ページ1に含まれる内容の要旨
2008-03
Operator's
Manual O0802055
Ride Mower
2748 GLS (CA)
96043005000
03002
Operator's Manual
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, WARNING: In order to prevent ac- discharge guard, or other safety devices in place and ci den tal starting when setting up, working. trans port ing, ad just ing or making • Slow down before t
ページ4に含まれる内容の要旨
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE • Never operate machine in a closed area. Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to • Keep all nuts and bolts tight to be sure the equipment is in safe working condition. the ma chine and the mowing activity. Never assume that children will remain where you last saw them. • Never tamper with safety devices. Check their proper • Ke
ページ5に含まれる内容の要旨
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES Gasoline Capacity 4 Gallons • Read and observe the safety rules. and type: Unleaded Regular • Follow a regular schedule in maintaining, caring for Oil Type (API-SG-SL): SAE 30 (above 32°F) and using your tractor. SAE 5W-30 (below 32°F) • Follow the instructions under “Maintenance” and “Stor- Oil Capacity: w/Filter: 64 oz age” sec tions of this own er’s manual. w/o Filter: 60 oz Spark Plug: Champion QC12YC (Gap: .040") WARNI
ページ6に含まれる内容の要旨
UNASSEMBLED PARTS Slope Sheet Key (1) Oil Drain Tube (2) Keys ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard wrench sizes are listed. (1) 3/4" wr
ページ7に含まれる内容の要旨
ASSEMBLY NOTE: You may now roll or drive your tractor off the skid. CHECK FOR PROPER POSITION OF ALL Follow the ap pro pri ate instruction below to remove the BELTS tractor from the skid. See the figures that are shown for replacing motion and mower blade drive belts in the Service and Adjustments WARNING: Before start ing, read, un der stand and fol low sec tion of this manual. Verify that the belts are routed all in struc tions in the Op er a tion section of this man u al. Be correc
ページ8に含まれる内容の要旨
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF REVERSE OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON BATTERY CRUISE CONTROL FUEL REVERSE FORWARD PEDAL 15 15 ATTACHMENT DANGER, KEEP HANDS ATTACHMENT SLOPE HAZARDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAFETY
ページ9に含まれる内容の要旨
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. H D E G P B N F J C Q A M FIG. 3 Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER – Used to raise and lower (G) REVERSE OPERATION SYSTEM (ROS) "ON" PO- t
ページ10に含まれる内容の要旨
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. NOTE: Failure to move throttle control between half and HOW TO USE YOUR TRAC TOR full speed (fast) position, before stopping, may cause en- gine to “backfire”.
ページ11に含まれる内容の要旨
OPERATION TO MOVE FORWARD AND BACKWARD TO ADJUST GAUGE WHEELS (See Fig. 9) (See Fig. 7) Gauge wheels are prop er ly ad just ed when they are slight ly The direction and speed of movement is controlled by the off the ground when mower is at the desired cutting height Motion Control Lever (J). in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions. NOTE: Adjust gauge wheels with tractor on a flat level surface. • Adjust
ページ12に含まれる内容の要旨
OPERATION • Raise attachment lift to highest position with at tach ment REVERSE OPERATION SYSTEM (ROS) lift control. Your tractor is equipped with a Reverse Operation System • Pull freewheel control out and down into the slot and (ROS). Any attempt by the operator to travel in the reverse release so it is held in the disengaged position. direction with the attachment clutch engaged will shut off • Do not push or tow tractor at more than two (2) the engine unless ignition key is placed in
ページ13に含まれる内容の要旨
OPERATION COLD WEATHER STARTING ( 50° F and below) ADD GASOLINE • When engine starts, allow engine to run with the throttle • Fill fuel tank to bottom of filler neck. Do not overfill. Use control in the choke position until the engine runs roughly, fresh, clean, regular un lead ed gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon then move throttle control to fast position. This may re- and lead oxide deposits and reduce valve life). Do not quire an engi
ページ14に含まれる内容の要旨
OPERATION • Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed. Disengage parking brake. • Drive tractor forward for approximately five feet then backwards for five feet. Repeat this driving procedure three times. Your transmission is now purged and now ready for normal op er a tion. MOWING TIPS • Mower should be properly leveled for best mowing FIG. 12 performance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustment
ページ15に含まれる内容の要旨
maint_sch-tractore.ROS.e MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check BrakeOperation Check Tire Pressure T Check Operator Presence &ROSSystems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2
ページ16に含まれる内容の要旨
02545 MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be sharp. Re place Always observe safety rules when per form ing any main- worn, bent or damaged blades. te nance. CAUTION: Use only a replacement BRAKE OPERATION blade approved by the manufacturer of If tractor requires more than five (5) feet to stop at highest your tractor. Using a blade not approved speed in high est gear on a level, dry concrete or paved by the manufacturer of your tractor is surface, then bra
ページ17に含まれる内容の要旨
MAINTENANCE • Rinse the battery with plain water and dry. TO CHANGE ENGINE OIL (See Figs. 14 and 15) • Clean terminals and battery cable ends with wire brush Determine temperature range expected before oil change. until bright. All oil must meet API service classification SG-SL. • Coat terminals with grease or petroleum jelly. • Be sure tractor is on level surface. • Reinstall battery (See “REPLACING BATTERY" in • Oil will drain more freely when warm. the SERVICE AND ADJUSTMENTS section of
ページ18に含まれる内容の要旨
MAINTENANCE ENGINE OIL FILTER 2. Make sure the PTO (Blade Engage) is not engaged, Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in set the parking brake, and stop the engine. one year. 3. Thread the nozzle adapter (packaged with your tractor’s Operator’s Manual) onto the end of your garden hose. MUFFLER Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or dam- Hose a
ページ19に含まれる内容の要旨
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST - MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. • Go to either side of mower and disconnect mower TRACTOR suspens
ページ20に含まれる内容の要旨
SERVICE AND ADJUSTMENTS NOTE: Be sure mower side suspension arms (A) are pointing • From right side of mower, disconnect anti-sway bar (S) forward before sliding mower under tractor. from right rear mower bracket (D) - remove retainer spring and washer and pull mower toward you until the • Slide mower under tractor until it is centered under bar falls from the hole in bracket. tractor. • Turn tractor steering wheel to the left as far as it will go. • FIRST INSTALL ANTI-SWAY BAR (S). • Sli
