever while the engine is run ning. • Mower should be properly leveled for best mowing performance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual. To ensure proper operation and performance, it is rec om- mend ed that the transmission be purged before operating • The left hand side of mower s
ページ14に含まれる内容の要旨
maint_sch-tractore.ROS.e MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1
ページ15に含まれる内容の要旨
MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be kept sharp. Re place Always observe safety rules when per form ing any bent or damaged blades. main te nance. CAUTION: Use only a replacement blade ap- BRAKE OPERATION proved by the manufacturer of your tractor. If tractor requires more than five (5) feet to stop at highest Using a blade not approved by the manu- speed in high est gear on a level, dry concrete or paved facturer of your tractor is hazardous, could surface
ページ16に含まれる内容の要旨
MAINTENANCE DECK WASHOUT PORT (See Fig. 16) V-BELTS Your tractor’s deck is equipped with a washout port on Check V-belts for deterioration and wear after 100 hours its surface as part of its deck wash system. It should be of operation and replace if necessary. The belts are not utilized after each use. ad just able. Re place belts if they begin to slip from wear. 1. Drive the tractor to a level, clear spot on your lawn, near TRANSAXLE MAINTENANCE enough to a water spigot for your garden hose
ページ17に含まれる内容の要旨
00667 MAINTENANCE TO CHANGE ENGINE OIL (See Fig. 17) CLEAN AIR SCREEN Determine temperature range expected before oil change. Air screen must be kept free of dirt and chaff to prevent engine dam age from overheating. Clean with a wire brush or All oil must meet API service classification C. compressed air to re move dirt and stubborn dried gum fibers. • Be sure tractor is on level surface. • Oil will drain more freely when warm. AIR FILTER • Catch oil in a suitable container. Your engine w
ページ18に含まれる内容の要旨
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TO REMOVE MOWER (See Fig. 19) TO INSTALL MOWER (See Figs. 20-28) • Pl
ページ19に含まれる内容の要旨
SERVICE AND ADJUSTMENTS NOTE: Be sure mower side suspension arms (A) are pointing - Pivot bar towards you and insert other end of bar forward before sliding mower under tractor. into hole in rear mower bracket (D). Move mower as needed to insert bar. • Slide mower under tractor until it is centered under tractor. - Secure with washer and retainer spring as shown D A 02996 Fig. 23 02965 • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside Fig.
ページ20に含まれる内容の要旨
SERVICE AND ADJUSTMENTS • Turn steering wheel to position wheels straight forward. • Install belt onto engine clutch pulley (M). • ATTACH FRONT LINK (E) - Work from left side of trac- M tor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F) and secure with retainer spring (G) through hole in link located behind the bracket. • Insert other end of link (E) into hole in front mower bracket (H) and secure with washer and retainer spring (J). • Disengage b
