ページ1に含まれる内容の要旨
03131
M13538
Operator's Manual
532 43 45-03
ページ2に含まれる内容の要旨
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate the machine while under the influence WARNING: In order to prevent ac ci den tal of alcohol or drugs. starting when setting up, trans port ing, • Watch for traffic when operating near or crossing ad just ing or making repairs, al wa
ページ3に含まれる内容の要旨
SAFETY RULES Safe Operation Practices for Ride-On Mowers GENERAL SERVICE III. CHILDREN • Never operate machine in a closed area. Tragic accidents can occur if the operator is not alert to • Keep all nuts and bolts tight to be sure the equipment the presence of children. Children are often attracted to is in safe working condition. the ma chine and the mowing activity. Never assume that • Never tamper with safety devices. Check their proper children will remain where you last saw them. ope
ページ4に含まれる内容の要旨
PRODUCT SPECIFICATIONS CONGRATULATIONS on your purchase of a new tractor. It has been designed, engineered and manu fac tured to give Gasoline Capacity 1.50 Gallons you the best possible dependability and performance. and Type: Unleaded Regular Should you experience any problem you cannot easily Oil Type (API-SG-SL): SAE 30 (above 32°F/0°C) remedy, please contact your nearest authorized service SAE 5W-30 (below 32°F/0°C) center/department. We have com pe tent, well-trained tech ni -
ページ5に含まれる内容の要旨
UNASSEMBLED PARTS Steering Wheel (1) Lock Washer Steering (1) Large Wheel Insert Flat Washer Steering Wheel (1) Hex Bolt Steering Steering Wheel Extension Adapter Shaft Steering Boot Seat (1) Washer (1) Knob (1) Seat Slope Sheet Key(s) 5
ページ6に含まれる内容の要旨
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TO INSTALL STEERING WHEEL (See Fig. 2) TOOLS REQUIRED FOR ASSEMBLY ASSEMBLE EXTENSION SHAFT AND BOOT A socket wrench set will make assembly easier. Stan dard wrench sizes are listed. •
ページ7に含まれる内容の要旨
ASSEMBLY INSTALL SEAT (See Fig. 3) CHECK TIRE PRESSURE Adjust seat before tightening adjustment knob. The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important • Remove adjustment knob and flat washer securing for best cutting performance. seat to cardboard packing and set aside for assembly • Reduce tire pressure to PSI shown on tires. of seat to tractor. • Pivot seat upward and remove from the cardboard pack- CHECK DECK LEVELNESS i
ページ8に含まれる内容の要旨
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH REVERSE ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON FUEL BATTERY REVERSE FORWARD CRUISE CONTROL PEDAL 15 15 ATTACHMENT ATTACHMENT DANGER, KEEP HANDS KEEP AREA CLEAR SLOPE HAZARDS CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAFET
ページ9に含まれる内容の要旨
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. H E D B G F A C J Fig. 4 Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER - Used to raise, lower, (E) ATTACHMENT CLUTCH LEVER - Used to engage the and ad
ページ10に含まれる内容の要旨
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. ENGINE - HOW TO USE YOUR TRACTOR • Move throttle control (D) between half and full speed TO SET PARKING BRAKE (See Fig. 5) (fast) position. Your tractor is equip
ページ11に含まれる内容の要旨
OPERATION TO OPERATE MOWER TO MOVE FORWARD AND BACKWARD (See Fig. 8) Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with The direction and speed of movement is controlled by the the engine running and the attachment clutch engaged will gearshift lever (J). shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitat- ing or cutting off when operating your equipment on r
ページ12に含まれる内容の要旨
OPERATION USING THE REVERSE OPERATION SYSTEM - TOWING CARTS & OTHER ATT ACH MENTS Only use if you are certain no children or other bystanders Tow only the attachments that are recommended by and will enter the mowing area. comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, • Depress clutch/brake pedal all the way down and hold. while on a slope, is dangerous. Tires can lose traction with • With engine running, turn ignition ke
ページ13に含まれる内容の要旨
OPERATION MOWING TIPS TO START ENGINE (See Fig. 4) • Mower should be properly leveled for best mowing When starting the engine for the first time or if the engine per for mance. See "TO LEVEL MOWER HOUSING" in has run out of fuel, it will take extra cranking time to move the Service and Adjustments section of this manual. fuel from the tank to the engine. • The left hand side of mower should be used for trim- • Sit on seat in operating position, depress clutch/brake ming. pedal and set par
ページ14に含まれる内容の要旨
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Clean Debris Off Steering Plate 5 Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil
ページ15に含まれる内容の要旨
MAINTENANCE BLADE CARE TRACTOR For best results, mower blade must be kept sharp. Re place Always observe safety rules when per form ing any bent or damaged blade. main te nance. CAUTION: Use only a replacement blade ap- BRAKE OPERATION proved by the manufacturer of your tractor. If tractor requires more than five (5) feet to stop at highest Using a blade not approved by the manu- speed in high est gear on a level, dry concrete or paved facturer of your tractor is hazardous, could surface,
ページ16に含まれる内容の要旨
00667 MAINTENANCE • Slide oil drain extension under oil drain hole (drain hole TRANSAXLE MAINTENANCE may be flush with or protrude from engine block side wall). Keep transaxle free from build-up of dirt and chaff which • Make sure back face of oil drain extension is flush with can restrict cooling. engine side wall. Do not attempt to clean transaxle while engine is running or • Make sure bottom lip of oil drain extension is lined up while the transaxle is hot. T o prevent pos si ble damage
ページ17に含まれる内容の要旨
MAINTENANCE DECK WASHOUT PORT (See Fig. 20) ENGINE COOLING SYSTEM (See Fig. 18) Debris may clog the engine's air cooling system. Remove Your tractor’s deck is equipped with a washout port on blower housing and clean the area shown to prevent over- its surface as part of its deck wash system. It should be heating and engine damage. utilized after each use. 1. Drive the tractor to a level, clear spot on your lawn, near AIR SCREEN CLEAN OUT CHAFF AND DEBRIS enough to a water spigot for your ga
ページ18に含まれる内容の要旨
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: • Depress clutch/brake pedal fully and set parking brake. • Place gearshift lever in neutral position. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTANT: IF AN AT
ページ19に含まれる内容の要旨
SERVICE AND ADJUSTMENTS • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO • Insert end of link (E) into hole in front mower bracket CHASSIS - Position hole in arm over pin (B) on outside and secure with washer and retainer spring (J). of tractor chassis and secure with retainer spring. E • Repeat on opposite side of tractor. A J F H B Fig. 24 • Hook end of clutch cable spring (Q) into hole in idler arm (R). Fig. 22 • Push clutch cable housing guide (P) into bracket, slide • ATTACH REAR LIFT LINKS (C
ページ20に含まれる内容の要旨
SERVICE AND ADJUSTMENTS • If adjustment is necessary, see step in Visual Adjust- TO LEVEL MOWER ment instructions above. Make sure tires are properly inflated to the PSI shown on • Recheck measurements, adjust if necessary until both tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower sides are equal. is not adjusted properly. FRONT-TO-BACK ADJUSTMENT (See Figs. 29 & 30) VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 27) IMPORTANT: D
