ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
IMPORTANT- READ CAREFULLY The Dixon® ZTR® Mower is both easy and fun to operate. However, any power mower must be operated properly to be safe. It is not a toy or a recreational vehicle. Before you start to use the mower, read the operator's manual carefully, and become completely familiar with the controls. The information in this operator's manual applies to all Dixon ZTR 4000 Series Model Mowers. Your @ @ Dixon dealer will gladly provide a check-out ride, and answer any questions.
ページ3に含まれる内容の要旨
INDEX 1. SAFETY................................................................Pages 1- 5 2. WARRANTY POLICY............................................ Page 6 3. SPECIFICATIONS................................................. Page 7 4. SEAT ADJUSTMENT ............................................Page 8 5. CONTROLS...........................................................Pages 9 - 12 6. OPERATION INSTRUCTIONS...............................Pages 13 - 16 7. CARE AND MAINTENANCE ........
ページ4に含まれる内容の要旨
SAFETY RIDING LAWNMOWERS, IF IMPROPERLY OPERATED, CAN CA USE SERIOUS INJURY OR DEATH The most common causes of injury to the operator or bystander... BLADE CONTACT TIP-OVER RUN-OVER To avoid these and other accidents, read and understand the operator's manual. SAFETY SYMBOLS: SAFETY ALERT SYMBOL - When you see this symbol, BE ALERT to the potential for injury. Follow recommended safety precautions and safe operating practices. Danger indicates an imminently hazardous situat
ページ5に含まれる内容の要旨
SAFETY This cutting mower is capable of amputating hands and feet, and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. GENERAL OPERATION: * Read, understand, and follow all instructions in the manual and on the mower before starting. * Only allow responsible adults, who are familiar with the instructions, to operate the mower. * Clear the area of objects such as rocks, toys, wire, etc., which could be picked up and t
ページ6に含まれる内容の要旨
SAFETY SLOPE OPERATION: Slopes are a major factor related to loss-of-control and tip-over accidents, which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it. DO Mow across the slope with your Dixon ZTR - never up or down. Remove obstacles such as rocks, tree limbs, etc. Watch for holes, ruts or bumps. Uneven terrain could overturn the mower. Tall grass can hide obstac
ページ7に含まれる内容の要旨
SAFETY CHILDREN: Tragic accidents can occur if the operator is not alert to the presence of children. Children are attracted to lawn mowers and the mowing activity. NEVER assume children will stay where they were last seen. Be alert to avoid accidents. * Keep children out of the mowing area and under the watchful care of another responsible adult. * Be alert and turn mower off if a child enters the area. * Before and during backing, look behind and DOWN for small children. *
ページ8に含まれる内容の要旨
SAFETY SERVICE: * Use extra care in handling gasoline and other fuels. They are flammable and vapors are explosive. Use only an approved container. Never remove gas cap or add fuel with the engine running. Allow engine to cool before refueling. Do not smoke. Never refuel the mower indoors. Never store the mower or fuel container inside a building where there is an open flame. * Never run a mower inside a closed area. * Keep nuts and bolts, especially blade attachment b
ページ9に含まれる内容の要旨
DIXON PROTECTION PLUS TWO YEAR LIMITED WARRANTY POLICY This warranty policy applies to all (30"), (36"), (4 2") mowers purchased on or after March 1, 1990 . WARRANTY: The Dixon Protection Plus Warranty term is for a period of two (2) years from date of purchase. DIXON ZTR MOWERS ARE WARRANTED AGAINST DEFECTS IN MATERIALS AND WORKMANSHIP AND PROVIDES FOR REPLACEMENT OR REPAIR OF PARTS INCLUDING LABOR COSTS. THIS WARRANTY IS SUBJECT TO THE FOLLOWING CONDITIONS AND LIMITATIONS: 1. Warrant
ページ10に含まれる内容の要旨
SPECIFICATIONS Models ZTR 4421 & 4422 CHASSIS: Hand welded 11 gauge structural tubing. BODY: All body parts are made of rotational molded, high density polyethylene. Fron t body contains access panel for battery service. Seat lifts forward or backward for a variety of service points in the transmission area. MOWER DECK: 13 GA stamped steel construction. (3) blades combine for a 42" cut width. Cut height approximately 1" to 4" via 8 position lift handle. BLADE DRIVE: Electric clutch.
