ページ1に含まれる内容の要旨
917.289541
(YTH20K46)
Owner's Manual
532 43 47-08
ページ2に含まれる内容の要旨
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Slow down before turning. WARNING: In order to prevent ac ci den tal • Never leave a running machine unattended. Always starting when setting up, trans port ing, turn off blades, set parking brake, stop engine, and ad just ing or making repairs,
ページ3に含まれる内容の要旨
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN Tragic accidents can occur if the operator is not alert to GENERAL SERVICE the presence of children. Children are often attracted to • Never operate machine in a closed area. the ma chine and the mowing activity. Never assume that • Keep all nuts and bolts tight to be sure the equipment children will remain where you last saw them. is in safe working condition. • Keep children out of the mowing area and in the watchful
ページ4に含まれる内容の要旨
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES Gasoline Capacity 2.5 Gallons (9,5 L) • Read and observe the safety rules. and type: Unleaded Regular • Follow a regular schedule in maintaining, caring for Oil Type (API-SG-SL): SAE 30 (above 32°F/0°C) and using your tractor. SAE 10W-30 (below 32°F/0°C) • Follow the instructions under “Maintenance” and “Stor- Oil Capacity: W/ Filter: 64 oz (1,96 L) age” sec tions of this manual. W/O Filter: 60 oz (1,77 L) Spark Plug: Champion RC12YC
ページ5に含まれる内容の要旨
UNASSEMBLED PARTS Slope Sheet Key (1) Oil Drain Tube (2) Keys ASSEMBLY Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard LABEL wrench sizes are listed. (1) 1/2" wrench Tire pressure gauge (2) 7/16" wrenches Utility knife Pliers When right or left hand is mentioned in this man ual, it means when you are in the operating po si tion (s
ページ6に含まれる内容の要旨
ASSEMBLY TO ROLL TRACTOR OFF SKID (See Op- ✓CHECKLIST er a tion section for location and function of BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE con trols) WISH TO ASSURE THAT YOU RECEIVE THE BEST • Raise attachment lift lever to its highest po si tion. PERFORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT. • Release parking brake by de press ing brake ped al. • Place freewheel control in dis en gaged po si tion to dis- PLEASE REVIEW THE FOLLOWING CHECKLIST: en gage trans mis sion (See “TO
ページ7に含まれる内容の要旨
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF REVERSE OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON BATTERY CRUISE CONTROL FUEL REVERSE FORWARD PEDAL 15 15 ATTACHMENT DANGER, KEEP HANDS ATTACHMENT SLOPE HAZARDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAFE
ページ8に含まれる内容の要旨
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. H D G P E B K A F C J M L Fig. 3 Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER - Used to raise and lower (H) LIGHT SWITCH - Turns the headlights on a
ページ9に含まれる内容の要旨
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any ad just ments or repairs. We rec om mend standard safety glasses or a wide vision safety mask worn over spectacles. ENGINE - HOW TO USE YOUR TRAC TOR • Move throttle control between half and full speed (fast) position. TO SET PARKING BRAKE (See Fig. 4) NOTE: Failure to
ページ10に含まれる内容の要旨
OPERATION • For best cutting performance, grass over 6" in height TO MOVE FORWARD AND BACKWARD should be mowed twice. Make the first cut relatively (See Fig. 7) high; the second to de sired height. The direction and speed of movement is controlled by the TO ADJUST GAUGE WHEELS (See Fig. 9) forward and reverse drive pedals. Gauge wheels are prop er ly ad just ed when they are slight ly • Start tractor and release parking brake. off the ground when mower is at the desired cutting height in
ページ11に含まれる内容の要旨
OPERATION NOTE: To protect hood from damage when transporting REVERSE OPERATION SYSTEM (ROS) your tractor on a truck or a trailer, be sure hood is closed Your tractor is equipped with a Reverse Operation System and secured to tractor. Use an appropriate means of tying (ROS). Any attempt by the operator to travel in the reverse hood to tractor (rope, cord, etc.). direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position. TR
