ページ1に含まれる内容の要旨
VENTURER 32 (VTR32)
®
VISIMO (VM032/VM032+)
ROLLERMO (RM032)
EASIMO (EM032/EM032+)
Original Instructions
RE 320 (RE32)
ROLLERMO
VENTURER 32
RE320
VISIMO EASIMO
IMPORTANT INFORMATION
Read before use
& retain for future reference
ページ2に含まれる内容の要旨
Carton Contents switchbox start/stop lever lock off cable clip x 2 button grassbox washer x 4 handle upper handle wingknob x 4 bolt x 2 grassbox upper grassbox lower Easimo only grassbox tongue electric cable with moulded safety flap on plug lower handle x 2 motor cover deck instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. The Loose Parts Pack is packaged underneath the deck of the product. IF ANY PARTS ARE MISSING CON
ページ3に含まれる内容の要旨
tions to use the machine. fixings in sets to preserve balance. 3. Stop using the machine while people, especially children, Use or pets are nearby. 1. Use the lawnmower only in daylight or good artificial light. 4. Only use the lawnmower in the manner and for the 2. Avoid operating your lawnmower in wet grass, where functions described in these instructions. feasible. 5. Never operate the lawnmower when you are tired, ill or 3. Take care in wet grass, you may lose your footing. under the influe
ページ4に含まれる内容の要旨
Assembly Instructions • The Loose Parts Pack is packaged underneath the deck. A Assembly of Lower Handles to Deck 2 3 1. Place the bolt (A2) through the hole in the lower handle (A1) until the lower handle fits into the recess (A3) 2. Place the washer (B1) and the wing knob (B2) on to the bolt and tighten the wing knob. 1 3. Repeat on the other side. Assembly of Upper Handles to Lower Handles. 1. Ensure the upper handle is located correctly with the B lock-off button on the switchbox uppermost.
ページ5に含まれる内容の要旨
Grassbox G 1 Fitting Fully Assembled Grassbox to Lawnmower. 3 1. Lift safety flap (G1) 2. Make sure the discharge chute is clean and free from debris (G2) 3. Locate fully assembled grassbox onto 2 location points (G3) at the rear of the deck as illustrated in 2 pic. H H 4. Locate safety flap onto the top of the grassbox. En- sure the grassbox is securely located. • IMPORTANT ! AFTER FITTING ENSURE NO GAP REMAINS BE- TWEEN THE SAFETY FLAP AND THE GRASSBOX. • Removal is the reverse procedure. •
ページ6に含まれる内容の要旨
Starting and Stopping To Start your Lawnmower M N 1. Form loop in mains cable and push the loop through the slot. (M) 2. To secure, position loop over the hook and pull the cable back through the slot (N). 3. Connect plug to mains and switch on. 4. Tilt the handle downwards to slightly raise the front of the lawnmower and to reduce the risk of lawn damage whilst starting. P Q The switchbox is provided with a lock-off button (P1) to prevent accidental starting. 5. Press and hold the lock-off butt
ページ7に含まれる内容の要旨
Caring for your Lawnmower Cleaning V1 V2 • USE GLOVES • IMPORTANT:- It is very important that you keep your lawn- mower clean. Grass clippings left in any of the air intakes or under the deck could become a potential fire hazard. 1. Remove grass from under the deck with brush. (V1) 2. Using a soft brush - remove grass clippings from all air intakes (V2), the discharge chute (V3) and the grass box (V4). 3. Visimo Only - Using a soft brush, remove grass clip- pings from the vision window (V5). V3
ページ8に含まれる内容の要旨
Service Recommendations 1. We strongly recommend that your product is serviced at 6. Should it be necessary for work to be carried out by your least every twelve months, more often in a professional ap- Service Centre, it is important to take your complete ma- plication. chine including cable and any extension cables used. 2. Always use genuine Spare Parts. A network of specialist dealers can be found in your local Yel- 3. Prepacked spares are available from most Husqvarna UK low Pages. Ltd. sto
ページ9に含まれる内容の要旨
EC Declaration of Conformity Husqvarna AB, 561 82, Huskvarna, Sweden Declare under our sole responsibility that the product(s); Category........................................ Electric Rotary Lawnmower Model(s).........................................VM032, VM032+, RM032, EM032, EM032+,RE32 Identification of Series................... See Product Rating Label Year of Construction...................... See Product Rating Label Complies with the essential requirements & provisions of the following
