ページ1に含まれる内容の要旨
Owner's Manual
Riding Mower
H3011 • H3011H
KINKOS
31763800
Printed on 100.2002.08
00X31-763-8002
©1989 Honda Motor Co., LTD. — All Rights Reserved
Recycled Paper
PRINTED IN U.S.A.
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Thank you for purchasing a Honda riding mower. This manual describes operation and maintenance of the Honda H3011 (manual transmission) and H301 1 H (hydrostatic transmission) riding mower, type SA and HSA. Information in this manual is based on the H301lSA model with Mechanical Auto-clutch Transmission (MAT) except as noted. The noted areas apply to the H3011 HSA model with Hydrostatic Transmission (HSTI. All information in this manual is based.on‘the latest product information availab
ページ4に含まれる内容の要旨
CONTENTS 1. SAFETY INFORMATION ....................................................... 4 ............................................. 9 2. COMPONENT IDENTIFICATION 3. CONTROLS ........................................................................ 12 Engine switch ..................................................................... 12 ...................................................................... 12 Throttle lever .......................................... Cutter deck height
ページ5に含まれる内容の要旨
5. OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33 33 Starting the engine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 Mowing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 Mowing tips . . . . .
ページ6に含まれる内容の要旨
1. SAFETY INFORMATION Read all safety instructions before you ride! (H301 1 only, Manual Transmission) GASOLINE IS FLAMMABLE
ページ7に含まれる内容の要旨
Read all safety instructions before you ride! (H301 1 H only, Hydrostatic Transmission) GASOLINE IS FLAMMABLE STOP ENGINE. AVOID HEAT,
ページ8に含まれる内容の要旨
SAFETY INFORMATION For your safety and the safety of others, pay special attention to these precautions: Operator Responsibility l Keep the riding mower in good operating condition. Operating a riding mower in poor, or questionable condition could result in serious injury. l Be sure all safety devices are in working order and warning labels are in place, these items are installed for your safety. l Know how to stop the engine and blade quickly in case of emergency. Understand the use of
ページ9に含まれる内容の要旨
-, . . Cutting Blade Hazard The cutting blade is sharp, and it turns at high speed. Accidental contact can cause serious injury. l Keep your hands and feet away from the mower deck while the engine is running. l Stop the engine, disengage the Power Take Off (P.T.O.) clutch and remove the key before inspection or maintenance of the deck or blade. l Disconnect the spark plug cap to prevent any possibility of accidental starting. Wear heavy gloves to protect your hands from the blade when
ページ10に含まれる内容の要旨
The engine and exhaust system become very hot during operation and re- main hot for a while after stopping. Contact with hot engine components can cause burn injuries and can ignite some materials. l Avoid touching a hot engine or exhaust system. l Allow the engine to cool before performing maintenance or storing the riding mower indoors. Carbon Monoxide Poisoning Hazard Exhaust contains poisonous carbon monoxide, a colorless and odorless gas. Breathing exhaust can cause loss of consciou
ページ11に含まれる内容の要旨
2. COMPONENT IDENTIFICATION SHIFT LEVER I H3011H (HYDROSTATIC TRANSMISSION) \ STEERING WHEEL JNG AIR INTAKE BRAKE LEVER WARNING BUZZER 9
ページ12に含まれる内容の要旨
POWER TAKE-OFF TRANSMISSION tP.T.0.) LEVER RELEASE LEVER \ POWER TAKE-OFF 8.. .w ‘. . I .-.,I-” . ,I-. I .“.I LCVC” DECK HEIGHT ADJUSTING LE E SERIAL NUMBER CUTTER DECK OWNER’S MANU l ENGINE SERIAL NUMBER * Record the frame and engine serial numbers for your reference. Refer to the serial numbers when ordering parts, and when making technical or warranty inquiries (see page 76). Frame serial number: Engine serial number: IO
ページ13に含まれる内容の要旨
Engine compartment TRANSMISSION FLUID RESERVOIR lH3011H HYDROSTATIC TRANSMISSION) AIR CLEANER OIL FILLER CAP I I 1 BATTERY SPARK PLUG CAP OIL FILLER CAP BATTERY ’ %+&\ ~l?%&J%: ,“,“,:‘,E, H3011H (HYDROSTATIC TRANSMISSION) SPARK PLUG CAP I??+-- - ENGINE OIL DRAIN BOLT (LOCATED UNDER ENGINE) 11
ページ14に含まれる内容の要旨
3. CONTROLS Engine switch m Always remove the key from the engine switch whenever the riding mower is Unattended to prevent childrenor unauthorized persons from-starting the engine. This riding mower is equipped with an automotive type ignition switch, which controls all the electrical cir- cuits. The switch is located on the right-hand side in front of the gear shift lever. Key positions: “START” to start the engine “ON” to run the engine after ENGINE SWITCH starting “OFF” to st
ページ15に含まれる内容の要旨
Cutter deck height adjusting lever This lever is used to raise and lower the cutter deck. To adjust the cutting height, squeeze the handle lock and then press in and hold the set button. Raise or lower the lever until the desired cutting height appears on the in- dicator. At that point, release the set button and the handle lock. Be sure the handle lock returns to its normal position when released. Cutting height: 1.0, 1.5, 2.0, 2.5, 3.0, 3.5 in (Approx.) 1 IMPORTANT NOTICE 1 l To avoid
ページ16に含まれる内容の要旨
Shift lever (H3011 H only, Hydrostatic Transmission) Use the shift lever to change the forward/reverse speed of the riding mower and/or to shift the transmission into NEUTRAL (STOP). To drive the riding mower forward, release the parking brake and slowly move the shift lever from NEUTRAL to forward direction (away from you). To drive in reverse, slowly move the shift lever back (toward you). NOTE: The shift lever is interconnected with the brake pedal, the shift lever returns to NEUTRAL w
ページ17に含まれる内容の要旨
Brake pedal (H3011 only, Manual Transmission) Depressing the pedal will first disengage the riding mower drive clutch. As you continue to depress the pedal, the brake will be applied to stop the riding mower. \ When the clutch pedal is released, the clutch will automatically engage smoothly. m Releasing the brake pedal too slowly can cause the clutch to slip, and may lead to premature clutch wear. Brake pedal (H3011 H only, Hydrostatic Transmission) The brake pedal and the shift lever
ページ18に含まれる内容の要旨
Parking brake lever and warning buzzer (H3011 only, Manual Transmission) This lever is used to set the brake when the riding mower is parked. To set the parking brake, pull up on the parking brake lever until the set button locks in place. To release the parking brake, pull the lever up slightly and press the set button, lower the lever while holding in the button. The warning buzzer will sound continuously when the following conditions are present: With the parking brake set, the engin
ページ19に含まれる内容の要旨
Parking brake lever and warning buzzer (H3011 H only, Hydrostatic Transmission) This lever is used to set the brake when the riding mower is parked. Pull the lever fully up until the ratchet locks. To set the parking brake, pull up on the parking brake lever until the set button locks in place. To release the parking brake, pull the lever up slightly and press the set button, lower the lever while holding in the button. The warning buzzer will sound continuously when the following condit
ページ20に含まれる内容の要旨
Transmission release lever This lever is used when it becomes necessary to push or move the riding mower manually. m Operating the transmission release lever while on a slope or hill, could result in a loss of control causing serious injury or equipment damage. [ IMPORTANT NoT’CE 1 Operating the transmission release lever while the engine is running could cause transmission damage. To operate the transmission release lever: 1. Stop the engine and apply the parking brake. Place the shi