ページ12に含まれる内容の要旨
OPERATION AUTOMATIC TRANSMISSION WARM UP CAUTION: Wipe off any spilled oil or • Before driving the unit in cold weather, the trans mis sion fuel. Do not store, spill or use gasoline should be warmed up as follows: near an open flame. • Be sure the tractor is on level ground. • Release the parking brake and let the brake slowly IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW return to operating position. 32°F (0°C), USE FRESH, CLEAN WINTER GRADE GAS O LINE TO HELP ENSURE GOOD COLD WEATHE
ページ13に含まれる内容の要旨
OPERATION PURGE TRANSMISSION MOWING TIPS • Mower should be properly leveled for best mowing CAUTION: Never engage or disengage performance. See “TO LEVEL MOWER HOUSING” in freewheel lever while the engine is the Service and Adjustments section of this manual. run ning. • The left hand side of mower should be used for trim- ming. • Drive so that clippings are discharged onto the area To ensure proper operation and performance, it is rec om- that has been cut. Have the cut area to the righ
ページ14に含まれる内容の要旨
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Clean Debris Off Steering Plate 5 Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil
ページ15に含まれる内容の要旨
MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be kept sharp. Re place Always observe safety rules when per form ing any bent or damaged blades. main te nance. CAUTION: Use only a replacement blade ap- BRAKE OPERATION proved by the manufacturer of your tractor. If tractor requires more than five (5) feet to stop at highest Using a blade not approved by the manu- speed in high est gear on a level, dry concrete or paved facturer of your tractor is hazardous, could surface
ページ16に含まれる内容の要旨
MAINTENANCE V-BELTS OIL DRAIN VALVE Check V-belts for deterioration and wear after 100 hours CLOSED of operation and replace if necessary. The belts are not AND ad just able. Re place belts if they begin to slip from wear. LOCKED POSITION TRANSAXLE COOLING DRAIN The transmission fan and cooling fins should be kept clean YEL LOW CAP TUBE to assure proper cooling. Do not attempt to clean fan or transmission while engine is running or while the transmission is hot. To prevent pos- Fig. 16 s
ページ17に含まれる内容の要旨
MAINTENANCE IN-LINE FUEL FILTER (See Fig. 17) DECK WASHOUT PORT (See Fig. 19) The fuel filter should be replaced once each season. If fuel Your tractor’s deck is equipped with a washout port on filter becomes clogged, ob struct ing fuel flow to car bu re tor, its surface as part of its deck wash system. It should be re place ment is re quired. utilized after each use. • With engine cool, remove filter and plug fuel line sec- 1. Drive the tractor to a level, clear spot on your lawn, near
ページ18に含まれる内容の要旨
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTANT: IF AN ATTACHMENT OTHER THAN THE TO REMOVE MOWER (See Fig.
ページ19に含まれる内容の要旨
SERVICE AND ADJUSTMENTS • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO • Insert end of link (E) into hole in front mower bracket CHASSIS - Position hole in arm over pin (B) on outside and secure with washer and retainer spring (J). of tractor chassis and secure with retainer spring. E • Repeat on opposite side of tractor. A J F H B Fig. 23 • Hook end of clutch cable spring (Q) into hole in idler arm (R). Fig. 21 • Push clutch cable housing guide (P) into bracket, slide • ATTACH REAR LIFT LINKS (C
ページ20に含まれる内容の要旨
SERVICE AND ADJUSTMENTS • If adjustment is necessary, see step in Visual Adjust- TO LEVEL MOWER ment instructions above. Make sure tires are properly inflated to the PSI shown on • Recheck measurements, adjust if necessary until both tires. If tires are over or under inflated, it may affect the sides are equal. appearance of your lawn and lead you to think the mower is not adjusted properly. FRONT-TO-BACK ADJUSTMENT (See Figs. 28 & 29) VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 26) IMPORTANT:
