ページ1に含まれる内容の要旨
Mainboard
MS 6760 Vers.1
ページ2に含まれる内容の要旨
FCC-B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interferen
ページ3に含まれる内容の要旨
Lithium Battery Statement CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufactuer. Discard used bat- teries according to the manufacturer’s instructions. ® Macrovision Statement This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyrig
ページ4に含まれる内容の要旨
Safety Instructions 1. Always read the safety instructions carefully. 2. Keep this User’s Manual for future reference. 3. Keep this equipment away from humidity. 4. Lay this equipment on a reliable flat surface before setting it up. 5. The openings on the enclosure are for air convection hence protects the equipment from overheating. DO NOT COVER THE OPENINGS. 6. Make sure the voltage of the power source and adjust properly 115/230V before connecting the equipment to the power inlet. 7. Place t
ページ5に含まれる内容の要旨
Copyright Notice The material in this document is the intellectual property of MICRO-STAR INTERNATIONAL. We take every care in the preparation of this document, but no guarantee is given as to the correctness of its contents. Our products are under continual improvement and we reserve the right to make changes with- out notice. Trademarks All trademarks are the properties of their respective owners. ® ® Intel and Pentium are registered trademarks of Intel Corporation. ® PS/2 and OS /2 are regis
ページ6に含まれる内容の要旨
CONTENTS System Specification ............................................................................ viii Chapter 1. Introducing Mainboard...........................................................1-1 Mainboard Layout..........................................................................1-2 CPU/Memory.................................................................................1-3 Introduction to DDR SDRAM................................................1-3 Power Supply..............
ページ7に含まれる内容の要旨
Modem Module Connector: CN21...........................1-16 Jumper.............................................................................1-17 Clear CMOS Jumper: J2.............................................1-17 Slots......................................................................................1-18 PCI Slot.......................................................................1-18 AGP Slot......................................................................1-18 Chapter 2: Setting
ページ8に含まれる内容の要旨
System Specification M/B - MS-6760 (Proprietary F/F), 185 x 290 mm (4 layer) CPU: ® - Support Socket 478 for Pentium 4, 2.8 GHz Chipset: - SiS 651 + SiS 962 Memory: - DDR 333 x 2, support memory up to 2.0GB On-Board Audio: - AC’97 Codec integrated in ALC 650, support 5.1 channel , SPDIF In/Out. On-Board VGA: - Integrated (AGP 4X) ** On-Board VGA memory: None On-Board Communication - LAN: integrated in Realtek (10/100Mb) - Modem: 56K MDC module On-Board USB - Front x 2; Rear x 2; On-Board x 2 f
ページ9に含まれる内容の要旨
On-Board Headers & Connectors - Rear Panel: Parallel Port x 1, Serial Port x 1, VGA x 1, PS/2 x 2, Mic in/Line in/ Line out x 1, USB x 2, LAN (RJ45) x 1, SPDIF/O x 1, Modem (RJ11) x 1 - Front Panel: Mic in/Headphone x 1, USB x 2, SPDIF/I x 1, 1394 x 1 (4-pin), 1394 x 1(6-pin) BIOS - 2MB Flash Others ® - Microsoft PC 2001 - LAN Wake Up Function - Suspend to RAM/DISk function - Top Tech III (Thermal Overheat Protection Technology) - PC Alert System Hardware Monitor - On-Board BlueBird Module for
ページ10に含まれる内容の要旨
Introducing Mainboard Introducing Mainboard Introducing Mainboard Introducing Mainboard Introducing Mainboard Introducing Mainboard 1.1 Mainboard Layout 1.1 Mainboard Layout 1.1 Mainboard Layout 1.1 Mainboard Layout 1.1 Mainboard Layout 1.2 CPU/Memory 1.2 CPU/Memory 1.2 CPU/Memory 1.2 CPU/Memory 1.2 CPU/Memory 1.3 Power Supply 1.3 Power Supply 1.3 Power Supply 1.3 Power Supply 1.3 Power Supply 1.4 Front Panel 1.4 Front Panel 1.4 Front Panel 1.4 Front Panel 1.4 Front Panel 1.5 Back Panel 1.5 Back
ページ11に含まれる内容の要旨
Chapter 1 1.1 Mainboard layout See the following for the mainboard layout: FDD Connector IDE Connectors Front Panel Connector USB Card Reader DDR DIMM Slots Connector Radio Module USB Connector Radio Antenna Connector LCM Connector Front Panel Power Connector AGP Slot Clear CMOS Jumper CPU Fan Connector ATX Power Supply PCI Slot Modem Module Connector TV Audio Connector PowerSupply Connector CD-IN Connector Hi-Fi Power Connector MS6760 v1.X Mainboard ○ ○ ○ ○○○○○○○○○○○○○○○○○○○○○○ 1-2 CN28 CN20 T
ページ12に含まれる内容の要旨
