ページ1に含まれる内容の要旨
Operator's Manual
3000 SERIES
ZTR® MOWERS
2001
ページ2に含まれる内容の要旨
IMPORTANT: READ CAREFULLY The Dixon® ZTR® Mower is both easy and fun to operate. However, any power mower must be operated properly to be safe. It is not a toy or a recreational vehicle. Before you start to use the mower: read the operator's manual carefully, and become completely familiar with the controls. The information in this operator's manual applies to all Dixon® ZTR® 3000 Series Model Mowers. Your Dixon dealer will gladly answer any questions. See your dealer for warranty service, par
ページ3に含まれる内容の要旨
INDEX SAFETY .................................................................. 4 - 9 WARRANTY POLICY ............................................ 10 SPECIFICATIONS ................................................. 11 - 13 SEAT ADJUSTMENT ............................................ 14 CONTROLS ........................................................... 15 - 17 OPERATION INSTRUCTIONS ........................... 18 - 23 CARE AND MAINTENANCE ............................... 24 - 31 STA
ページ4に含まれる内容の要旨
SAFETY RIDING LAWNMOWERS, IF IMPROPERLY OPERATED, CAN CAUSE SERIOUS INJURY OR DEATH The most common causes of injury to the operator or bystander... BLADE CONTACT TIP-OVER BACK-OVER RUN-OVER ...read and understand this manual to prevent injuries. Page 4
ページ5に含まれる内容の要旨
SAFETY SAFETY SYMBOLS Safety Alert Symbol When you see this symbol, BE ALERT to the potential for injury. Follow recommended safety precautions and safe operating practices. Danger indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. Warning indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. Caution indicates a potentially hazardous situation which, if not avoided, may result in minor o
ページ6に含まれる内容の要旨
SAFETY This cutting mower is capable of amputating hands & feet, and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. GENERAL OPERATION: Read, understand, and follow all instructions in the manual and on the mower before starting. Only allow responsible adults, who are familiar with the instructions, to operate the mower. Clear the area of objects such as rocks, toys, wire, etc., which could be picked up and thrown by the blade
ページ7に含まれる内容の要旨
SAFETY SLOPE OPERATION: Slopes are a major factor related to loss-of-control and tip-over accidents, which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it! DO Mow across the slope with your Dixon ZTR - never up or down. Remove obstacles such as rocks, tree limbs, etc. Watch for holes, ruts or bumps. Uneven terrain could overturn the mower. Tall grass can hide obstacles. Use slow speed. Tires ma
ページ8に含まれる内容の要旨
SAFETY CHILDREN: Tragic accidents can occur if the operator is not alert to the presence of children. Children are attracted to lawn mowers and the mowing activity. NEVER assume children will stay where they were last seen. Be alert to avoid accidents. Keep children out of the mowing area and under the watchful care of another responsible adult. Be alert and turn mower off if a child enters the area. Before and during backing, look behind and DOWN for small children. Never carry
ページ9に含まれる内容の要旨
SAFETY SERVICE: Use extra care in handling gasoline and other fuels. They are flammable and vapors are explosive. Use only an approved container. Never remove gas cap or add fuel with the engine running. Allow engine to cool before refueling. Do not smoke. Never refuel the mower indoors. Never store the mower or fuel container inside a building where there is an open flame, If fuel is spilled on clothing, change clothing immediatley. To prevent fire and explosion caused by static electrici
ページ10に含まれる内容の要旨
DIXON INDUSTRIES, INC. a BLOUNT company AIRPORT INDUSTRIAL PARK PO BOX 1569 COFFEYVILLE KS 67337 0945 316 251 2000 FAX 316 251 4117 DIXON LIMITED WARRANTY POLICY - 3000 & 4000 SERIES WARRANTY: Home Owner Application: This Dixon Warranty term is for a period of two (2) years from date of purchase. Commercial Application: Dixon mowers used for commercial application are warranted for 30 days from the date of purchase. Commercial use is specified as use other than, or in addition to, mowin
ページ11に含まれる内容の要旨
SPECIFICATIONS Model ZTR 3303 CHASSIS: Twin 12 gauge side frames and 7 gauge transmission and engine base plate. BODY: All body parts are made of rotational molded polyethylene. Front body contains access panel for battery service. Seat tilts forward to allow transmission service. MOWER DECK: 11 GA stamped steel construction. Single 30" cut blade. Cut height approximately 1" to 4" via 7 position lift handle. BLADE DRIVE: Mechanical; hand lever engagement. TRANSMISSION: Each rear wheel is inde