ページ11に含まれる内容の要旨
SEAT ADJUSTMENT INSTRUCTIONS Models ZTR 4421 & ZTR 4422 1. Place parking brake in ON position. (Pull brake lever up) 2. Raise and push seat assembly and upper body forward. 3. Loosen two front seat adjustment knobs, P/N 3978, and slide seat forward or backward to desired position. 4. Re -tighten front seat adjustment knobs, P/N 3978. DO NOT operate mower without seat adjustments properly tightened. 5. Raise and push seat assembly and upper body
ページ12に含まれる内容の要旨
CONTROLS Page 9
ページ13に含まれる内容の要旨
CONTROLS The Dixon ZTR has a unique transaxle that requires only two drive levers to control braking, turning, speed, and direction. On initial operation, set throttle speed on slow and operate with mower blade "OFF". -To avoid "over-controlling" the mower, use a light touch on the drive levers. Slight movements using fingertip control is all that is necessary. All controls are described from operators position: PARKING BRAKE: The parking brake used on the 4000 Series Models is des
ページ14に含まれる内容の要旨
CONTROLS TOGO FORWARD: From neutral position, gently push both drive levers forward. To increase speed, move levers farther forward. TO GO BACKWARD; From neutral position, gently pull both drive levers toward you. TURNING: Turning is controlled by moving one drive lever slightly forward or rearward of the other. To turn left, move left lever rearward of the right lever. To turn "square corners" move lever of desired direction to neutral. To turn on mower's own axis (zero turnin
ページ15に含まれる内容の要旨
CONTROLS: BLADE DRIVE: Located on control panel, on operator's right. To engage the mower blades, lift switch up lightly and push forward. To disengage blades, pull switch backward. Switch is clearly marked "on and off". MOWER DECK CUT HEIGHT LIFT LEVER: Located to the right and front of operator. Controls the cutting height. Eight positions of adjustment. Move lever in and forward to lower. Move lever in and back to raise. NOTE: Always use high for
ページ16に含まれる内容の要旨
OPERATION INSTRUCTIONS The safe and successful operation of the 4000 Series Models will depend upon the operator having the correct knowledge of all controls used on the mower and making good judgements about the terrain to be mowed. NEVER allow anyone to operate the mower without complete, knowledge of all controls and their functions. Sound judgement by the owner will prevent accidents. BEFORE OPERATING MOWER: 1. Read engine manufacturer's operating and maintenance instructions. 2.
ページ17に含まれる内容の要旨
OPERATION INSTRUCTIONS MOWING WITH A MULCHING ATTACHMENT: Mulching or recycling the grass clippings requires a totally different mowing approach than would be : normal when side discharging or bagging the grass. There may be instances or conditions where it is not possible to hide all of the recycled or mulched clippings. In order to achieve the best results, please read and follow the mulching tips listed below: 1. Set the engine speed control to the wide open or full setting. 2.
ページ18に含まれる内容の要旨
OPERATION INSTRUCTIONS MOWING WITH A GRASS CATCHER ATTACHMENT: In order to achieve optimum performance when mowing with a grass catching attachment, please read and follow the tips listed below. 1. Set engine speed control to the wide open or full setting. 2. Do Not Attempt To Cut Grass When It Is Wet. Wet grass will clog both the underside of the deck and the attachment chutes. Empty bags often to prevent plugging. 3. If the grass is tall, place the mower deck cut heig
ページ19に含まれる内容の要旨
OPERATION INSTRUCTIONS SIDE DISCHARGE OF THE CLIPPINGS: In order to achieve optimum performance when side discharging the grass clippings, please read and follow the tips listed below. Additional information can be found in the troubleshooting guide on Page 28. Be sure that deflector is properly installed on the discharge chute. 1. Set engine speed control to the wide open or full setting. 2. Do Not Attempt To Cut Grass When It Is Wet. Wet grass will clog the undersi
ページ20に含まれる内容の要旨
CARE AND MAINTENANCE - 4000 SERIES MODELS This portion of the 4000 Series Models owners manual deals with normal service items which can be performed by the owner. Please remember that if you are in doubt as to the correct service procedures to be followed, these and other service situations can be handled by a Dixon ZTR dealer who is familiar with the service of your mower. *• - • '