Introducing Mainboard 1.2 CPU/memory ® ® The mainboard supports Intel Pentium 4 processors in the 478-pin package. The mainboard uses a CPU socket called PGA478 for easy CPU installation. When you are installing the CPU, make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating. Overheating Overheating will seriously damage the CPU and system, always make sure the cooling fan can work properly to protect the CPU from overheating. The mainboard provides 2 sl
ページ13に含まれる内容の要旨
Chapter 1 1.3 Power Supply The system is equipped with a 200W(PFC) ATX power supply. The power cord of power supply has been connected to the connectors on the mainboard when shipped out. You can find two connectors (20-Piin & CN 20) on the mainboard. ATX Power Supply Pin Definition 10 20 PIN SINGAL PIN SIGNAL 1 3.3V 1 1 3.3V 2 3.3V 12 -12V 3 GND 13 GND 45V 14 PS_ON 5 GND 15 GND 65V 16 GND 1 7 GND 17 GND 11 8 PW_OK 18 9 5V_SB 19 5V 20-Pin 10 12V 20 5V Connector CN20 Pin Definition PIN SINGAL
ページ14に含まれる内容の要旨
Introducing Mainboard 1.4 Front panel The Front Panel is independent and extended from the mainboard. It’s connected to the Front Panel Connector on the mainboard. You can find the following ports on the Front Panel. Optical SPDIF-In USB x 2 J1394-1 J1394-2 Mic-In Head-Phone IEEE 1394 Port: J1394-2 The mainboard provides two IEEE 1394 ports. This smaller one is de- signed for you to connect the IEEE 1394 device with external power. The IEEE 1394 high-speed serial bus complements USB by prov
ページ15に含まれる内容の要旨
Chapter 1 IEEE 1394 Port: J1394-1 The bigger 6-pin IEEE 1394 Port on the back panel is designed for you to connect to IEEE 1394 devices without external power. That means the mainboard can provide the power for the devices connected to this port. Software Support ® IEEE 1394 Driver is provided by Windows 98 SE, Win- ® ® ® dows XP, Windows ME and Windows 2000. Just plug in the IEEE 1394 connector into the port. These Operating Sys- tems will install the driver for IEEE 1394. USB Ports The ma
ページ16に含まれる内容の要旨
Introducing Mainboard Mic-in/Head-Phone Mic-in is a connector for microphone. Head-Phone is a connector for Speakers or Headphones. OPTICAL SPDIF-in The OPTICAL connector allows you to receive the audio file of SPDIF interface for recording and playing. The SPDIF (Sony & Philips Digital Interface) is developed jointly by the Sony and Philips corporations . A standard audio file transfer format, SPDIF allows the transfer of digital audio signals from one device to another without having to be c
ページ17に含まれる内容の要旨
Chapter 1 1.5 Back panel The Back Panel provides the following ports: Serial Port Mouse LAN Port Parallel Port VGA Port Keyboard USB x 2 Optical SPDIF-out Lin-in Mic-in Speak-out Serial Port The mainboard offers a 9-pin male DIN serial port . The port is 16550A high speed communication ports that sends/receives 16 bytes FIFOs. You can attach a serial mouse or other serial devices directly to the connector. Pin Definition 1 2 3 4 5 PIN SIGNAL DESCRIPTION 1 DCD Data Carry Detect 2 SI
ページ18に含まれる内容の要旨
Introducing Mainboard VGA Port The mainboard provides one DB 15-pin female connector to connect a VGA monitor. Pin Definition 5 1 Analog Video Display Connector (DB-15s) PIN SIGNAL DESCRIPTION 1 Red 2 Green 3 Blue 15 11 4 Not used 5 Ground DB 15-Pin Female Connector 6 Ground 7 Ground 8 Ground 9 Power 10 Ground 1 1 Not used 12 SDA 13 Horizontal Sync 14 Vertical Sync 15 SCL Mouse/Keyboard Connectors The mainboard provides two standard mini DIN connectors f
ページ19に含まれる内容の要旨
Chapter 1 RJ45 LAN Jack The mainboard provides one standard RJ-45 jack for connection to Local Area Network (LAN). You can connect a network cable to the LAN jack. Pin Definition PIN SIGNAL DESCRIPTION 1 TDP Transmit Differential Pair 2 TDN Transmit Differential Pair 3 RDP Receive Differential Pair 4 NC Not Used 5 NC Not Used 6 RDN Receive Differential Pair 7 NC Not Used 8 NC Not Used USB Ports The mainboard provides an OHCI (Universal Host Controller Interface) Universal Serial Bus root for a
ページ20に含まれる内容の要旨
Introducing Mainboard Parallel Port The mainboard provides a 25-pin female centronic connector as LPT. A parallel port is a standard printer port that supports Enhanced Parallel Port (EPP) and Extended Capabilities Parallel Port (ECP) mode. 13 1 25 14 Pin Definition PIN SIGNAL DESCRIPTION 1 STROBE Strobe 2 DATA0 Data0 3 DATA1 Data1 4 DATA2 Data2 5 DATA3 Data3 6 DATA4 Data4 7 DATA5 Data5 8 DATA6 Data6 9 DATA7 Data7 10 ACK# Acknowledge 11 BUSY Busy 12 PE Paper End 13 SELECT Select 14 AUTO FEED#
