ページ1に含まれる内容の要旨
Use & Care Guide
Wine Cooler
Guia de Uso y Cuidado
Refrigerador de Vinos
Guide D’utilisation et D’entretien
Refroidisseur à Vin
241957000 May 2008
ページ2に含まれる内容の要旨
Finding Information 2 Product Registration Card Please Read and Save This The package containing this manual also includes Guide your product registration information. Warranty Thank you for choosing Electrolux, the new coverage begins at the time your Electrolux wine premium brand in home appliances. This Use & cooler was purchased. Care Guide is part of our commitment to customer satisfaction and product quality throughout the NOTE service life of your new wine cooler. Register
ページ3に含まれる内容の要旨
Finding Information 3 Table of Contents Finding Information ................................................................................. 2 Please Read and Save This Guide ......................................................................................2 Make a Record for Quick Reference ...................................................................................2 Product Registration Card ...........................................................................................
ページ4に含まれる内容の要旨
Safety 4 Important Safety Instructions WARNING Safety Precautions • Ne ver attempt to repair or perf orm Do not attempt to install or operate your unit maintenance on the unit until the electricity until you have read the safety precautions in this has been disconnected. manual. Safety items throughout this manual are • Altering, cutting of po wer cor d, remo v al of labeled with a Danger, Warning or Caution based power cord, removal of power plug, or direct on the risk type.
ページ5に含まれる内容の要旨
Installation 5 Installing the Wine Cooler Your Electrolux wine cooler has been designed for either free-standing or built-in installation. When built- in, your wine cooler does not require additional air space for top, sides or rear. In either case, the front grille must NOT be obstructed. NOTE To ease unit installation and removal, it is recommended that the cabinet rough opening dimensions be increased by at least ¼ inch over the dimensions given for your unit. NOTE All units
ページ6に含まれる内容の要旨
Installation 6 NOTE All units require zero clearance when installed flush with a cabinet or wall. Electrolux ICON Pro stainless 11 16 steel models require a minimum 2 / inch handle clearance when installed against a wall or cabinet that extends beyond the front edge of the unit. ICON Pro Unit Dimensions Width Height Depth 13 1 23 /16 inch 34-35 inches 26 /5 inch ICON Pro Product Dimensions
ページ7に含まれる内容の要旨
Installation 7 6 Wipe out inside of unit with a damp cloth. Site Preparation 7 Be sure to install the Anti-Tip bracket. Follow 1 Position the unit on a flat, level surface the instructions provided with the Anti-Tip capable of supporting the entire weight of the bracket kit. unit. Remember the unit will be significantly heavier once it is fully loaded. 2 This unit requires a grounded and polarized WARNING 115 VAC, 60Hz, 15A circuit (normal The Anti-Tip Kit m ust be installed
ページ8に含まれる内容の要旨
Leveling 8 Leveling the Unit Position the unit on a flat, level surface capable of supporting the entire weight of the unit when full. This unit contains four (4) adjustable leveling legs. Turn the legs clockwise to raise and counterclockwise to lower.
ページ9に含まれる内容の要旨
Door Reversal 9 4 Remove upper right-hand (RH) hinge bracket Reversing the Door by loosening four (4) screws. Be careful This model comes equipped with a RH-swing door. to support the door while loosening and To convert the unit to a LH-swing door (as shown removing the upper hinge bracket. in the Use & Care Guide), certain components must be obtained before beginning the conversion. These components are available from your local dealer or by calling Electrolux. Order Part Number:
ページ10に含まれる内容の要旨
Door Reversal 10 6 Remove access cover by removing two (2) 9 Install metal left-hand (LH) door stop by screws. installing screw. 7 Shift door harness from one side to the other. 10 Install plastic LH door stop by installing Replace access cover. screw. 11 Remove lower RH door hinge by removing two (2) screws. Remove P-clamp and install in LH side. 12 Install lower LH door closer in lower LH door hinge by installing screw. 13 Install lower LH door hinge by installing two (2) screws
ページ11に含まれる内容の要旨
Door Reversal 11 14 Remove button plug from upper left side of 15 Install upper LH hinge bracket by installing door and place in upper right side of door. four (4) screws. Place door on lower LH hinge bracket. If door does not close properly after reversing, the following actions may be taken: Remove Button Plug a) Loosen lower hinge screws and align From Left Side And door. Retighten screws. Install On Right Side b) Loosen upper hinge screws and align door. Retighten screws. c)
ページ12に含まれる内容の要旨
Door Reversal 12 17 Reattach toe grille by installing two (2) screws. 18 Reapply power.
ページ13に含まれる内容の要旨
Star t-Up and T emperature Contr ol 13 Starting the Unit Your wine cooler is shipped in the ON position; however, you may turn it ON or OFF by pressing and holding the ON/OFF for three (3) seconds and then releasing the key. Adjusting the Temperature To accurately check the temperature, insert a reliable thermometer into a plastic (non-breakable) bottle, partially filled with water. Tighten the bottle cap securely. Place the bottle in the desired area for 24 hours. Refrain from opening the
ページ14に含まれる内容の要旨
Operation 14 Description of Features Alarms door ajar If the door has been left open for five (5) minutes, vacation mode Conserves energy by disabling interior an audible alarm will sound and the door ajar lights and keypad inputs. indicator will illuminate on the right side of the mute sounds Tones emitted by each keypress can be display. The mute sounds indicator will blink. turned off based on user preference. The Pressing the mute sounds key or closing the sounds are muted when th
ページ15に含まれる内容の要旨
Storage 15 Proper Storage The wine cooler will accommodate 48 bottles (750 ml size). There are five (5) upper racks that will hold eight (8) bottles each and two lower racks that will hold four (4) bottles each. Specially designed wine racks allow for proper horizontal storage of the wine. The cork remains moist which keeps air from entering the bottle. Stocking Recommendations The wine racks allow for the proper horizontal stor- age of wine. The bottles are properly positioned so that t
ページ16に含まれる内容の要旨
Maintenance 16 Interior Cleaning - as Required Maintaining Your Wine Cooler 1 Disconnect power to the wine cooler. Periodic cleaning and proper maintenance will ensure efficiency, top performance, and long 2 Remove racks if desired, see “WINE RACK life. The maintenance intervals listed are based REMO V AL/INST ALLA TION” below. on normal conditions. You may want to shorten 3 Wipe down the interior with a solution of non- the intervals if you have pets or other special abrasive mild deter
ページ17に含まれる内容の要旨
Troubleshooting 17 Before You Call for Service If Service is Required If the unit appears to be malfunctioning, read Contact the dealer where you purchased the unit through this manual first. If the problem persists, if service is required. State the model and serial check the Troubleshooting Guide below. Locate number and explain the problem. The model and the problem in the guide and refer to the cause serial number plate is located on the ceiling of your and its remedy before calling for
ページ18に含まれる内容の要旨
Warranty Information 18 Warranty 26 REFRIGERATOR WARRANTY Your refrigerator is protected by this warranty WARRANTY THROUGH OUR AUTHORIZED SERVICERS, THE CONSUMER WILL BE PERIOD WE WILL: RESPONSIBLE FOR: FULL ONE- One year from Pay all costs for repairing or replacing any parts of Costs of service calls that are listed under original this appliance which prove to be defective in NORMAL RESPONSIBILITIES OF THE YEAR purchase date. materials or workmanship. Excludes original and CONSUM