ページ12に含まれる内容の要旨
SPECIFICATIONS Model ZTR 3304 CHASSIS: Twin 12 gauge side frames and 7 gauge transmission and engine base plate. BODY: All body parts are made of rotational molded polyethylene. Front body contains access panel for battery service. Seat tilts forward to allow transmission service. MOWER DECK: 11 GA stamped steel construction. Single 30" cut blade. Cut height approximately 1" to 4" via 7 position lift handle. BLADE DRIVE: Mechanical; hand lever engagement. TRANSMISSION: Each rear wheel is ind
ページ13に含まれる内容の要旨
SPECIFICATIONS Model ZTR 3014 CHASSIS: Twin 12 gauge side frames and 7 gauge transmission and engine base plate. BODY: All body parts are made of rotational molded polyethylene. Front body contains access panel for battery service. Seat tilts forward to allow transmission service. MOWER DECKS: 36" Deck: 11 GA Laser Cut Fabricated - 36" Cut Width 42" Deck: 13 GA Stamped Steel Construction - 42" Cut Width Cut height approximately 1" to 4" via 7 position lift handle. BLADE DRIVE: Electric
ページ14に含まれる内容の要旨
SEAT ADJUSTMENT INSTRUCTIONS Models ZTR 3303 - ZTR 3304 - ZTR 3014 1. Raise and push seat assembly forward. 2. Loosen five nuts, P/N 3205, and slide seat forward or backward to desired position. 3. Re-tighten nuts, P/N 3205. DO NOT operate mower without seat adjustments properly tightened. 4. Push seat assembly back to closed position. Page 14
ページ15に含まれる内容の要旨
CONTROLS The Dixon ZTR has a unique transaxle that requires only two drive levers to control braking, turning, speed, and direction. On initial operation, set throttle speed on slow. Operate with mower blade "OFF". To avoid "over-controlling" the mower, use a light touch on the drive levers. Slight movements using fingertip control is all that is necessary. PARKING BRAKE: The parking brake is designed to hold the mower from moving and is not intended for use in stopping the mower while it is i
ページ16に含まれる内容の要旨
CONTROLS (Left turn opposite) TO GO FORWARD: From neutral position, gently push both drive levers forward. To increase speed, move levers farther forward. TO GO BACKWARD: From neutral position, gently pull both drive levers toward you. TURNING: Turning is controlled by moving one drive lever slightly forward or rearward of the other. To turn left, move left lever rearward of the right lever. To turn "square corners" move lever of desired direction to neutral. To turn on mower's own axis (z
ページ17に含まれる内容の要旨
CONTROLS BLADE DRIVE: Models ZTR 3303 & 3304 Located to left of operator. To engage the mower blade, turn lever on floor slowly to the "ON" position. To disengage mower blade, turn lever to the "OFF" position. BLADE DRIVE: Model ZTR 3014 Located on control panel, on operator's right. To engage the mower blades, pull up on the switch. To disengage blades, push down. CIRCUIT BREAKER: Protection of the electrical system is by (1) 15 amp circuit breaker. If circuit breaker trips, push
ページ18に含まれる内容の要旨
OPERATION INSTRUCTIONS Safe and successful operation will depend upon the operator having the correct knowledge of all controls used on the mower and making good judgements about the terrain to be mowed. NEVER allow anyone to operate the mower without complete knowledge of all controls and their functions. During initial operation, "learning to drive", set throttle at slow speed. Sound judgement by the operator will prevent accidents. TOWING Towing a trailer or other attachment that is too hea
ページ19に含まれる内容の要旨
OPERATION INSTRUCTIONS TESTING OF SAFETY INTERLOCK SYSTEMS: PARKING BRAKE SWITCH TEST: a)Place Parking Brake in OFF position b)Turn ignition switch to START Engine should not turn over or attempt to start. BLADE DRIVE SWITCH TEST: a)Place Parking Brake in ON position b)Engage blade drive switch c)Turn ignition switch to START Engine should not turn over or attempt to start. SEAT SWITCH TEST: a)In a SAFE AREA away from bystanders, start the engine b)Engage blade drive switch c) Raise slightly off
ページ20に含まれる内容の要旨
OPERATION INSTRUCTIONS STARTING INSTRUCTIONS: 1. Parking brake must be on, and blade drive disengaged. 2. Move throttle control to "Choke" position if engine is cold, full throttle if warm. 3. Insert ignition key and turn to "Start" position. When engine starts, release ignition key. Key will return to "Run" position. 4. Move throttle from "Choke" to desired speed position. 5. Release parking brake. 6. Operate the mower per the "CONTROL" instructions on Page 16. NOTE: While mowing, "blade(s)
